Towards the Development of the In-Cylinder Pressure Measurement Based on the Strain Gauge Technique for Internal Combustion Engines

SAE Technical Papers

Volumn 2015-September, Issue September, 2015, Pages

  Amirante, Riccardo ^a   Casavola, Caterina ^a   Distaso, Elia ^a   Tamburrano, Paolo ^a  

^a POLITECNICO DI BARI   (Italy)

Author keywords

[No Author keywords available]

Indexed keywords

COMBUSTION CHAMBERS; COMBUSTION EQUIPMENT; COST BENEFIT ANALYSIS; COSTS; STRAIN GAGES; STRAIN MEASUREMENT;

CYLINDER PRESSURE SENSOR; ENGINE OPERATING CONDITIONS; EXPERIMENTAL INVESTIGATIONS; IN-CYLINDER PRESSURES; PRESSURE-BASED CONTROLS; SIGNIFICANT VARIABLES; STRAIN GAUGE TECHNIQUE; TEMPERATURE VARIATION;

ENGINE CYLINDERS;

EID: 84959318683     PISSN: None     EISSN: 01487191     Source Type: Journal    
DOI: 10.4271/2015-24-2419     Document Type: Conference Paper

References (33)

1. Kawamura Y., Shinshi M., Sato H., Takahashi N. et al., " MBT Control through Individual Cylinder Pressure Detection," SAE Technical Paper http://www.sae.org/technical/papers/881779 881779, 1988, doi: 10.4271/881779.
2. Yoon P., Park S., Sunwoo M., Ohm I. et al., " Closed-Loop Control of Spark Advance and Air-Fuel Ratio in SI Engines Using Cylinder Pressure," SAE Technical Paper http://www.sae.org/technical/papers/2000-01-0933 2000-01-0933, 2000, doi: 10.4271/2000-01-0933.
3. Eriksson L. (1999). Spark advance modeling and control. Division of Vehicular Systems, Department of Electrical Engineering, Linköping University.
4. Saraswati S., Agarwal P. K., & Chand S. (2011). Neural networks and fuzzy logic-based spark advance control of SI engines. Expert Systems with Applications, 38 (6), 6916-6925.
5. Yu S., Choi H., Cho S., Han K., & Min K. (2013). Development of engine control using the in-cylinder pressure signal in a high speed direct injection diesel engine. International Journal of Automotive Technology, 14 (2), 175-182.
6. Leonhardt S., Muller N., & Isermann R. (1999). Methods for engine supervision and control based on cylinder pressure information. Mechatronics, IEEE/ASME Transactions on, 4 (3), 235-245.
7. Bargende M. (1995). Most optimal location of 50% mass fraction burned and automatic knock detection. Components for automatic optimization of SI-engine calibrations. M T Z, 56 (10), 632-638.
8. Sellnau M., Matekunas F., Battiston P., Chang C. et al., " Cylinder-Pressure-Based Engine Control Using Pressure-Ratio-Management and Low-Cost Non-Intrusive Cylinder Pressure Sensors," SAE Technical Paper http://www.sae.org/technical/papers/2000-01-0932 2000-01-0932, 2000, doi: 10.4271/2000-01-0932.
9. Cook H. A., Heinicke O. H., & Haynie W. H. (1947). Spark-Timing Control Based on Correlation of Maximum-Economy Spark Timing, Flame-Front Travel and Cylinder-Pressure Rise (No. NACA-886). National aeronautics and space administration Washington dc.
10. Yoon M., Lee K., & Sunwoo M. (2007). A method for combustion phasing control using cylinder pressure measurement in a CRDI diesel engine. Mechatronics, 17 (9), 469-479.
11. Willems F., Doosje E., Engels F., and Seykens X., " Cylinder Pressure-Based Control in Heavy-Duty EGR Diesel Engines Using a Virtual Heat Release and Emission Sensor," SAE Technical Paper http://www.sae.org/technical/papers/2010-01-0564 2010-01-0564, 2010, doi: 10.4271/2010-01-0564.
12. Henningsson M., Tunestal P., & Johansson R. (2012, October). A Virtual Sensor for Predicting Diesel Engine Emissions from Cylinder Pressure Data. In Engine and Powertrain Control, Simulation and Modeling (Vol. 3, No. 1, pp. 424-431).
13. Taglialatela F., Cesario N., Porto M., Merola S. et al., " Use of Accelerometers for Spark Advance Control of SI Engines," SAE Int. J. Engines 2 (1): 971-981, 2009, doi: http://dx.doi.org/10.4271/2009-01-1019 10.4271/2009-01-1019.
14. Taglialatela-Scafati F., Lavorgna M., and Mancaruso E., " Use of Vibration Signal for Diagnosis and Control of a Four-Cylinder Diesel Engine," SAE Technical Paper http://www.sae.org/technical/papers/2011-24-0169 2011-24-0169, 2011, doi: 10.4271/2011-24-0169.
15. Taglialatela-Scafati F., Cesario N., Lavorgna M., Mancaruso E. et al., " Diagnosis and Control of Advanced Diesel Combustions using Engine Vibration Signal," SAE Technical Paper http://www.sae.org/technical/papers/2011-01-1414 2011-01-1414, 2011, doi: 10.4271/2011-01-1414.
16. Bizon K., Continillo G., Mancaruso E., and Vaglieco B., " Reconstruction of In-Cylinder Pressure in a Diesel Engine from Vibration Signal Using a RBF Neural Network Model," SAE Technical Paper http://www.sae.org/technical/papers/2011-24-0161 2011-24-0161, 2011, doi: 10.4271/2011-24-0161.
17. Bizon K., Continillo G., Mancaruso E., and Vaglieco B., " Towards On-Line Prediction of the In-Cylinder Pressure in Diesel Engines from Engine Vibration Using Artificial Neural Networks," SAE Technical Paper http://www.sae.org/technical/papers/2013-24-0137 2013-24-0137, 2013, doi: 10.4271/2013-24-0137.
18. Polonowski C., Mathur V., Naber J., and Blough J., " Accelerometer Based Sensing of Combustion in a High Speed HPCR Diesel Engine," SAE Technical Paper http://www.sae.org/technical/papers/2007-01-0972 2007-01-0972, 2007, doi: 10.4271/2007-01-0972.
19. Johnsson R. (2006). Cylinder pressure reconstruction based on complex radial basis function networks from vibration and speed signals. Mechanical Systems and Signal Processing, 20 (8), 1923-1940.
20. Cavina N., Moro D., Poffio L., Zecchetti D., Nanni R., & Gelmetti A. (2007). Individual Cylinder Combustion Control Based on Real-Time Processing of Ion Current Signals. Diesel Engine, 2009, 01-01.
21. Cavina N., Poggio L., and Sartoni G., " Misfire and Partial Burn Detection based on Ion Current Measurement," SAE Int. J. Engines 4 (2): 2451-2460, 2011, doi: http://dx.doi.org/10.4271/2011-24-0142 10.4271/2011-24-0142.
22. Shamekhi A. H., & Ghaffari A. (2007). Fuzzy control of spark advance by ion current sensing. Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 221 (3), 335-342.
23. Malaczynski G., Roth G., and Johnson D., " Ion-Sense-Based Real-Time Combustion Sensing for Closed Loop Engine Control," SAE Int. J. Engines 6 (1): 267-277, 2013, doi: http://dx.doi.org/10.4271/2013-01-0354 10.4271/2013-01-0354.
24. Brown T. and Neill W., " Determination of Engine Cylinder Pressures from Crankshaft Speed Fluctuations," SAE Technical Paper http://www.sae.org/technical/papers/920463 920463, 1992, doi: 10.4271/920463.
25. Yinhui W., Kaisheng H., Zhihua L., & Fanbo M. (2011, April). Advanced gasoline engine misfire diagnostic method based on crankshaft speed multiple filtering. In Electric Information and Control Engineering (ICEICE), 2011 International Conference on (pp. 1964-1968). IEEE.
26. Rizzoni G., " Diagnosis of individual Cylinder Misfires by Signature Analysis of Crankshaft Speed Fluctuations," SAE Technical Paper http://www.sae.org/technical/papers/890884 890884, 1989, doi: 10.4271/890884.
27. Azzoni P., Cantoni G., Minelli G., Moro D. et al., " Measurement of Engine Misfire in the Lamborghini 533 V-12 Engine Using Crankshaft Speed Fluctuations," SAE Technical Paper http://www.sae.org/technical/papers/950837 950837, 1995, doi: 10.4271/950837.
28. Azzoni P., Moro D., Porceddu-Cilione C., and Rizzoni G., " Misfire Detection in a High-Performance Engine by the Principal Component Analysis Approach," SAE Technical Paper http://www.sae.org/technical/papers/960622 960622, 1996, doi: 10.4271/960622.
29. Connolly F. T., & Rizzoni G. (1994). Real time estimation of engine torque for the detection of engine misfires. Journal of dynamic systems, measurement, and control, 116 (4), 675-686.
30. Taglialatela F., Lavorgna M., Mancaruso E., & Vaglieco B. M. (2013). Determination of combustion parameters using engine crankshaft speed. Mechanical Systems and Signal Processing, 38 (2), 628-633.
31. Heywood J., Internal Combustion Engine Fundamentals, McGraw-ill Publishing Company, 1988
32. Ferrari G., Motori a combustione interna, Il capitello, 1996
33. Wang C. S., & Berry G. F. (1985). Heat transfer in internal combustion engines. ASME paper, (85-WA).