Mechanical vibration reduction control of two-mass permanent magnet synchronous motor using adaptive notch filter with fast Fourier transform analysis

IET Electric Power Applications

Volumn 6, Issue 7, 2012, Pages 455-461

  Lee, D H ^a   Lee, J H ^a   Ahn, J W ^a  

^a Kyungsung University   (South Korea)

Author keywords

[No Author keywords available]

Indexed keywords

ADAPTIVE NOTCH FILTERS; BALL-SCREW; COMMAND SIGNAL; CONTROL SCHEMES; FEEDER SYSTEM; FOURIER TRANSFORM ANALYSIS; LOAD CONDITION; MECHANICAL CONFIGURATIONS; MECHANICAL COUPLING; MECHANICAL LOADS; MECHANICAL PLANTS; MECHANICAL SIGNALS; NUMERICAL CONTROL; PERMANENT MAGNET SYNCHRONOUS MOTOR; RESONANT VIBRATIONS; SERVO-DRIVE SYSTEMS; SPEED ERRORS; SPEED RESPONSE; TORQUE TRANSMISSION; TORSIONAL VIBRATION; VIBRATION FREQUENCY;

ADAPTIVE FILTERS; ELASTIC WAVES; FACTORY AUTOMATION; FAST FOURIER TRANSFORMS; INDUSTRIAL APPLICATIONS; MACHINE VIBRATIONS; MATERIALS HANDLING EQUIPMENT; NATURAL FREQUENCIES; NOTCH FILTERS; SYNCHRONOUS MOTORS; TORQUE MOTORS;

PERMANENT MAGNETS;

EID: 84864336118     PISSN: 17518660     EISSN: 17518679     Source Type: Journal    
DOI: 10.1049/iet-epa.2011.0322     Document Type: Article

References (16)

1. Choi, H.H., Vu, N.T.T., and Jung, J.W.: 'Digital implementation of an adaptive speed regulator for a PMSM', IEEE Trans. Power Electron., 2011, 26, (1), p. 3-810.1109/TPEL.2010.2055890 0885-8993
2. Liu, H., and Li, S.: 'Speed control for PMSM servo system using predictive functional control and extended state observer', IEEE Trans. Ind. Electron., 2012, 59, (2), p. 1171-118310.1109/TIE.2011.2162217 0278-0046
3. Carriere, S., Caux, S., and Fadel, M.: 'Optimized speed control in state space for PMSM direct drive', IET Electr. Power Appl., 2010, 4, (3), p. 158-16810.1049/iet-epa.2009.0080
4. Orlowska-Kowalska, T., Dybkowski, M., and Szabat, K.: 'Adaptive sliding-mode neuro-fuzzy control for the two-mass induction motor drive without mechanical sensors', IEEE Trans. Ind. Electron., 2010, 57, (2), p. 553-56410.1109/TIE.2009.2036023 0278-0046
5. Sepasi, D., Nagamune, R., and Sassani, F.: 'Tracking control of flexible ball screw drives with runout effect and mass variation', IEEE Trans. Ind. Electron., 2012, 59, (2), p. 1248-125610.1109/TIE.2011.2158042 0278-0046
6. Abeygunawardhana, P.K.W., and Murakami, T.: 'Vibration suppression of two-wheel mobile manipulator using resonance-ratio-control-based null-space control', IEEE Trans. Ind. Electron., 2010, 57, (12), p. 4137-414610.1109/TIE.2010.2044115 0278-0046
7. Kia, S.H., Henao, H., and Capolino, G.A.: 'Torsional vibration effects on induction machine current and torque signatures in gearbox-based electromechanical system', IEEE Trans. Ind. Electron., 2009, 56, (11), p. 4689-469910.1109/TIE.2009.2026772 0278-0046
8. Muszynski, R., and Deskur, J.: 'Damping of torsional vibrations in high-dynamic industrial drives', IEEE Trans. Ind. Electron., 2010, 57, (2), p. 544-55210.1109/TIE.2009.2036034 0278-0046
9. Ikeda, H., Hanamoto, T., and Tsuji, T.: 'Digital speed control of multi-inertia resonant system using real time simulator', Proc. Electrical Machines and Systems, 2007, p. 1881-1886
10. Vasak, M., and Peric, N.: 'Protective predictive control of electrical drives with elastic transmission', Proc. Power Electronics and Motion Control Conf., 2008, p. 2235-2240
11. Deskur, J., and Muszynski, R.: 'The problems of high dynamic drive control under circumstance of elastic transmission', Proc. Power Electronics and Motion Control Conf., 2008, p. 2227-2234
12. Levin, J., and Ioannou, P.: 'Multi-rate adaptive notch filter with an adaptive bandwidth controller for disk drives', Proc. American Control Conf., 2008, p. 4407-4412
13. Li, G.: 'A Stable and efficient adaptive notch filter for direct frequency estimation', IEEE Trans. Signal Process., 1997, 45, (8), p. 2001-200910.1109/78.611196 1053-587X
14. Cadzow, J.: 'Digital notch filter design procedure', IEEE Trans. Signal Process., 1974, 22, (1), p. 10-1510.1109/TASSP.1974.1162533 1053-587X
15. Wilson, C.S.: 'Using notch filters in motion control - part 1', Motion Control, 1992, p. 48-51
16. Wilson, C.S.: 'Using notch filters in motion control - part 2', Motion Control, 1992, p. 19-22