Sensorless Control of PMSM for the Whole Speed Range Using Two-Degree-of-Freedom Current Control and HF Test Current Injection for Low-Speed Range

IEEE Transactions on Power Electronics

Volumn 30, Issue 8, 2015, Pages 4394-4403

  Seilmeier, Markus ^a   Piepenbreier, Bernhard ^a  

^a UNIVERSITY OF ERLANGEN NUREMBERG   (Germany)

Author keywords

Permanent magnet motors; saliency; sensorless control; test current injection

Indexed keywords

CONTROLLERS; DEGREES OF FREEDOM (MECHANICS); DISTURBANCE REJECTION; ELECTRIC CURRENT CONTROL; ELECTRIC MACHINE THEORY; ELECTRIC MOTORS; FEEDFORWARD CONTROL; PERMANENT MAGNETS; QUALITY CONTROL; SPEED;

CURRENT CONTROL SCHEMES; CURRENT INJECTIONS; DYNAMIC FEEDFORWARD CONTROLS; MODEL-BASED ESTIMATOR; PERMANENT MAGNET MOTOR; POSITION ERROR SIGNALS; SALIENCY; TWO-DEGREE OF FREEDOM;

SENSORLESS CONTROL;

EID: 84924898392     PISSN: 08858993     EISSN: None     Source Type: Journal    
DOI: 10.1109/TPEL.2014.2353215     Document Type: Article

References (33)

1. D. Zaltni, M. N. Abdelkrim, M. Ghanes, and J. P. Barbot, "Observability analysis of PMSM," in Proc. Int. Conf. Signals, Circuits Syst., 2009, pp. 1-6.
2. L. A. S. Ribeiro, M. W. Degner, F. Briz, and R. D. Lorenz, "Comparison of carrier signal voltage and current injection for the estimation of flux angle and rotor position," in Proc. IEEE Ind. Appl. Conf., 1998, pp. 452-459.
3. R. Bojoi, M. Pastorelli, J. Bottomley, and P. Giangrande, "Sensorless control of PM motor drives - A technology status review," in Proc. IEEE Workshop Electr. Mach. Des. Control Diagn., 2013, pp. 168-182.
4. M. Linke, R. Kennel, and J. Holtz, "Sensorless speed and position control of synchronous machines using alternating carrier injection," in Proc. Int. Electr. Mach. Drives Conf., 2003, pp. 1211-1217.
5. J. Holtz, "Acquisition of position error and magnet polarity for sensorless control of PM synchronous machines," IEEE Trans. Ind. Appl., vol. 44, no. 4, pp. 1172-1180, Jul./Aug. 2008.
6. P. L. Jansen and R. D. Lorenz, "Transducerless position and velocity estimation in induction and salient AC machines," IEEE Trans. Ind. Appl., vol. 31, no. 2, pp. 240-247, Mar./Apr. 1995.
7. S.Kim and S.-K. Sul, "High performance position sensorless control using rotating voltage signal injection in IPMSM," in Proc. Eur. Conf. Power Electron. Appl., 2011, pp. 1-10.
8. S. C. Yang and R. D. Lorenz, "Comparison of resistance-based and inductance-based self-sensing control for surface permanent magnet machine using high frequency signal injection," in Proc. IEEE Energy Convers. Congr. Expo., 2011, pp. 2701-2708.
9. T. Frenzke, "Impacts of cross-saturation on sensorless control of surface permanent magnet synchronous motors," in Proc. Eur. Conf. Power Electron. Appl., 2005, pp. P.1-P.10.
10. D. Reigosa, P. Garcia, D. Raca, F. Briz, and R. D. Lorenz, "Measurement and adaptive decoupling of cross-saturation effects and secondary saliencies in sensorless-controlled IPM synchronous machines," IEEE Trans. Ind. Appl., vol. 44, no. 6, Nov./Dec. pp. 1758-1767, 2008.
11. A. Piippo and J. Luomi, "Inductance Harmonics in permanent magnet synchronous motors and reduction of their effects in sensorless control,"in Proc. Int. Conf. Electric Mach., 2006, pp. 1-6.
12. J. Solsona, M. I. Valla, and C. Muravchik, "Nonlinear control of a permanent magnet synchronous motor with disturbance torque estimation,"IEEE Trans. Energy Convers., vol. 15, no. 2, pp. 163-168, Jun. 2000.
13. S. Beineke, J. Schirmer, J. Lutz, H. Wertz, A. Bahr, and J. Kiel, "Implementation and applications of sensorless control for synchronous machines in industrial inverters," in Proc. Symp. Sensorless Control Electr. Drives, 2010, pp. 64-71.
14. I. Boldea and S. C. Agarlita, "The active flux concept for motion-sensorless unified AC drives: A review," in Proc. Int. Aegean Conf. Electr. Mach. Power Electron., 2011, pp. 1-16.
15. S. Morimoto, K. Kawamoto, M. Sanada, and Y. Takeda, "Sensorless control strategy for salient-pole PMSM based on extended EMF in rotating reference frame," IEEE Trans. Ind. Appl., vol. 38, no. 4, pp. 1054-1061, Jul./Aug. 2002.
16. O. Benjak and D. Gerling, "Review of position estimation methods for IPMSM drives without a position sensor part I: Nonadaptive methods and part II adaptive methods," in Proc. Int. Conf. Electr. Mach., 2010, pp. 1-6.
17. M. Seilmeier, S. Arenz, B. Piepenbreier, and I. Hahn, "Model based closed loop control scheme for compensation of harmonic currents in PM-synchronous machines," in Proc. Int. Symp. Power Electron. Electr. Drives Autom. Motion, 2010, pp. 1-6.
18. S. Ebersberger, M. Seilmeier, and B. Piepenbreier, "Flatness based sensorless control of PMSM using test current signal injection and compensation for differential cross-coupling inductances at standstill and low speed range," in Proc. Symp. Sensorless Control Electr. Drives, 2013, pp. 1-7.
19. M. Seilmeier, S. Ebersberger, and B. Piepenbreier, "PMSM model for sensorless control considering saturation induced secondary saliencies,"in Proc. Symp. Sensorless Control Electr. Drives, 2013, pp. 1-8.
20. J. Melkebeek and J. Willems, "Reciprocity relations for the mutual inductances between orthogonal axis windings in saturated salient-pole machines,"IEEE Trans. Ind. Appl., vol. 26, no. 1, pp. 107-114, Jan./Feb. 1990.
21. S.-C. Yang and R. D. Lorenz, "Surface permanent magnet synchronous machine self-sensing position estimation at low speed using eddy current reflected asymmetric resistance," in Proc. Eur. Conf. Power Electron. Appl., 2011, pp. 1-10.
22. M. Seilmeier, S. Ebersberger, and B. Piepenbreier, "Identification of high frequency resistances and inductances for sensorless control of PMSM,"in Proc. Symp. Sensorless Control Electr. Drives, 2013, pp. 1-8.
23. L. Alberti, N. Bianchi, M. Morandin, and J. Gyselinck, "Finite-element analysis of electrical machines for sensorless drives with signal injection,"in Proc. Energy Convers. Congr. Expo., 2012, pp. 861-868.
24. J. Slotine, Applied Nonlinear Control. Upper Saddle River, NJ, USA: Prentice-Hall, 1991.
25. A. Isidori, Nonlinear Control Systems. London, U.K.: Springer-Verlag, 1995.
26. M. Fliess, J. Levine, P. Martin, and P. Rouchon, "Flatness and defect of non-linear systems: Introductory theory and examples," Int. J. Control, vol. 61, pp. 1327-1361, 1995.
27. M. Seilmeier, A. Boehm, I. Hahn, and B. Piepenbreier, "Identification of time-variant high frequency parameters for sensorless control of PMSM using an internal model principle based high frequency current control,"in Proc. Int. Conf. Electr. Mach., 2012, pp. 987-993.
28. M. Seilmeier, S. Ebersberger, and B. Piepenbreier, "HF test current injection based self-sensing control of PMSM for low and zero speed range using two-degree-of-freedom current control," in Proc. Symp. Sensorless Control Electr. Drives, 2014, pp. 1-8.
29. N. Limsuwan, T. Kato, C.-Y. Yu, J. Tamura, D. Reigosa, K. Akatsu, and R. D. Lorenz, "Secondary resistive losses with high-frequency injectionbased self-sensing in IPM machines," in Proc. IEEE Energy Convers. Congr. Expo., 2011, pp. 622-629.
30. M. Seilmeier and B. Piepenbreier, "Initial start-up and magnet polarity estimation method for HF test current injection based sensorless control of PMSM," in Proc. Int. Power Electron. Motion Control Conf. Expo., 2014.
31. J. Hong, S. Jung, and K. Nam, "An incorporation method of sensorless algorithms: Signal injection and back EMF based methods," in Proc. Int. Power Electron. Conf., 2010, pp. 2743-2747.
32. M. Seilmeier and B. Piepenbreier, "Identification of steady-state inductances of PMSM using polynomial representations of the flux surfaces,"in Proc. Ind. Electron. Conf., Vienna, Austria, 2013, pp. 2899-2904.
33. st Int. Electr. Drives Prod. Conf., 2011, pp. 17-22.