Improving Efficiency and Using E10 for Higher Loads in Boosted HCCI Engines

SAE International Journal of Engines

Volumn 5, Issue 3, 2012, Pages 1009-1032

  Dec, John E ^a   Yang, Yi ^a   Dronniou, Nicolas ^a  

^a SANDIA NATIONAL LABORATORIES   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

COMBUSTION; DATA COMPRESSION; ECONOMIC AND SOCIAL EFFECTS; EFFICIENCY; ENGINE CYLINDERS; ETHANOL FUELS; FUELING; FUELS; GASOLINE; HEAT TRANSFER; INTERNAL COMBUSTION ENGINES; MIXTURES;

COMBUSTION EFFICIENCIES; COMBUSTION PHASING; CONVENTIONAL GASOLINE; ENGINE CONFIGURATION; FUEL STRATIFICATION; IMPROVING EFFICIENCY; MIXTURE STRATIFICATIONS; OPERATING PARAMETERS;

ENGINES;

EID: 84877183728     PISSN: 19463936     EISSN: 19463944     Source Type: Journal    
DOI: 10.4271/2012-01-1107     Document Type: Article

References (36)

1. Dec, J.Yang, Y. and , “Boosted HCCI for High Power without Engine Knock and with Ultra-Low NOx Emissions - using Conventional Gasoline,” SAE Int. J. Engines 3(1):750-767, 2010, doi:10.4271/2010-01-1086.
2. Dec, J.Yang, Y.Dronniou, N., , and , “Boosted HCCI - Controlling Pressure-Rise Rates for Performance Improvements using Partial Fuel Stratification with Conventional Gasoline,” SAE Int. J. Engines 4(1):1169-1189, 2011, doi:10.4271/2011-01-0897.
3. Olsson, J.Tunestål, P.Johansson, B.Fiveland, S., , , et al., “Compression Ratio Influence on Maximum Load of a Natural Gas Fueled HCCI Engine,” SAE Technical Paper 2002-01-0111, 2002, doi:10.4271/2002-01-0111.
4. Sjöberg, M.Dec, J.Babajimopoulos, A.Assanis, D., , , and , “Comparing Enhanced Natural Thermal Stratification Against Retarded Combustion Phasing for Smoothing of HCCI Heat-Release Rates,” SAE Technical Paper 2004-01-2994, 2004, doi:10.4271/2004-01-2994.
5. Yun, H.Wermuth, N.Najt, P., , and , “Development of Robust Gasoline HCCI Idle Operation Using Multiple Injection and Multiple Ignition (MIMI) Strategy,” SAE Technical Paper 2009-01-0499, 2009, doi:10.4271/2009-01-0499.
6. Wermuth, N.Yun, H.Najt, P., , and , “Enhancing Light Load HCCI Combustion in a Direct Injection Gasoline Engine by Fuel Reforming During Recompression,” SAE Int. J. Engines 2(1):823-836, 2009, doi:10.4271/2009-01-0923.
7. Kokjohn, S.Hanson, R.Splitter, D.Reitz, R., , , and , “Experiments and Modeling of Dual-Fuel HCCI and PCCI Combustion Using In-Cylinder Fuel Blending,” SAE Int. J. Engines 2(2):24-39, 2010, doi:10.4271/2009-01-2647.
8. Kokjohn, S.Hanson, R.Splitter, D.Kaddatz, J., , , et al., “Fuel Reactivity Controlled Compression Ignition (RCCI) Combustion in Light- and Heavy-Duty Engines,” SAE Int. J. Engines 4(1):360-374, 2011, doi:10.4271/2011-01-0357.
9. Manente, V.Johansson, B.Tunestal, P.Cannella, W., , , and , “Influence of Inlet Pressure, EGR, Combustion Phasing, Speed and Pilot Ratio on High Load Gasoline Partially Premixed Combustion,” SAE Technical Paper 2010-01-1471, 2010, doi:10.4271/2010-01-1471.
10. Manente, V.Zander, C.Johansson, B.Tunestal, P., , , et al., “An Advanced Internal Combustion Engine Concept for Low Emissions and High Efficiency from Idle to Max Load Using Gasoline Partially Premixed Combustion,” SAE Technical Paper 2010-01-2198, 2010, doi:10.4271/2010-01-2198.
11. Dec, J.Sjöberg, M.Hwang, W., , and , “Isolating the Effects of EGR on HCCI Heat-Release Rates and NOX Emissions,” SAE Int. J. Engines 2(2):58-70, 2010, doi:10.4271/2009-01-2665.
12. Sjoberg, M.Dec, J. and , “Ethanol Autoignition Characteristics and HCCI Performance for Wide Ranges of Engine Speed, Load and Boost,” SAE Int. J. Engines 3(1):84-106, 2010, doi:10.4271/2010-01-0338.
13. Christensen, M.Johansson, B.Amnéus, P.Mauss, F., , , and , “Supercharged Homogeneous Charge Compression Ignition,” SAE Technical Paper 980787, 1998, doi: 10.4271/980787.
14. Christensen, M.Johansson, B. and , “Supercharged Homogeneous Charge Compression Ignition (HCCI) with Exhaust Gas Recirculation and Pilot Fuel,” SAE Technical Paper 2000-01-1835, 2000, doi:10.4271/2000-01-1835.
15. Olsson, J.Tunestål, P.Haraldsson, G.Johansson, B., , , and , “A Turbo Charged Dual Fuel HCCI Engine,” SAE Technical Paper 2001-01-1896, 2001, doi:10.4271/2001-01-1896.
16. Bessonette, P.Schleyer, C.Duffy, K.Hardy, W., , , et al., “Effects of Fuel Property Changes on Heavy-Duty HCCI Combustion,” SAE Technical Paper 2007-01-0191, 2007, doi:10.4271/2007-01-0191.
17. Sjöberg, M.Dec, J.Hwang, W., , and , “Thermodynamic and Chemical Effects of EGR and Its Constituents on HCCI Autoignition,” SAE Technical Paper 2007-01-0207, 2007, doi:10.4271/2007-01-0207.
18. Dec, J.Sjöberg, M. and , “A Parametric Study of HCCI Combustion - the Sources of Emissions at Low Loads and the Effects of GDI Fuel Injection,” SAE Technical Paper 2003-01-0752, 2003, doi:10.4271/2003-01-0752.
19. Sjöberg, M.Dec, J. and , “Influence of Fuel Autoignition Reactivity on the High-Load Limits of HCCI Engines,” SAE Int. J. Engines 1(1):39-58, 2009, doi:10.4271/2008-01-0054.
20. Anderson, J. E.Kramer, U.Mueller, S. A.Wallington, T. J., , , and , “Octane Numbers of Ethanol- and Methanol-Gasoline Blends Estimated from Molar Concentrations,” Energy and Fuels, 24:6576-6585, 2010.
21. Yang, Y.Dec, J. E.Dronniou, N.Sjöberg, M., , , and , “Tailoring HCCI Heat Release Rates with Partial Fuel Stratification: Comparison of Two-Stage and Single-Stage Ignition Fuels,” Proceedings of the Combustion Institute, 33:3047-3055, 2011.
22. Heywood, J. B., Internal Combustion Engine Fundamentals, McGraw-Hill, New York, 1988.
23. Thring, R., “Homogeneous-Charge Compression-Ignition (HCCI) Engines,” SAE Technical Paper 892068, 1989, doi: 10.4271/892068.
24. Olsson, J.Tunestål, P.Johansson, B.Fiveland, S., , , et al., “Compression Ratio Influence on Maximum Load of a Natural Gas Fueled HCCI Engine,” SAE Technical Paper 2002-01-0111, 2002, doi:10.4271/2002-01-0111.
25. Tsurushima, T.Kunishima, E.Asaumi, Y.Aoyagi, Y., , , et al., “The Effect of Knock on Heat Loss in Homogeneous Charge Compression Ignition Engines,” SAE Technical Paper 2002-01-0108, 2002, doi:10.4271/2002-01-0108.
26. Eng, J., “Characterization of Pressure Waves in HCCI Combustion,” SAE Technical Paper 2002-01-2859, 2002, doi:10.4271/2002-01-2859.
27. Andreae, M.Cheng, W.Kenney, T.Yang, J., , , and , “On HCCI Engine Knock,” SAE Technical Paper 2007-01-1858, 2007, doi:10.4271/2007-01-1858.
28. Olsson, J.Tunestål, P.Ulfvik, J.Johansson, B., , , and , “The Effect of Cooled EGR on Emissions and Performance of a Turbocharged HCCI Engine,” SAE Technical Paper 2003-01-0743, 2003, doi:10.4271/2003-01-0743.
29. Dec, J.Hwang, W. and , “Characterizing the Development of Thermal Stratification in an HCCI Engine Using Planar-Imaging Thermometry,” SAE Int. J. Engines 2(1):421-438, 2009, doi:10.4271/2009-01-0650.
30. Snyder, J.Dronniou, N.Dec, J.Hanson, R., , , and , “PLIF Measurements of Thermal Stratification in an HCCI Engine under Fired Operation,” SAE Int. J. Engines 4(1):1669-1688, 2011, doi:10.4271/2011-01-1291.
31. Dec, J.Sjöberg, M. and , “Isolating the Effects of Fuel Chemistry on Combustion Phasing in an HCCI Engine and the Potential of Fuel Stratification for Ignition Control,” SAE Technical Paper 2004-01-0557, 2004, doi:10.4271/2004-01-0557.
32. Yang, Y.Dec, J.Dronniou, N.Sjöberg, M., , , et al., “Partial Fuel Stratification to Control HCCI Heat Release Rates: Fuel Composition and Other Factors Affecting Pre-Ignition Reactions of Two-Stage Ignition Fuels,” SAE Int. J. Engines 4(1):1903-1920, 2011, doi:10.4271/2011-01-1359.
33. Sjöberg, M.Dec, J. and , “An Investigation of the Relationship Between Measured Intake Temperature, BDC Temperature, and Combustion Phasing for Premixed and DI HCCI Engines,” SAE Technical Paper 2004-01-1900, 2004, doi:10.4271/2004-01-1900.
34. Sjöberg, M.Dec, J. and , “Effects of Engine Speed, Fueling Rate, and Combustion Phasing on the Thermal Stratification Required to Limit HCCI Knocking Intensity,” SAE Technical Paper 2005-01-2125, 2005, doi:10.4271/2005-01-2125.
35. Saxena, S.Chen, J.Dibble, R., , and , “Maximizing Power Output in an Automotive Scale Multi-Cylinder Homogeneous Charge Compression Ignition (HCCI) Engine,” SAE Technical Paper 2011-01-0907, 2011, doi:10.4271/2011-01-0907.
36. Dronniou, N.Lombard, B.Colliou, T.Tilagone, R.Réveillé, B., , , , and , “Dual-mode Engine for Euro VI Heavy-duty Applications: Presentation of the Concept,” Proceedings of THIESEL 2008, 2008.