A diffusion model for a drum dryer subjected to conduction, convection, and radiant heat input

Drying Technology

Volumn 25, Issue 6, 2007, Pages 1033-1043

  Islam, Md Raisul ^a   Thaker, Keyur S ^b   Mujumdar, A S ^c  

^a CURTIN UNIVERSITY   (Malaysia)

^b API Division   (India)

^c NATIONAL UNIVERSITY OF SINGAPORE   (Singapore)

Author keywords

Biological sludge; Convection; Diffusivity; Mass flux; Moisture content; Pilot scale; Radiation; Thermal conductivity

Indexed keywords

DIFFUSION; DRYERS (EQUIPMENT); HEAT CONDUCTION; HEAT CONVECTION; HEAT RADIATION; MASS TRANSFER; MATHEMATICAL MODELS; MOISTURE; THERMAL CONDUCTIVITY;

AIR FLOW VELOCITY; DRUM DRYER;

DRYING;

DIFFUSION; DRYERS (EQUIPMENT); DRYING; HEAT CONDUCTION; HEAT CONVECTION; HEAT RADIATION; MASS TRANSFER; MATHEMATICAL MODELS; MOISTURE; THERMAL CONDUCTIVITY;

EID: 34250656560     PISSN: 07373937     EISSN: 15322300     Source Type: Journal    
DOI: 10.1080/07373930701397467     Document Type: Article

References (31)

1. Daud, W.R.B.W. and Armstrong, W.D. (1987) Drying '87, Hemisphere, New York
2. Gavrielidou, M.A., Vallous, N.A., Karapantsios, T.D. and Raphaelides, S.N. (2002) Heat transport to a starch slurry gelatinising between the drums of a double drum dryer. Journal of Food Engineering, 54, pp. 45-58.
3. Pua, C.K., Hamid, N.S.A., Rusul, G. and Rahman, R.A. (2007) Production of drum-dried jackfruit (Artocarpus heterophyllus) powder with different concentration of soy lecithin and gum arabic. Journal of Food Engineering, 78:2, pp. 630-636.
4. Supprung, P. and Noomhorm, A. (2003) Optimization of drum drying parameters for low amylose rice (KDML105) starch and flour. Drying Technology, 21:9, pp. 1781-1795.
5. Rodriguez, G., Vasseur, J. and Courtois, F. (1996) Design and control of drum dryers for the food industry. Part 1. Set-up of a moisture sensor and an inductive heater. Journal of Food Engineering, 28:3, pp. 271-282.
6. Karapantsios, T.D. (2006) Conductive drying kinetics of pre-gelatinized starch thin films. Journal of Food Engineering, 76:4, pp. 477-489.
7. Daud, W.R.B.W. and Armstrong, W.D. (1988) Conductive drying characteristics of gelatinized rice starch. Drying Technology, 6:4, pp. 655-674.
8. Anastasiades, A., Thanou, S., Loulis, D., Stapatoris, A. and Karapantsios, T.D. (2002) Rheological and physical characterization of pregelatinized maize starches. Journal of Food Engineering, 52, pp. 57-66.
9. Gavrielidou, M.A., Vallous, N.A., Karapantsios, T.D. and Raphaelides, S.N. (2002) Heat transport to a starch slurry gelatinizing between the drums of a double drum dryer. Journal of Food Engineering, 54:1, pp. 45-58.
10. Kalogianni, E., Xinogalos, V., Karapantsios, T.D. and Kostoglou, M. (2002) Effect of feed concentration on the production of pregelatinized starch in a double drum dryer. Lebensmittel-Wissenschaft & Technologie, 35:8, pp. 703-714.
11. Vallous, N.A., Gavrielidou, M.A., Karapantsios, T.D. and Kostoglou, M. (2002) Performance of a double drum dryer for producing pregelatinized maize starches. Journal of Food Engineering, 51, pp. 171-183.
12. Vlachos, N.A. and Karapantsios, T.D. (2000) Water content measurement of thin sheet starch products using a conductance technique. Journal of Food Engineering, 46:2, pp. 91-98.
13. Hassebrauck, M. and Ermel, G. (1996) Two examples of thermal drying of sewage sludge. Water Science and Technology, 33:12, pp. 235-242.
14. Shiravi, A.H., Mujumdar, A.S. and Kubes, G.J. (1997) Drum drying of black liquor using superheated steam impinging jets. Drying Technology, 15:5, pp. 1571-1584.
15. Kostoglou, M. and Karapantsios, T.D. (2003) On the thermal inertia of the wall of a drum dryer under a cyclic steady state operation. Journal of Food Engineering, 60:4, pp. 453-462.
16. Trystram, G. and Vasseur, J. (1992) Modeling and simulation of a drum-drying process. International Chemical Engineering, 32:4, pp. 689-705.
17. Stemmelen, D., Moyne, C. and Perre, P. (1997) Drum drying of fabrics. Drying Technology, 15:9, pp. 2089-2112.
18. Daud, W.R.B.W. (1991) Thermal dynamics of a drum dryer. Drying Technology, 9:2, pp. 463-478.
19. Nastaj, J.F. (2000) Numerical model of vacuum drying of suspensions on continuous drum dryer at two-region conductive-convective heating. International Communications in Heat and Mass Transfer, 27:7, pp. 925-936.
20. Roetzel, W. (1975) Improving heat transfer in steam-heated fast rotating paper drying drums. International Journal of Heat and Mass Transfer, 18:1, pp. 79-86.
21. Chen, P. and Pei, D.C.T. (1989) A mathematical model of drying processes. International Journal of Heat and Mass Transfer, 32:2, pp. 297-310.
22. Coumans, W.J. (2000) Models of drying kinetics based on drying curves of slabs. Chemical Engineering and Processing, 39, pp. 53-68.
23. Islam, M.R., Ho, J.C. and Mujumdar, A.S. (2003) Simulation of liquid diffusion-controlled drying of shrinking thin slabs subjected to multiple heat sources. Drying Technology, 21:3, pp. 413-438.
24. Krokida, M.K., Maroulis, Z.B. and Marinos-Kouris, D. (2002) Heat and mass transfer coefficients in drying: Compilation of literature data. Drying Technology, 20:1, pp. 1-18.
25. Arlabosse, P., Rodier, E., Ferrasse, J.H., Chavez, S. and Lecomte, D. (2003) Comparison between static and dynamic methods for sorption isotherm measurements. Drying Technology, 21:3, pp. 479-497.
26. Sablani, S., Rahman, S. and Al-Habsi, N. (2000) Drying Technology in Agriculture and Food Sciences, pp. 41-49. Science Publishers, Inc., Enfield, NH
27. Incropera, F.P. and DeWitt, D.P. (1996) Fundamentals of Heat and Mass Transfer, John Wiley & Sons, New York
28. Raderer, M. (2001) Drying of Viscous, Shrinking Products: Modeling and Experimental Validation, Technical University of Munich, Germany
29. Saravacos, G.D. and Maroulis, Z.B. (2001) Transport Properties of Foods, Marcel Dekker, New York
30. Keey, R.B. (1972) Drying Principles and Practice, Pergamon Press, Oxford
31. Etter, D.M. (1993) Engineering Problem Solving with Matlab, Prentice Hall, Englewood Cliffs, NJ