A real time zero-dimensional diagnostic model for the calculation of in-cylinder temperatures, HRR and nitrogen oxides in diesel engines

Energy Conversion and Management

Volumn 79, Issue , 2014, Pages 498-510

  Finesso, Roberto ^a   Spessa, Ezio ^a  

^a POLITECNICO DI TORINO   (Italy)

Author keywords

Diesel; Multizone; Nitrogen oxides; Real time

Indexed keywords

CONTROL SYSTEMS; DIESEL ENGINES; DIRECT INJECTION; EXHAUST GAS RECIRCULATION; NITROGEN OXIDES; SELECTIVE CATALYTIC REDUCTION; SOFTWARE TESTING; TEMPERATURE;

CYLINDER TEMPERATURES; DIESEL; HEAT RELEASE RATE (HRR); MASS CONSERVATION EQUATIONS; MULTIZONE; REAL TIME; REAL-TIME APPLICATION; STEADY STATE AND TRANSIENTS;

ENGINE CYLINDERS;

EID: 84893065963     PISSN: 01968904     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.enconman.2013.12.045     Document Type: Article

References (40)

1. A.J. Torregrosa, A. Broatch, A. García, and L.F. Mónico Sensitivity of combustion noise and NOx and soot emissions to pilot injection in PCCI Diesel engines Appl Energy 104 2013 149 157 10.1016/j.apenergy.2012.11.040
2. O. Laguitton, C. Crua, T. Cowell, M.R. Heikal, and M.R. Gold The effect of compression ratio on exhaust emissions from a PCCI diesel engine Energy Convers Manage 48 11 2007 2918 2924 10.1016/j.enconman.2007.07.016 (Pubitemid 47498657)
3. A.E. Catania, S. D'Ambrosio, R. Finesso, E. Spessa, G. Cipolla, and A. Vassallo Combustion system optimization of a low compression-ratio PCCI diesel engine for light-duty application SAE Int J Engines 2 1 2009 1314 1326 10.4271/2009-01-1464
4. Kook S, Bae C, Miles PC, Choi D, Pickett LM. The influence of charge dilution and injection timing on low-temperature diesel combustion and emissions. SAE Technical Paper 2005-01-3837; 2005. http://dx.doi.org/10.4271/ 2005-01-3837.
5. Kook S, Bae C, Miles PC, Choi D. The effect of swirl ratio and fuel injection parameters on CO emission and fuel conversion efficiency for high-dilution, low-temperature combustion in an automotive diesel engine. SAE Technical Paper 2006-01-0197; 2006. http://dx.doi.org/10.4271/2006-01-0197.
6. Aceves SM, Flowers DL, Espinosa-Loza F, Babajimopoulos A, Assanis DN. Analysis of premixed charge compression ignition combustion with a sequential fluid mechanics-multizone chemical kinetics model. SAE Technical Paper 2005-01-0115; 2005. http://dx.doi.org/10.4271/2005-01-0115.
7. Catania AE, d'Ambrosio S, Ferrari A, Finesso R, Spessa E, Avolio G, Rampino V. Experimental analysis of combustion processes and emissions in a 2.0L multi-cylinder diesel engine featuring a new generation piezo-driven injector. SAE Technical Paper 2009-24-0040; 2009. http://dx.doi.org/10.4271/2009-24-0040.
8. C. Guido, C. Beatrice, and P. Napolitano Application of bioethanol/RME/diesel blend in a Euro5 automotive diesel engine: potentiality of closed loop combustion control technology Appl Energy 102 2013 13 23 10.1016/j.apenergy.2012.08.051
9. Arregle J, López JJ, Guardiola C, Monin C. Sensitivity study of a NOx estimation model for on-board applications. SAE Technical Paper 2008-01-0640; 2008. http://dx.doi.org/10.4271/2008-01-0640.
10. C. Guardiola, J.J. López, J. Martín, and D. García-Sarmiento Semiempirical in-cylinder pressure based model for NOx prediction oriented to control applications Appl Therm Eng 31 2011 3275 3286 10.1016/j.applthermaleng.2011.05.048
11. S. Saravanan, G. Nagarajan, S. Anand, and S. Sampath Correlation for thermal NOx formation in compression ignition (CI) engine fuelled with diesel and biodiesel Energy 42 1 2012 401 410 10.1016/j.energy.2012.03.028
12. J.B. Heywood Internal combustion engine fundamentals 1988 McGraw-Hill Intern. Editions
13. S:R. Krishnan, and K.K. Srinivasan Multi-zone modelling of partially premixed low-temperature combustion in pilot-ignited natural-gas engines Proc Inst Mech Engrs, Part D: J Autom Eng 224 12 2010 1597 1622 10.1243/ 09544070JAUTO1472
14. Egnell R. Combustion diagnostics by means of multizone heat release analysis and NO calculation. SAE Technical Paper 981424; 1998. http://dx.doi.org/10.4271/981424.
15. Egnell R. A simple approach to studying the relation between fuel rate heat release rate and NO formation in diesel engines. SAE Technical Paper 1999-01-3548; 1999. http://dx.doi.org/10.4271/1999-01-3548.
16. R. Finesso, and E. Spessa Analysis of combustion and emissions in a EURO V diesel engine by means of a refined quasi-dimensional multizone diagnostic model SAE Int J Engines 5 3 2012 886 908 10.4271/2012-01-1066
17. Catania AE, Finesso R, Spessa E. Diagnostics of mixing process dynamics, combustion and emissions in a Euro V diesel engine. SAE Technical Paper 2011-24-0018; 2011. http://dx.doi.org/10.4271/2011-24-0018.
18. A.E. Catania, S. d'Ambrosio, R. Finesso, and E. Spessa Effects of rail pressure, pilot scheduling and EGR rate on combustion and emissions in conventional and PCCI diesel engines SAE Int J Engines 3 1 2010 773 787 10.4271/2010-01-1109
19. M. Baratta, A.E. Catania, A. Ferrari, R. Finesso, and E. Spessa Premixed-diffusive multizone model for combustion diagnostics in conventional and PCCI diesel engines J Eng Gas Turb Power 133 10 2011 102801-1 102801-13 10.1115/1.4003048
20. Ericson C, Westerberg B, Andersson M, Egnell R. Modelling diesel engine combustion and NOx formation for model based control and simulation of engine and exhaust aftertreatment systems. SAE Technical Paper 2006-01-0687; 2006. http://dx.doi.org/10.4271/2006-01-0687.
21. Andersson M, Johansson B, Hultqvist A, Noehre C. A predictive real time NOx model for conventional and partially premixed diesel combustion. SAE Technical Paper 2006-01-3329; 2006. http://dx.doi.org/10.4271/2006-01-3329.
22. Provataris S, Savva N, Hountalas D. Detailed evaluation of a new semi-empirical two-zone NOx model by application on various diesel engine configurations. In: ICES 2012-81101, Proceedings of the ASME 2012 internal combustion engine division spring technical conference, ICES2012, May 6-9, 2012, Torino, Piemonte, Italy; 2012. http://dx.doi.org/10.1115/ICES2012-81101.
23. Finesso R, Spessa E. Real-time predictive modeling of combustion and NOx formation in diesel engines under transient conditions. SAE Technical Paper 2012-01-0899; 2012. http://dx.doi.org/10.4271/2012-01-0899.
24. Catania AE, Finesso R, Spessa E. Assessment of a low-throughput predictive model for indicated cycle, combustion noise and NOx calculation in diesel engines in steady-state and transient operations. In: ICES2012-81094, Proceedings of the ASME 2012 internal combustion engine division spring technical conference, ICES2012, May 6-9, 2012, Torino, Piemonte, Italy; 2012. http://dx.doi.org/10.1115/ICES2012-81094.
25. A.E. Catania, R. Finesso, and E. Spessa Predictive zero-dimensional combustion model for DI diesel engine feed-forward control Energy Convers Manage 52 10 2011 3159 3175 10.1016/j.enconman.2011.05.003
26. A.E. Catania, E. Spessa, R. Finesso, G. Landsmann, and A. Catanese combustion prediction by a low-throughput model in modern diesel engines SAE Int J Engines 4 1 2011 2106 2123 10.4271/2011-01-1410
27. Chmela FG, Orthaber GC. Rate of heat release prediction for direct injection diesel engines based on purely mixing controlled combustion. SAE Technical Paper 1999-01-0186; 1999. http://dx.doi.org/10.4271/1999-01-0186.
28. A.E. Catania, A. Ferrari, and E. Spessa Numerical-experimental study and solutions to reduce the dwell time threshold for fusion-free consecutive injections in a multijet solenoid-type C.R. System J Eng Gas Turb Power 131 1 2009 022804-1 022804-14 10.1115/1.2938394
29. Dec JD. A conceptual model of diesel combustion based on laser-sheet imaging. SAE Technical Paper 970873; 1997. http://dx.doi.org/10.4271/970873.
30. Catania AE, Finesso R, Spessa E. Real-time calculation of EGR rate and intake charge oxygen concentration for misfire detection in diesel engines. SAE Technical Paper 2011-24-0149; 2011. http://dx.doi.org/10.4271/2011-24-0149.
31. S. D'Ambrosio, R. Finesso, and E. Spessa Calculation of mass emissions, oxygen mass fraction and thermal capacity of the inducted charge in SI and diesel engines from exhaust and intake gas analysis Fuel 90 1 2011 152 166 10.1016/j.fuel.2010.08.025
32. Nakayama S, Fukuma T, Matsunaga A, Miyake T, Wakimoto T. A new dynamic combustion control method based on charge oxygen concentration for diesel engines. SAE Technical Paper 2003-01-3181; 2003. http://dx.doi.org/10.4271/2003- 01-3181.
33. Nakayama S, Ibuki T, Hosaki H, Tominaga H. An application of model based combustion control to transient cycle-by-cycle diesel combustion. SAE Technical Paper 2008-01-1311; 2008. http://dx.doi.org/10.4271/2008-01-1311.
34. Woschni G. A universally applicable equation for the instantaneous heat transfer coefficient in the internal combustion engine. SAE Technical Paper 670931; 1967. http://dx.doi.org/10.4271/670931.
35. Katrašnik T, Oprešnik SR, Trenc F, Škifić N. A new criterion to determine the start of combustion in diesel engine. In: ICEF2004-830, Proceedings of ASME ICEF04, fall technical conference of the ASME internal combustion engine division, October 24-27, 2004 Long Beach, California USA; 2004. http://dx.doi.org/10.1115/1.2179471.
36. Finesso R, Spessa E, Misul DA. Estimation of the engine-out NO2/NOx ratio in a EURO VI diesel engine. SAE Technical Paper 2013-01-0317; 2013. http://dx.doi.org/10.4271/2013-01-0317.
37. Miller R, Davis G, Lavoie G, Newman C, Gardner T. A super-extended zel'dovich mechanism for NOx modeling and engine calibration. SAE Technical Paper 980781; 1998. http://dx.doi.org/10.4271/980781.
38. J.A. Miller, and C.T. Bowman Mechanism and modeling of nitrogen chemistry in combustion Prog Energy Combust Sci 1989 15 1989 287 338 10.1016/0360- 1285(89)90017-8 (Pubitemid 20647070)
39. C.P. Fenimore Formation of nitric oxide in premixed hydrocarbon flames Symp (Int) Combust 13 1 1971 373 380 10.1016/s0082-0784(71)80040-1
40. ISO/IEC GUIDE 98-3:2008(E).