Estimating SI engine efficiencies and parameters in second-order sliding modes

IEEE Transactions on Industrial Electronics

Volumn 58, Issue 10, 2011, Pages 4837-4846

  Ahmed, Qadeer ^a   Bhatti, Aamer Iqbal ^a  

^a CAPITAL UNIVERSITY OF SCIENCE AND TECHNOLOGY   (Pakistan)

Author keywords

Combustion efficiency; frictional torque; mean value engine model (MVEM); parameter estimation; sliding mode observers; throttle discharge coefficient; volumetric efficiency

Indexed keywords

COMBUSTION EFFICIENCIES; FRICTIONAL TORQUE; MEAN VALUE ENGINE MODELS; SLIDING-MODE OBSERVER; THROTTLE DISCHARGE COEFFICIENT; VOLUMETRIC EFFICIENCY;

COMBUSTION; EFFICIENCY; ENGINES; ESTIMATION; FRICTION;

PARAMETER ESTIMATION;

EID: 80052348882     PISSN: 02780046     EISSN: None     Source Type: Journal    
DOI: 10.1109/TIE.2010.2102317     Document Type: Article

References (34)

1. National Environmental Quality Standard for Motor Vehicle Exhaust and Noise, S. R. O. 72(KE), 2009.
2. C. C. Daniels and M. J. Braun, "The friction behavior of individual components of a spark-ignition engine during warm-up", Tribol. Trans., vol. 49, no. 2, pp. 166-173, Jul. 2006.
3. A. A. Stotsky, Automotive Engines Control, Estimation, Statistical Detection. New York: Springer-Verlag, 2009.
4. W. W. Pulkrabek, Engineering Fundamentals of the Internal Combustion Engine. Englewood Cliffs, NJ: Prentice-Hall, 2003.
5. D. Sandoval and J. Heywood, "An improved friction model for sparkignition engines", presented at the SAE World Congr. Exhibition, Detroit, MI, 2003, Paper 2003-01-0725.
6. J. Jongeneel, H. Nijmeijer, C. Manzie, and D. Nesic, "Input redundant internal combustion engine with linear quadratic Gaussian control and dynamic control allocation", Eindhoven Univ. Technol., Eindhoven, The Netherlands, 2009.
7. J. Heywood, Internal Combustion Engine Fundamentals. New York: McGraw-Hill, 1988.
8. Q. Butt and A. Bhatti, "Estimation of gasoline-engine parameters using higher order sliding mode", IEEE Trans. Ind. Electron., vol. 55, no. 11, pp. 3891-3898, Nov. 2008.
9. R. W. Weeks and J. J. Moskwa, "Automotive engine modeling for realtime control using matlab/simulink", presented at the SAE Int. Congr. Expo., Detroit, MI, 1995, Paper 950417.
10. Y.-W. Kim, G. Rizzoni, and V. Utkin, "Automotive engine diagnosis and control via nonlinear estimation", IEEE Control Syst. Mag., vol. 18, no. 5, pp. 84-99, Oct. 1998.
11. M. Müller, "Volumetric efficiency and pumping torque estimation and compressor recirculation control of turbocharged engines", presented at the SAE World Congr. Exhibition, Detroit, MI, 2009, Paper 2009-01-0587.
12. G. D. Nicolao, R. Scattolini, and C. Siviero, "Modelling the volumetric efficiency of IC engines: Parametric, non-parametric and neural techniques", Control Eng. Pract., vol. 4, no. 10, pp. 1405-1415, Oct. 1996.
13. J. J. Moskwa and J. K. Hedrick, "Automotive engine modeling for real time control application", in Proc. Amer. Control Conf., 1987, pp. 341-346.
14. L. Guzzella and C. Onder, Introduction to Modeling and Control of Internal Combustion Engine Systems. New York: Springer-Verlag, 2004.
15. I. H. Kazmi and I. A. Tirmizi, "Modeling and simulation of internal combustion engines for design of model-based control methods", M. S. thesis, Ghulam Ishaq Khan Inst. Eng. Sci. Technol., Topi, Pakistan, 2007.
16. P. Anderson, "Air charge estimation in turbocharged spark ignition engines", Ph. D. dissertation, Linkoping Univ., Linkoping, Sweden, 2005.
17. E. Hendricks and J. B. Luther, "Model and observer based control of internal combustion engines", in Proc. Model., Emission Control Automot. Engine, Sep. 2001, pp. 9-20.
18. E. Hendricks and S. C. Sorenson, "Mean value modeling of spark ignition engines", presented at the SAE Int. Congr. Expo., Detroit, MI, 1990, Paper 900616.
19. E. Hendricks, A. Chevalier, M. Jensen, and S. C. Sorenson, "Modeling of the intake manifold modeling dynamics", presented at the SAE Int. Congr. Expo., Detroit, MI, 1996, Paper 960037.
20. M. Reichhartinger and M. Horn, "Application of higher order slidingmode concepts to a throttle actuator for gasoline engines", IEEE Trans. Ind. Electron., vol. 56, no. 9, pp. 3322-3329, Sep. 2009.
21. B. Alt, J. Blath, F. Svaricek, and M. Schultalbers, "Multiple sliding surface control of idle engine speed and torque reserve with dead start assist control", IEEE Trans. Ind. Electron., vol. 56, no. 9, pp. 3580-3592, Sep. 2009.
22. M. Canale, L. Fagiano, A. Ferrara, and C. Vecchio, "Vehicle yaw control via second-order sliding-mode technique", IEEE Trans. Ind. Electron., vol. 55, no. 11, pp. 3908-3916, Nov. 2008.
23. S. Sayeef, G. Foo, and M. Rahman, "Rotor position and speed estimation of a variable structure direct-torque-controlled IPM synchronous motor drive at very low speeds including standstill", IEEE Trans. Ind. Electron., vol. 57, no. 11, pp. 3715-3723, Nov. 2010.
24. J. Davila, L. Fridman, and A. Levant, "Second-order sliding-mode observer for mechanical systems", IEEE Trans. Autom. Control, vol. 50, no. 11, pp. 1785-1789, Nov. 2005.
25. N. M'sirdi, A. Rabhi, L. Fridman, J. Davila, and Y. Delanne, "Second order sliding mode observer for estimation of velocities, wheel sleep, radius and stiffness", in Proc. Amer. Control Conf., 2006, pp. 3316-3321.
26. Q. Ahmed and A. I. Bhatti, "Second order sliding mode observer for estimation of si engine volumetric efficiency & throttle discharge coefficient", in Proc. Int. Workshop VSS, Mexico City, Mexico, Jun. 2010, pp. 307-312.
27. Z. Xu and M. Rahman, "An adaptive sliding stator flux observer for a direct torque controlled IPM motor drive", in Proc. IEEE Int. Conf. Elect. Mach. Drives, 2005, pp. 704-709.
28. A. Levant, "Higher-order sliding modes, differentiation and outputfeedback control", Int. J. Control, vol. 76, no. 9/10, pp. 924-941, 2003.
29. D. Caveney, "Cooperative vehicular safety applications", IEEE Control Syst. Mag., vol. 30, no. 4, pp. 38-53, Aug. 2010.
30. R. Van der Merwe and E. Wan, "The square-root unscented Kalman filter for state and parameter-estimation", in Proc. ICASSP, 2001, vol. 6, pp. 3461-3464.
31. M. Saif, W. Chen, and Q. Wu, High Order Sliding Mode Observers and Differentiators-Application to Fault Diagnosis Problem, Modern Sliding Mode Control Theory. Berlin, Germany: Springer-Verlag, 2008.
32. X. Wang, K. Kim, C. Lee, and J. Kim, "Prediction of air filter efficiency and pressure drop in air filtration media using a stochastic simulation", Fibers Polym., vol. 9, no. 1, pp. 34-38, Feb. 2008.
33. I. Muhammad, A. Bhatti, S. Ayubi, and Q. Khan, "Robust parameter estimation of nonlinear systems using sliding mode differentiator observer", IEEE Trans. Ind. Electron., vol. 58, no. 2, pp. 680-689, Feb. 2011.
34. K. Madsen, H. Nielsen, and O. Tingleff, Methods for Non-Linear Least Squares Problems. Kongens Lyngby, Denmark: Informat. Math. Model., Tech. Univ. Denmark, 2004.