Dynamic load and strain analysis for the optimization of micro end mills

CIRP Annals - Manufacturing Technology

Volumn 54, Issue 1, 2005, Pages 75-78

  Uhlmann, E ^a   Schauer, K ^a  

^a TECHNISCHE UNIVERSITÄT BERLIN   (Germany)

Author keywords

Micromachining; Milling; Tool Design

Indexed keywords

DYNAMIC LOADS; FINITE ELEMENT METHOD; HARDNESS; MACHINE TOOLS; STEEL; STRAIN;

CEMENTED CARBIDE; MICROMILLING PROCESS; STEEL MICROCOMPONENT GEOMETRIES; TOOL DESIGN;

MILLING (MACHINING);

EID: 21944447678     PISSN: 00078506     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0007-8506(07)60053-5     Document Type: Article

References (12)

1. Masuzawa, T., 2000, State of the Art Micromachining, Annals of the CIRP, 49/2:473-487.
2. Alting, L., Kimura, F., Hansen, H.N., Bissacco, G., 2003, Micro Engineering, Annals of the CIRP, 52/2:635-657.
3. Onikura, H.; Ohnishi, O.; Take, Y., 2000, Fabrication of Micro Carbide Tools by Ultrasonic Vibration Grinding, Annals of the CIRP, 49/1:257-260.
4. Weule, H., Hüntrup, V., Tritschler, H., 2001, Micro-Cutting of Steel to Meet New Requirements in Miniaturization, Annals of the CIRP, 50/1:61-64.
5. Schaller, T.; Bonn, L.; Mayer, J.; Schubert, K., 1999, Microstructure grooves with a width of less than 50 μm cut with ground hard metal micro end mills. Precision Engineering, 23:229-235.
6. Masuzawa, T., Fujino, M., 1990, A process for manufacturing very fine pin tools, SME Technical Papers, MS90, 307:1-11.
7. Adams, D., P. et al., 2001, Micromilling of metal alloys with focused ion beam fabricated tools. Precision Engineering, 25:107-113.
8. Uhlmann, E., Schauer, K., 2003, Laser Vibrometer for Measurement Tasks in Micromilling. Production Engineering, X/1:77-82.
9. Byrne, G., Dornfeld, D., Denkena, B., 2003, Advancing Cutting Technology, Annals of the CIRP, 52/2:1-20.
10. Weinert, K.; Kahnis, P.; Köhler, W., 2003, Investigation of Scaling Effects on Modelling an Simulation of Scaled Milling Process. Process Scaling, Proceedings of the 1st Colloquium of DFG Priority Program Process Scaling, 107-112.
11. Sailer, T., et al., 2001, Microstructure and mechanical properties of ultrafine-grained hard metals, Int. J. o. Refractory Metals & Hard Materials, 19:553-559.
12. Wertheim, R., Satran, A., Ber, A., 1994, Modification of the Cutting Edge Geometry an Chip Formation in Milling, Annals of the CIRP, 43/1:63-68.