Experimental analysis of flow and heat transfer in a miniature porous heat sink for high heat flux application

International Journal of Heat and Mass Transfer

Volumn 55, Issue 15-16, 2012, Pages 4437-4441

  Wan, Z M ^a   Guo, G Q ^a   Su, K L ^a   Tu, Z K ^b   Liu, W ^b  

^a HUNAN INSTITUTE OF SCIENCE AND TECHNOLOGY   (China)

^b HUAZHONG UNIVERSITY OF SCIENCE AND TECHNOLOGY   (China)

Author keywords

Experimental investigation; Heat sink; Heat transfer; High heat flux; Porous media

Indexed keywords

COOLANT FLOW RATES; COOLANT PRESSURE; ELECTRONIC DEVICE; ELECTRONICS COOLING; EXPERIMENTAL ANALYSIS; EXPERIMENTAL INVESTIGATIONS; FLOW AND HEAT TRANSFER; HIGH HEAT FLUX; JUNCTION TEMPERATURES; MAXIMUM VALUES; MICRO HEAT SINK; MINIMUM VALUE; NU NUMBER; OPERATIONAL PRINCIPLES; OVERALL HEAT TRANSFER COEFFICIENT; RE NUMBERS;

COOLANTS; ELECTRONIC COOLING; FLOW RATE; HEAT FLUX; HEAT TRANSFER; HEAT TRANSFER COEFFICIENTS; POROUS MATERIALS; THERMAL LOAD; THERMOELECTRIC EQUIPMENT; THERMONUCLEAR REACTIONS;

HEAT SINKS;

EID: 84861528701     PISSN: 00179310     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.ijheatmasstransfer.2012.04.013     Document Type: Article

References (23)

1. M.W. Sydney, B. Sudipta, and V.G. Suresh Piezoelectric fans using higher flexural modes for electronics cooling applications IEEE Trans. Compon. Packag. Technol. 30 1 2007 119 128
2. E.S. Cho, J.W. Choi, and J.S. Yoon Experimental study on micro channel heat sinks considering mass flow distribution with non-uniform heat flux conditions Int. J. Heat Mass Transfer 53 9-10 2010 2159 2168
3. A. Sivasamy, V. Selladurai, and P. Rajesh Kanna Mixed convection on jet impingement cooling of a constant heat flux horizontal porous layer Int. J. Therm. Sci. 49 7 2010 1238 1246
4. Y. Sui, C.J. Teo, P.S. Lee, and Y.T. Chew Fluid flow and heat transfer in wavy micro channels Int. J. Heat Mass Transfer 53 13-14 2010 2760 2772
5. W. Li, and Z. Wu A general correlation for evaporative heat transfer in micro/mini-channels Int. J. Heat Mass Transfer 53 9-10 2010 1778 1787
6. A. Sivasamy, V. Selladurai, and P.R. Kann Mixed convection on jet impingement cooling of a constant heat flux horizontal porous layer Int. J. Therm. Sci. 49 7 2010 1238 1246
7. M.K. Sung, and I. Mudawar CHF determination for high-heat flux phase change cooling system incorporating both micro-channel flow and jet impingement Int. J. Heat Mass Transfer 52 1 2009 610 619
8. A.W. Mauro, J.R. Thome, D. Toto, and G.P. Vanoli Saturated critical heat flux in a multi-microchannel heat sink fed by a split flow system Exp. Therm. Fluid Sci. 34 1 2010 81 92
9. S.C. Fok, W. Shen, and F.L. Tan Cooling of portable hand-held electronic devices using phase change materials in finned heat sinks Int. J. Therm. Sci. 49 1 2010 109 117
10. B. Pulvirenti, A. Matalone, and U. Barucca Boiling heat transfer in narrow channels with offset strip fins: Application to electronic chipsets cooling Appl. Therm. Eng. 30 14-15 2010 2138 2145
11. H.S. Huang, Y.C. Weng, and Y.W. Chang Thermoelectric water-cooling device applied to electronic equipment Int. Commun. Heat Mass Transfer 37 2 2010 140 146
12. Z.B. Yan, K.C. Toh, and F. Duan Experimental study of impingement spray cooling for high power devices Appl. Therm. Eng. 30 10 2010 1225 1230
13. J. Darabi, and K. Ekula Development of a chip-integrated micro cooling device Microelectron. J. 34 2003 1067 1074
14. V. Lenoid, L. David, and R. Cyril Loop heat pipe for cooling of high-power electronic components Int. J. Heat Mass Transfer 52 2 2009 301 308
15. A.C. Mark, R.Y. Christopher, and C.N. Kim Modeling and testing of an advanced compact two-phase cooler for electronics cooling Int. J. Heat Mass Transfer 52 10 2009 3456 3463
16. K.C. Wong, and N.H. Saeid Numerical study of mixed convection on jet impingement cooling in a horizontal porous layer-using Brinkman-extended Darcy model Int. J. Therm. Sci. 48 2 2009 96 104
17. K.S. Myung, and M. Issam Single-phase hybrid micro-channel/micro-jet impingement cooling Int. J. Heat Mass Transfer 51 2 2008 4342 4352
18. X.B. Luo, and S. Liu A microjet array cooling system for thermal management of high-brightness LEDs IEEE Trans. Adv. Packag. 30 3 2007 475 484
19. L. Tadrist, M. Miscevic, and O. Rahli About the use of fibrous materials in compact heat exchangers Exp. Therm. Fluid Sci. 28 2 2004 193 199
20. D. Bogojevica, K. Sefiane, and A.J. Walton Two-phase flow instabilities in a silicon micro channels heat sink Int. J. Heat Fluid Flow 30 2009 854 867
21. P.X. Jiang, M. Li, and Y.C. Ma Boundary conditions and wall effect for forced convection heat transfer in sintered porous plate channels Int. J. Heat Mass Transfer 47 10-11 2004 2073 2083
22. P.X. Jiang, L. Meng, and T.J. Lu Experimental Research on convection heat transfer in sintered porous plate channels Int. J. Heat Mass Transfer 47 10-11 2004 2085 2096
23. N. Sahiti, F. Durst, and P. Geremia Selection and optimization of pin cross-sections for electronics cooling Appl. Therm. Eng. 27 1 2007 111 119