Sliding-mode observer for urea-selective catalytic reduction (SCR) mid-catalyst ammonia concentration estimation

International Journal of Automotive Technology

Volumn 12, Issue 3, 2011, Pages 321-329

  Hsieh, M F ^a   Wang, J ^a  

^a Ohio State University   (United States)

Author keywords

Ammonia concentration estimation; Diesel engine; SCR; Sliding mode observer

Indexed keywords

AMMONIA CONCENTRATION ESTIMATION; AMMONIA CONCENTRATIONS; AMMONIA SENSORS; AMMONIA SLIP; CONTROL METHODS; DISTRIBUTION CONTROL; EXPERIMENTAL VALIDATIONS; FAULT DIAGNOSIS; OBSERVER DESIGN; REDUCTANTS; SCR; SCR CATALYSTS; SLIDING MODE OBSERVER; SLIDING MODES; SYSTEM-SETUP; UREA-SELECTIVE CATALYTIC REDUCTION;

AMMONIA; CATALYSTS; CONVERSION EFFICIENCY; DIESEL ENGINES; ESTIMATION; METABOLISM; SENSORS; UREA;

SELECTIVE CATALYTIC REDUCTION;

EID: 79955987145     PISSN: 12299138     EISSN: None     Source Type: Journal    
DOI: 10.1007/s12239-011-0038-4     Document Type: Article

References (27)

1. Chi, J. N. and DaCosta, H. F. M. (2005). Modeling and control of a urea-SCR aftertreatment system. Proc. 2005 SAE World Cong., SAE Paper No. 2005-01-0966.
2. Drakunov, S. V. (1992). Sliding-mode observers based on equivalent control method. Proc. 31th Conf. Decision and Control.
3. Drakunov, S. V. and Utkin, V. (1995). Sliding mode observers tutorial. Proc. 34th Conf. Decision and Control.
4. Grossale, A., Nova, I., Tronconi, E., Chatterjee, D. and Weibel, M. (2008). The chemistry of the NO/NO2-NH3 "fast" SCR reaction over Fe-ZSM5 investigated by transient reaction analysis. J. Catalysts, 256, 312-322.
5. Herman, A., Wu, M., Cabush, D. and Shost, M. (2009). Model based control of SCR dosing and OBD strategies with feedback from NH3 sensors. Proc. SAE 2009 World Cong., SAE Paper No. 2009-01-0911.
6. x trap regenerations. ASME Trans. J. Dynamic Systems, Measurement, and Control132, 4, 13.
7. x trap regenerations. SAE Int. J. Fuels and Lubricants2, 1, 149-157.
8. Hsieh, M. and Wang, J. (2011a). A two-cell backstepping based control strategy for diesel engine selective catalytic reduction systems. IEEE Trans. Control Systems Technology (in press), (DOI: 10. 1109/TCST. 2010. 2098477).
9. Hsieh, M. and Wang, J. (2009). Backstepping based nonlinear ammonia surface coverage ratio control for diesel engine selective catalytic reduction systems. Proc. ASME Dynamic Systems and Control Conf.
10. Hsieh, M.-F. (2010). Control of Diesel Engine Urea Selective Catalytic Reduction Systems. Ph. D. Dissertation. Ohio State University.
11. x concentration estimator in selective catalytic reduction system applications. Control Engineering Practice (in press), (DOI: 10. 1016/j. conengprac. 2010. 12. 002).
12. Hsieh, M. F. and Wang, J. (2011b). Development and experimental studies of a control-oriented SCR model for a two-catalyst urea-SCR system. Control Engineering Practice (in press), (DOI: 10. 1016/j. conengprac. 2011. 01. 004).
13. Hsieh, M. F. and Wang, J. (2010). Observer-based estimation of selective catalytic reduction (SCR) catalyst ammonia storage. J. Automobile Engineering, Proc. Institution of Mechanical Engineers, Part D, 224, 9, 1199-1211.
14. Jung, S., Ishida, M., Yamamoto, S., Ueki, H. and Sakaguchi, D. (2010). Enhancement of NOx-PM trade-off in a diesel engine adopting bio-ethanol and EGR. Int. J. Automotive Technology11, 5, 611-616.
15. Kim, J. Y., Ryu, S. H. and Ha, J. S. (2004). Numerical prediction on the characteristics of spray-induced mixing and thermal decomposition of urea solution in SCR system. Proc. ASME Internal Combustion Engine Division.
16. Lee, S. J., Jeong, S. J., Kim, W. S. and Lee, C. B. (2008). Computational study on the effects of volume ratio of DOC/DPF and catalyst loading on the PM and NOx emission control for heavy-duty diesel engines. Int. J. Automotive Technology9, 6, 659-670.
17. Piazzesi, G., Devadas, M., Krocher, O., Elsener, M. and Wokaun, A. (2006). Isocyanic acid hydrolysis over Fe-ZSM5 in urea-SCR. Catalyst Communications7, 8, 600-603.
18. Schar, C. M., Onder, C. H. and Geering, H. P. (2006). Control of an SCR catalyst converter system for a mobile heavy-duty application. IEEE Trans. Control System Technology14, 4, 641-652.
19. Shimizu, K. and Satsuma, A. (2007). Hydrogen assisted urea-SCR and NH3-SCR with silver-alumina as highly active and SO2-tolerant de-NOx catalysis. Applied Catalysis B: Environmental, 77, 202-205.
20. Song, Q. and Zhu, G. (2002). Model-based closed-loop control of urea SCR exhaust aftertreatment system for diesel engine. Proc. SAE 2002 World Cong., SAE Paper No. 2002-01-0287.
21. Upadhyay, D. and van Nieuwstadt, M. (2006). Model based analysis and control design of a urea-SCR deNOx aftertreatment system. ASME J. Dynamic Systems, Measurement, and Control, 128, 737-741.
22. Utkin, V., Guldner, J. and Shi, J. (1999). Sliding Mode Control in Electromechanical Systems. Taylor & Francis Inc. London.
23. Wang, J. (2008). Smooth in-cylinder lean-rich combustion switching control for diesel engine exhaust-treatment system regenerations. SAE Int. J. Passenger Cars - Electronic and Electrical Systems1, 1, 340-348.
24. Wang, D. Y., Yao, S., Shost, M., Yoo, J., Cabush, D., Racine, D., Cloudt, R. and Willems, F. (2009). Ammonia sensor for close-loop SCR control. SAE 2008 World Cong., SAE Int. J. Passenger Cars- Electronic and Electrical Systems1, 1, 323-333.
25. Way, P., Viswanathan, K., Preethi, P., Gilb, A., Zambon, N. and Blaisdell, J. (2009), SCR performance optimization through advancements in aftertreatment packaging. Proc. SAE 2009 World Cong., SAE Paper No. 2009-01-0633.
26. Willems, R., Cloudt, E. V. D., Eijnden, B. D., Jager, Boomsma, W. and Heuvel, I. V. D. (2007). Is closedloop SCR control required to meet future emission targets?. Proc. SAE 2007 World Cong., SAE Paper No. 2007-01-1574.
27. Yim, S. D., Kim, S. J., Baik, J. H., Nam, I., Mok, Y. S., Lee, J. H., Cho, B. K. and Oh, S. H. (2004). Decomposition of urea into NH3 for the SCR process. Ind. Eng. Chem. Res., 43, 4856-4862.