Diagnosis of eccentric rotor in synchronous machines by analysis of split-phase currents - Part II: Experimental analysis

IEEE Transactions on Industrial Electronics

Volumn 61, Issue 8, 2014, Pages 4206-4216

  Bruzzese, Claudio ^a  

^a SAPIENZA UNIVERSITY OF ROME   (Italy)

Author keywords

Condition monitoring; current measurement; eccentricity; fault diagnosis; parallel windings; rotor; saturation; spectral analysis; synchronous machine (SM); virtual instrument (VI)

Indexed keywords

CONDITION MONITORING; ELECTRIC CURRENT MEASUREMENT; ELECTRIC FAULT CURRENTS; FAILURE ANALYSIS; FOURIER TRANSFORMS; ROTORS; SATURATION (MATERIALS COMPOSITION); SPECTRUM ANALYSIS; SYNCHRONOUS GENERATORS; WINDING;

CURRENT SIGNATURE ANALYSIS; ECCENTRICITY; FINITE ELEMENT SIMULATIONS; FOURIER TRANSFORMATIONS; PARALLEL WINDINGS; SYMMETRICAL COMPONENTS; SYNCHRONOUS MACHINE; VIRTUAL INSTRUMENT;

ROTORS (WINDINGS);

EID: 84894428244     PISSN: 02780046     EISSN: None     Source Type: Journal    
DOI: 10.1109/TIE.2013.2284554     Document Type: Article

References (39)

1. J. Sottile, F. C. Trutt, and A.W. Leedy, "Condition monitoring of brushless three-phase synchronous generators with stator winding or rotor circuit deterioration," IEEE Trans. Ind. Appl., vol. 42, no. 5, pp. 1209-1215, Sep./Oct. 2006. (Pubitemid 44500754)
2. Z. Daneshi-Far, H. Henao, and G.-A. Capolino, "Planetary gearbox effects on induction machine in wind turbine: Modeling and analysis," in Proc. ICEM Conf., Marseille, France, Sep. 2-5, 2012, pp. 1790-1796.
3. S. H. Kia, H. Henao, and G.-A. Capolino, "A high-resolution frequency estimation method for three-phase induction machine fault detection," IEEE Trans. Ind. Electron., vol. 54, no. 4, pp. 2305-2314, Aug. 2007. (Pubitemid 47296521)
4. F. Vedreno-Santos, M. Riera-Guasp, H. Henao, and M. Pineda-Sanchez, "Diagnosis of faults in induction generators under fluctuating load conditions through the instantaneous frequency of the fault components," in Proc. ICEM Conf., Marseille, France, Sep. 2-5, 2012, pp. 1653-1659.
5. J. Krotsch and B. Piepenbreier, "Radial forces in external rotor permanent magnet synchronous motors with non-overlapping windings," IEEE Trans. Ind. Electron., vol. 59, no. 5, pp. 2267-2276, May 2012.
6. M. F. Cabanas, F. Pedrayes, C. H. Rojas, M. G. Melero, J. G. Norniella, G. A. Orcajo, J. M. Cano, F. Nuno, and D. R. Fuentes, "A new portable, self-powered, and wireless instrument for the early detection of broken rotor bars in induction motors," IEEE Trans. Ind. Electron., vol. 58, no. 10, pp. 4917-4930, Oct. 2011.
7. A. Tessarolo, C. Bassi, G. Ferrari, D. Giulivo, R. Macuglia, and R. Menis, "Investigation into the high-frequency limits and performance of load commutated inverters for high-speed synchronous motor drives," IEEE Trans. Ind. Electron., vol. 60, no. 6, pp. 2147-2157, Jun. 2013.
8. S. H. Kia, H. Henao, and G.-A. Capolino, "Some digital signal processing techniques for induction machine diagnosis," in Proc. IEEE SDEMPED Conf., Bologna, Italy, Sep. 5-8, 2011, pp. 322-329.
9. C. Bruzzese, "Field experience with the split-phase current signature analysis (SPCSA): Eccentricity assessment for a stand-alone alternator in time-varying and unbalanced load conditions," in Proc. IEEE WEMDCD Conf., Paris, France, Mar. 11-12, 2013, pp. 257-270.
10. G. Traxler-Samek, T. Lugand, and M. Uemori, "Vibrational forces in salient pole synchronous machines considering tooth ripple effects," IEEE Trans. Ind. Electron., vol. 59, no. 5, pp. 2258-2266, May 2012.
11. T. Hosoi, H. Watanabe, K. Shima, T. Fukami, R. Hanaoka, and S. Takata, "Demagnetization analysis of additional permanent magnets in salient-pole synchronous machines with damper bars under sudden short circuits," IEEE Trans. Ind. Electron., vol. 59, no. 6, pp. 2448-2456, Jun. 2012.
12. S. Stipetic, M. Kovacic, Z. Hanic, and M. Vrazic, "Measurement of excitation winding temperature on synchronous generator in rotation using infrared thermography," IEEE Trans. Ind. Electron., vol. 59, no. 5, pp. 2288-2298, May 2012.
13. A. Foggia, J.-E. Torlay, C. Corenwinder, A. Audoli, and J. Herigault, "Circulating current analysis in the parallel-connected windings of synchronous generators under abnormal operating conditions," in Proc. IEEE IEMDC Conf., Seattle, WA, USA, May 9-12, 1999, pp. 634-636.
14. M. Biet, "Rotor faults diagnosis using features selection and nearest neighbors rule: Application to a turbogenerator," IEEE Trans. Ind. Electron., vol. 60, no. 9, pp. 4063-4073, Sep. 2013.
15. J. J. Simond, M. Tu Xuan, and R. Wetter, "An innovative inductive air-gap monitoring for large low speed hydro-generators," presented at the Proc. ICEM Conf., Vilamoura, Portugal, Sep. 6-9, 2008, paper ID 760.
16. L. Romeral, J. C. Urresty, J. R. R. Ruiz, and A. G. Espinosa, "Modeling of surface-mounted permanent magnet synchronous motors with stator winding interturn faults," IEEE Trans. Ind. Electron., vol. 58, no. 5, pp. 1576-1585, May 2011.
17. L. Wang, R. W. Cheung, Z. Ma, J. Ruan, and Y. Peng, "Finite-element analysis of unbalanced magnetic pull in a large hydro-generator under practical operations," IEEE Trans. Magn., vol. 44, no. 6, pp. 1558-1561, Jun. 2008. (Pubitemid 351711493)
18. B. A. T. Iamamura, Y. Le Menach, A. Tounzi, N. Sadowski, E. Guillot, T. Jacq, and J. Langlet, "Study of synchronous generator static eccentricities-FEM results and measurements," in Proc. ICEM Conf., Marseille, France, Sep. 2-5, 2012, pp. 1829-1835.
19. D. Zarko, D. Ban, I. Vazdar, and V. Jaric, "Calculation of unbalanced magnetic pull in a salient-pole synchronous generator using finite-element method and measured shaft orbit," IEEE Trans. Ind. Electron., vol. 59, no. 6, pp. 2536-2549, Jun. 2012.
20. S. H. Kia, H. Henao, and G.-A. Capolino, "Torsional vibration assessment using induction machine electromagnetic torque estimation," IEEE Trans. Ind. Electron., vol. 57, no. 1, pp. 209-219, Jan. 2010.
21. S. Keller, M. Tu Xuan, J. J. Simond, and A. Schwery, "Large low-speed hydro-generators-unbalanced magnetic pulls and additional damper losses in eccentricity conditions," IET Electr. Power Appl., vol. 1, no. 5, pp. 657-664, Sep. 2007. (Pubitemid 47283386)
22. H. Henao, S. M. J. R. Rastegar Fatemi, G.-A. Capolino, and S. Sieg-Zieba, "Wire rope fault detection in a hoisting winch system by motor torque and current signature analysis," IEEE Trans. Ind. Electron., vol. 58, no. 5, pp. 1727-1736, May 2011.
23. H. A. Toliyat and N. A. Al-Nuaim, "Simulation and detection of dynamic air-gap eccentricity in salient-pole synchronous machines," IEEE Trans. on Ind. Appl., vol. 35, no. 1, pp. 86-93, Jan./Feb. 1999.
24. C. Bruzzese, A. Giordani, A. Rossi, and E. Santini, "Synchronous generator eccentricities modeling by improved MWFA and fault signature evaluation in no-load E.M.F.s and current spectra," in Proc. SPEEDAM Conf., Ischia, Italy, Jun. 18-20, 2008, pp. 200-205.
25. T. Ilamparithi and S. Nandi, "Analysis, modeling and simulation of static eccentric reluctance synchronous motor," in Proc. IEEE SDEMPED Conf., Bologna, Italy, Sep. 5-8, 2011, pp. 45-50.
26. B. M. Ebrahimi, J. Faiz, and M. J. Roshtkhari, "Static-, dynamic-, and mixed-eccentricity fault diagnoses in permanent-magnet synchronous motors," IEEE Trans. Ind. Electron., vol. 56, no. 11, pp. 4727-4739, Nov. 2009.
27. C. Bruzzese and G. Joksimovic, "Harmonic signatures of static eccentricities in the stator voltages and in the rotor current of no-load salient pole synchronous generators," IEEE Trans. Ind. Electron., vol. 58, no. 5, pp. 1606-1624, May 2011.
28. C. Bruzzese, A. Rossi, E. Santini, V. Benucci, and A. Millerani, "Ship brushless generator shaft misalignment simulation by using a complete mesh-model for machine voltage signature analysis (MVSA)," in Proc. IEEE Elect. Ship Tech. Symp., Baltimore, MD, USA, Apr. 20-22, 2009, pp. 113-118.
29. M. Kiani, W. J. Lee, R. Kenarangui, and B. Fahimi, "Detection of rotor faults in synchronous generators," in Proc. IEEE SDEMPED Conf., Cracow, Poland, Sep. 6-8, 2007, pp. 266-271.
30. C. Bruzzese, G. Joksimovic, and E. Santini, "Static eccentricity detection in synchronous generators by field current and stator voltage signature analysis-Part II: Measurements," in Proc. ICEM Conf., Rome, Italy, Sep. 6-8, 2010, pp. 1-5.
31. P. Neti and S. Nandi, "Stator interturn fault detection of synchronous machines using field current and rotor search-coil voltage signature analysis," IEEE Trans. Ind. Appl., vol. 45, no. 3, pp. 911-920, May/Jun. 2009.
32. R. Perers, U. Lundin, and M. Leijon, "Saturation effects on unbalanced magnetic pull in a hydroelectric generator with an eccentric rotor," IEEE Trans. Magn., vol. 43, no. 10, pp. 3884-3890, Oct. 2007. (Pubitemid 47460330)
33. C. Bruzzese, "Diagnosis of eccentric rotor in synchronous machines by analysis of split-phase currents-Part I: Theoretical analysis," IEEE Trans. Ind. Electron., Oct. 1, 2013. DOI: 10.1109/TIE.2013.2284141.
34. C. Bruzzese, "A virtual instrument for on-line evaluation of alternator's shaft misalignments through ICSVA (Internal Current Space-Vector Analysis)," in Proc. IEEE SDEMPED Conf., Bologna, Italy, Sep. 5-8, 2011, pp. 55-62.
35. C. Bruzzese, "Rotor eccentricity evaluation in an alternator with parallel pole-phase-groups in the stator: FEM simulations and experimental proofs," in Proc. IEEE ENERGYCON Conf., Florence, Italy, Sep. 9-12, 2012, pp. 106-112.
36. H. Henao, G.-A. Capolino, M. Fernandez, F. Filippetti, C. Bruzzese, E. Strangas, R. Pusca, J. Estima, M. Riera-Guasp, and S. Hedayati, "Trends in fault diagnosis for electrical machines," IEEE Ind. Electron. Mag., accepted for publication.
37. C. Bruzzese, "2-pole turbo-generator eccentricity diagnosis by split-phase current signature analysis," in Proc. IEEE SDEMPED Conf., Valencia, Spain, Aug. 27-30, 2013, pp. 349-357.
38. C. Bruzzese, "Diagnosis-oriented sequence circuit-based modeling of eccentric rotor traction induction motors accounting for cage damping and split-phase currents," in Proc. IEEE EPECS Conf., Instanbul, Turkey, Oct. 2-4, 2013, pp. 740-747.
39. C. Bruzzese, "Validation of sequence circuits useful for split-phase current signature analysis (SPCSA) and diagnosis of eccentric-rotor traction cage motors," in Proc. IEEE EPECS Conf., Instanbul, Turkey, Oct. 2-4, 2013, pp. 799-806.