Experimental assessment of instantaneous heat transfer in the combustion chamber and exhaust manifold walls of air-cooled direct injection diesel engine

SAE International Journal of Engines

Volumn 1, Issue 1, 2009, Pages 888-912

  Mavropoulos, G C ^a   Rakopoulos, C D ^a   Hountalas, D T ^a  

^a NATIONAL TECHNICAL UNIVERSITY OF ATHENS   (Greece)

Author keywords

[No Author keywords available]

Indexed keywords

A-THERMAL; BLOW DOWN; CONTROL CODES; CYLINDER HEAD; CYLINDER PRESSURES; DATA ACQUISITION SYSTEM; DIRECT INJECTION; DIRECT INJECTION DIESEL ENGINES; ENGINE EXHAUST; ENGINE SPEED; EXHAUST MANIFOLD; EXPERIMENTAL ANALYSIS; EXPERIMENTAL ASSESSMENT; EXPERIMENTAL INSTALLATIONS; FAST DATA ACQUISITION; FAST RESPONSE; GAS TEMPERATURE; HEAT FLUX SENSORS; HEAT TRANSFER CHARACTERISTICS; ITERATIVE PROCEDURES; LOCAL HEAT TRANSFER; NONUNIFORM; OBJECT ORIENTED; ONE-DIMENSIONAL HEAT; OVERALL HEAT TRANSFER COEFFICIENT; SEMIEMPIRICAL EQUATION; SPATIAL UNIFORMITY; STANDARD CORRELATION; SWIRLING MOTION; TEMPERATURE DATA; TRANSIENT TEMPERATURE; VALVE MOTION; WALL TEMPERATURES; ZONE MODEL;

AIR ENGINES; AMPLIFICATION; AUTOMOBILE ENGINE MANIFOLDS; COMBUSTION; COMBUSTION CHAMBERS; COOLING SYSTEMS; DIESEL ENGINES; EQUATIONS OF MOTION; EXHAUST GASES; EXHAUST SYSTEMS (ENGINE); FABRICS; FOURIER ANALYSIS; GAS FUEL ANALYSIS; HEAT CONDUCTION; HEAT EXCHANGERS; HEAT TRANSFER COEFFICIENTS; THERMOCOUPLES;

ENGINE CYLINDERS;

EID: 70350438284     PISSN: 19463936     EISSN: 19463944     Source Type: Journal    
DOI: 10.4271/2008-01-1326     Document Type: Article

References (49)

1. Benson R.S. and Whitehouse N.D., Internal Combustion Engines, Pergamon, Oxford, 1979.
2. Heywood J.B., Internal Combustion Engine Fundamentals, McGraw-Hill, New York, 1988.
3. Ferguson C.R., Internal Combustion Engines, John Wiley, New York, 1986.
4. Annand W.J.D., "Heat transfer in the cylinders of reciprocating internal combustion engines", Proceedings of the Institution of Mechanical Engineers, Vol. 177, pp. 973-990, 1963.
5. French C.C.J., "Piston cooling", SAE Paper No. 720024, 1972.
6. Seale W.J. and Taylor D.H.C., "Spatial variation of heat transfer to pistons and liners of some medium speed diesel engines", Proceedings of the Institution of Mechanical Engineers, Vol. 185, pp. 203-218, 1970-71.
7. Whitehouse N.D., "Heat transfer in a quiescent chamber diesel engine", Proceedings of the Institution of Mechanical Engineers, Vol. 185, pp. 963-975, 1970-71.
8. Rakopoulos C.D. and Hountalas D.T., "Development and validation of a 3-D multi-zone combustion model for the prediction of DI diesel engines performance and pollutants emissions", Transactions of SAE, Journal of Engines, Vol. 107, pp. 1413-1429, 1998 [SAE Paper No. 981021].
9. Kouremenos D.A., Rakopoulos C.D. and Hountalas D.T., "Thermodynamic analysis of indirect injection diesel engines by two-zone modelling of combustion", Transactions of ASME, Journal of Engineering for Gas Turbines and Power, Vol. 112, pp. 138-149, 1990.
10. Kouremenos D.A., Rakopoulos C.D. and Hountalas D.T., "Multi-zone combustion modeling for the prediction of pollutants emissions and performance of DI diesel engines", Transactions of SAE, Journal of Engines, Vol. 106, pp. 940-957, 1997 [SAE Paper No. 970635].
11. Keribar R. and Morel T., "Thermal shock calculations in I.C. engines", SAE Paper No. 870162, 1987.
12. Morel T., Wahiduzzaman S. and Fort E.F., "Heat transfer experiments in an insulated diesel", SAE Paper No. 880186, 1988.
13. Enomoto Y. and Furuhama S., "A study of the local heat transfer coefficient on the combustion chamber walls of a four-stroke gasoline engine", Bulletin JSME, Vol. 32, pp. 107-114, 1989.
14. Alkidas A.C. and Myers J.P., "Transient heat-flux measurements in the combustion chamber of a spark-ignition engine", Transactions of ASME, Journal of Heat Transfer, Vol. 104, pp.62-67, 1982.
15. Alkidas A.C. and Cole R.M., "Transient heat-flux measurements in a divided-chamber diesel engine", Transactions of ASME, Journal of Heat Transfer, Vol. 107, pp. 439-444, 1985.
16. Borman G. and Nishiwaki K., "Internal-combustion engine heat transfer", Progress in Energy and Combustion Science, Vol. 13, pp. 1-46, 1987.
17. Perez-Blanco H., "Experimental characterization of mass, work and heat flows in an air cooled, single cylinder engine", Energy Conversion & Management, Vol. 45, pp. 157-169, 2004.
18. Tillock B.R. and Martin J.K., "Measurement and modeling of thermal flows in an air-cooled engine", Transactions of SAE, Journal of Engines, Vol. 105, pp. 1781-1789, 1996 [SAE Paper No. 961731].
19. Zhaoda Y., Zheng F., Xiaoli Y., Zhixing Y. and Hongouan S., "Calculation and prediction of thermal loading of the air-cooled diesel engine", SAE Paper No. 881254, 1988.
20. Rakopoulos C.D., Scott M.A., Kyritsis D.C. and Giakoumis E.G., "Availability analysis of hydrogen/natural gas blends combustion in internal combustion engines", Energy, Vol. 33, 2008 (in press).
21. Rakopoulos C.D., Antonopoulos K.A. and Rakopoulos D.C., "Experimental heat release analysis and emissions of a HSDI diesel engine fueled with ethanol-diesel fuel blends", Energy, Vol. 32, pp. 1791-1808, 2007.
22. Rakopoulos C.D., Antonopoulos K.A. and Rakopoulos D.C., "Development and application of a multi-zone model for combustion and pollutants formation in direct injection Diesel engine running with vegetable oil or its bio-diesel", Energy Conversion & Management, Vol. 48, pp. 1881-1901, 2007.
23. Kamo R. and Bryzik W., "Cummins/TACOM advanced adiabatic engine", SAE Paper No. 840428, 1984.
24. Assanis D.N., "Effect of combustion chamber insulation on the performance of a low heat rejection diesel engine with exhaust heat recovery", Heat Recovery Systems & CHP, Vol. 9, pp. 475-484, 1989.
25. Rakopoulos C.D., Antonopoulos K.A., Rakopoulos D.C. and Giakoumis E.G., "Investigation of the temperature oscillations in the cylinder walls of a diesel engine with special reference to the limited cooled case", Int. J. of Energy Research, Vol. 28, pp. 977-1002, 2004.
26. Lazaro J.L., Garcia-Bernad J.L., Perez C., Galindo J., Climent H. and Arnau F.J., "Cooled EGR modulation: a strategy to meet EURO IV emission standards in automotive DI diesel engines", SAE Paper No. 2002-01-1154, 2002.
27. Kanda T., "Study on Euro IV combustion technologies for direct injection diesel engine", SAE Paper No. 2004-01-0113, 2004.
28. Mure C.R. and Rhee K.T., "Instantaneous heat transfer over the piston of a motored direct injection- type diesel engine", SAE Paper No. 890469, 1989.
29. Farrugia M., Alkidas A.C. and Sangeorzan B.P., "Cycle-averaged heat flux measurements in a straight-pipe extension of the exhaust port of a SI engine", SAE Paper No. 2006-01-1033, 2006.
30. Sammut G. and Alkidas A.C., "Relative contributions of intake and exhaust tuning on SI engine breathing - A computational study", SAE Paper No. 2007-01-0492, 2007.
31. Heller S. and Wachtmeister G., "Analysis and modeling of heat transfer in the SI engine exhaust system during warm-up", SAE Paper No. 2007-01-1092, 2007.
32. Rakopoulos C.D. and Mavropoulos G.C., "Study of the steady and transient temperature field and heat flow in the combustion chamber components of a medium speed diesel engine using finite element analyses", Int. J. of Energy Research, Vol. 20, pp. 437-464, 1996.
33. Rakopoulos C.D., Hountalas D.T., Mavropoulos G.C. and Giakoumis E.G., "An integrated transient analysis simulation model applied in thermal loading calculations of an air-cooled diesel engine under variable speed and load conditions", Transactions of SAE, Journal of Engines, Vol. 106, pp. 923-939, 1997 [SAE Paper No. 970634].
34. Rakopoulos C.D., Mavropoulos G.C. and Hountalas D.T., "Modeling the structural thermal response of an air-cooled diesel engine under transient operation including a detailed thermodynamic description of boundary conditions", SAE Paper No. 981024, 1998.
35. Rakopoulos C.D. and Mavropoulos G.C., "Components heat transfer studies in a low heat rejection DI diesel engine using a hybrid thermostructural finite element model", Applied Thermal Engineering, Vol. 18, pp. 301-316, 1998.
36. Rakopoulos C.D. and Mavropoulos G.C., "Experimental instantaneous heat fluxes in the cylinder head and exhaust manifold of an air-cooled Diesel engine", Energy Conversion & Management, Vol. 41, pp. 1265-1281, 2000.
37. Rakopoulos C.D., Mavropoulos G.C. and Hountalas D.T., "Measurements and analysis of load and speed effects on the instantaneous wall heat fluxes in a direct injection air-cooled diesel engine", Int. J. of Energy Research, Vol. 24, pp. 587-604, 2000.
38. Rakopoulos C.D., Rakopoulos D.C., Mavropoulos G.C. and Giakoumis E.G., "Experimental and theoretical study of the short term response temperature transients in the cylinder walls of a Diesel engine at various operating conditions", Applied Thermal Engineering, Vol. 24, pp. 679-702, 2004.
39. Amsden A.A., Butler T.D., O'Rourke P.J. and Ramshaw J.D., "KIVA-a comprehensive model for 2- D and 3-D engine simulations", SAE Paper No. 850554, 1985.
40. Morel T. and Keribar R., "A model for predicting spatially and time resolved convective heat transfer in bowl-in-piston combustion chambers", SAE Paper No. 850204, 1985.
41. Yoo S. and Kim E., "A study of in-cylinder local heat transfer characteristics of a spark ignition engine", SAE Paper No. 931981, 1993.
42. Welty J.R., Engineering Heat Transfer, John Wiley, New York, 1974.
43. Alkidas A.C., Battiston P.A., and Kapparos D.J., "Thermal studies in the exhaust system of a diesel- powered light-duty vehicle", SAE Paper No. 2004-01-0050, 2004.
44. Ranganathan R.P., Turner D.W. and Franchett M.E., "Exhaust manifold gas temperature predictions using system level data driven modeling", SAE Paper No. 2005-01-0698, 2005.
45. NANMAC, "Temperature Measurement Handbook", Vol. VIII, Framingham MA, 1997.
46. Farrugia M., Alkidas A.C. and Sangeorzan P., "Transient surface-heat-flux measurements in the exhaust of a SI engine", Int. J. of Vehicle Design, Vol. 45, No. 1/2, pp. 1-11, 2007.
47. Wimmer A., Pivec R. and Sams T., "Heat transfer to the combustion chamber and port walls of IC engines-measurement and prediction", SAE Paper No. 2000-01-0568, 2000.
48. He Y., Battiston P.A. and Alkidas A.C., "Thermal studies in the exhaust manifold of a turbocharged V6 diesel engine operating under steady-state conditions", SAE Paper No. 2006-01-0688, 2006.
49. Kar K., Roberts S., Stone R., Oldfield M. and French B., "Instantaneous exhaust temperature measurements using thermocouple compensation techniques", SAE Paper No. 2004-01-1418, 2004.