Experimental study on the effects of spray inclination on water spray cooling performance in non-boiling regime

Experimental Thermal and Fluid Science

Volumn 34, Issue 7, 2010, Pages 933-942

  Wang, Yaqing ^a   Liu, Minghou ^a   Liu, Dong ^a   Xu, Kan ^a   Chen, Yiliang ^a  

^a UNIVERSITY OF SCIENCE AND TECHNOLOGY OF CHINA   (China)

Author keywords

Inclination angle; Non boiling regime; Spray cooling

Indexed keywords

ATMOSPHERIC TEMPERATURE; COOLING; EFFICIENCY; HEAT TRANSFER; NUSSELT NUMBER; REYNOLDS NUMBER; SPRAY STEELMAKING; SURFACE PROPERTIES;

DIMENSIONAL TEMPERATURES; GENERALIZED CORRELATION; HEAT TRANSFER PERFORMANCE; INCLINATION ANGLES; NON-BOILING REGIME; SATURATION TEMPERATURE; SPRAY COOLING; UTILIZATION EFFICIENCY;

HEAT FLUX;

EID: 77955936837     PISSN: 08941777     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.expthermflusci.2010.02.010     Document Type: Article

References (26)

1. C.H. Amon, J. Murthy, S.C. Yao, S. Narumanchi, C.-F. Wu, C.-C. Hsieh, MEMS-enabled thermal management of high-heat-flux devicesEDIFICE: embedded droplet impingement for integrated cooling of electronics, Exp. Therm. Fluid Sci. 25 (2001) 231-242.
2. M. Visaria, I. Mudawar, Theoretical and experimental study of the effects of spray inclination on two-phase spray cooling and critical heat flux, Heat and Mass Transf. 51 (2007) 2398-2410.
3. I. Mudawar, Assessment of high-heat-flux thermal management schemes, IEEE Trans. Compon. Packag. Technol. 24 (2001) 122-141.
4. J. Yang, L.C. Chow, M.R. Pais, Nucleate boiling heat transfer in spray cooling, ASME J Heat Transf. 118 (1996) 668-671.
5. S.V. Garimella, C.B. Sobhan, Transport in micro channels - a critical review, Annu. Rev. Heat Transf. 13 (2003) 1-50.
6. L.C. Chow, M.S. Sehembey, M.R. Pais, High heat flux spray cooling, Annu. Rev. Heat Transf. 8 (1997) 291-318.
7. K. Oliphant, B.W. Webb, M.Q. McQuay, An experimental comparison of liquid jet array and spray impingement cooling in the nonboiling regime, Exp. Therm. Fluid Sci. 18 (1998) 1-10.
8. J. Kim, Spray cooling heat transfer: the state of the art, Int. J. Heat Fluid Flow 28 (2007) 753-767.
9. D.P. Rini, R.-H. Chen, L.C. Chow, Bubble behavior and nucleate boiling heat transfer in saturated FC-72 spray cooling, J. Heat Transf. 124 (2002) 63-72.
10. R.H. Chen, L.C. Chow, J.E. Navedo, Effects of spray characteristics on critical heat flux in subcooled water spray cooling, Int. J. Heat Mass Transf. 45 (2002) 4033-4043.
11. R.H. Chen, L.C. Chow, J.E. Navedo, Optimal spray characteristic in water spray cooling, Int. J. Heat Mass Transf. 47 (2004) 5095-5099.
12. K.A. Estes, I. Mudawar, Correlation of Sauter mean diameter and critical heat flux for spray cooling of small surfaces, Int. J. Heat Mass Transf. 38 (1995) 2985-2996.
13. I. Mudawar, K.A. Estes, Optimizing and predicting CHF in spray cooling of a square surface, J. Heat Transf. 118 (1996) 672-679.
14. E. Cabrera, J.E. Gonzalez, Heat flux correlation for spray cooling in the nucleate boiling regime, Exp. Heat Transf. 16 (2003) 19-44.
15. M. Visaria, I. Mudawar, Effects of high subcooling on two-phase spray cooling and critical heat flux, Heat Mass Transf. 51 (2008) 5269-5278.
16. I. Mudawar, K.A. Estes, Optimizing and predicting CHF in spray cooling of a square surface, J. Heat Transf. 118 (1996) 672-680.
17. E. Silk, J. Kim, K. Kiger, Investigation of enhanced surface spray cooling, in: Proceedigs of IMECE 2004, Anaheim, USA, 2004.
18. B.Q. Li, T. Cader, J. Schwarzkopf, K. Okamoto, B. Ramaprian, Spray angle effect during spray cooling of microelectronics: experimental measurements and comparison with inverse calculations, Appl. Therm. Eng. 26 (2006) 1788-1795.
19. T.A. Shedd, A.G. Pautsch, Full Coverage Spray Drainage System and Method for Orientation-Independent Removal of High Heat Flux. US Patent Pending, 2005.
20. E.A. Silk, J. Kim, K. Kiger, Spray cooling of enhanced surfaces: impact of structured surface geometry and spray axis inclination, Int. J. Heat Mass Transf. 49 (2006) 4910-4920.
21. K. Nitin, R.K. Sunil, P.M.V. Subbarao, Experimental study of non-boiling heat transfer from a horizontal surface by water sprays, Exp. Therm. Fluid Sci. 32 (2007) 571-579.
22. E.A. Silk, Investigation into enhanced surface spray cooling, Ph.D. Dissertation, School of Mechanical Engineering, University of Maryland, College Park, MD, 2006.
23. S. Kim, S. Kiger, Spray cooling of high aspect ratio open microchannels, J. Heat Transf. 129 (2007) 1052-1059.
24. W. Jia, H.-H. Qiu, Experimental investigation of droplet dynamics and heat transfer in spray cooling, Exp. Therm. Fluid Sci. 27 (2003) 829-838.
25. J.D. Bernardin, I. Mudawar, Film boiling heat transfer of droplet streams and sprays, Int. J. Heat Mass Transf. 40 (1997) 2579-2593.
26. K.J. Choi, S.C. Yao, Mechanism of film boiling heat transfer of normally impacting spray, Int. J. Heat Mass Transf. 30 (1987) 311-318.