HIGH HEAT FLUX SPRAY COOLING

Annual Review of Heat Transfer

Volumn 8, Issue , 1997, Pages 291-318

  Chow, Louis C ^a   Sehmbey, Maninder S ^a   Pais, Martin R ^a  

^a NONE

Author keywords

[No Author keywords available]

Indexed keywords

COOLING; SPRAY STEELMAKING;

'CURRENT; COOLING TECHNIQUE; HEAT TRANSFER PROCESS; HIGH HEAT FLUX; SPRAY-COOLING;

HEAT FLUX;

EID: 85162896640     PISSN: 10490787     EISSN: 23750294     Source Type: Book Series    
DOI: 10.1615/AnnualRevHeatTransfer.v8.80     Document Type: Chapter

References (33)

1. S. Deb and S. C. Yao, Heat Transfer Analysis of Impacting Dilute Spray on Surfaces Beyond the Leidenfrost Temperature, ASME National Heat Transfer Conf., Pittsburgh, PA, paper # 87-HT-l, 1987.
2. S. C. Yao, Dynamics of Heat Transfer of Impacting Sprays, Annu. Rev. Heat Transfer, Vol. 5, pp. 351-382, 1994.
3. A. H. Lefebvre, Atomization Sprays, Chap., Hemisphere, New York, 1989.
4. J. Yang, L. C. Chow, and M. R. Pais, Nucleate Boiling Heat Transfer in Spray Cooling, 29th ASME/AIChE National Heat Transfer Conf., Atlanta, GA, ASME Paper # 93-HT-29, 1993.
5. A. Ashgriz and S. C. Yao, Development of a Controlled Spray Generator, Rev. Sci. lnstrumentaion, Vol. 58(7), pp. 1291-1296, 1987.
6. K. J. Choi and S. C. Yao, Mechanism of Film Boiling Heat Transfer of Normally Impacting Spray, Int. J. Heat Mass Transfer, Vol. 30(2), pp. 311-318, 1987.
7. C. Bonacina, S. Del Giudice, and G. Comini, Dropwise Evaporation, J. Heat Transfer, Vol. 101, pp. 441-46, 1979.
8. C. Bonacina, G. Comini, and S. Del Giudice, Evaporation of Atomized Liquids on Hot Surfaces, Lett. Heat Mass. Transfer, Vol. 2, pp. 401-406, 1975.
9. M. R. Pais, L. C. Chow, and E. T. Mahefkey, Surface Roughness and Its Effects on the Heat Transfer Mechanism in Spray Cooling, J. HeatTransfer, Vol. 114, pp. 211-219, 1992.
10. D. E. Tilton, Spray Cooling, Ph.D. dissertation, Univ. of Kentucky, Lexington, KY, 1989.
11. W. M. Rohsenow, Boiling, Handbook of Heat Transfer Fundamentals, W. M. Rohsenow, J. P. Hartnett, and E. N. Gani'c, Eds., 2nd ed., McGraw-Hill, New York, 12, 1985.
12. M. S. Sehmbey, M. R. Pais, and L. C. Chow, Effect of Surface Material Properties and Surface Characteristics in Evaporative Spray Cooling, J. Thermophys. Heat Transfer, Vol. 6, No. 3, pp. 505-512, 1992.
13. M. S. Sehmbey, L. C. Chow, O. J. Hahn, and M. R. Pais, Spray Cooling of Power Electronics at Cryogenic Temperatures, J. Thermophys. Heat Transfer, Vol. 9(1), pp. 123-128, 1995.
14. M. S. Sehmbey, L. C. Chow, O. J. Hahn, and M. R. Pais, Effect of Spray Characteristics on Spray Cooling with Liquid Nitrogen, J. Thermophys. Heat Transfer, accepted for publication, to appear in late 1995.
15. C. S. K. Cho and K. Wu, ©Comparison of Burnout Characteristics of Jet Impingement Cooling and Spray Cooling, National Heat Transfer Conf., Houston, HTD-Vol. 96, pp. 561-567, 1988.
16. S. C. Yao, S. Deb, and N. Hammouda, Impacting Sprays Boiling for Thermal Control of Electronic Systems, Heat Transfer in Electronics 1989, ASME, HTD-Vol. I l l, pp. 129-134, 1989.
17. M. Monde, Critical Heat Flux in the Saturated Forced Convection Boiling on a Heated Disk with Impinging Droplets, Heat Transfer - Jpn. Res., Vol. 8, pp. 54-64, 1979.
18. J. Yang, Spray Cooling with an Air Atomizing Nozzle, Ph.D. Dissertation, University of Kentucky, Lexington, K Y, 1993.
19. V. A. Grigor'ev, and A. S. Dudkevich, Boiling Cryogenic Liquid in a Thin Film, Teploenergetica, Vol. 17, No. 12, pp. 54-57, 1970.
20. M. Ghodbane and J. P. Holman, Experimental Study of Spray Cooling with Freon-113, Int. J. Heat Transfer, Vol. 34(4/5), pp. 1163-1174, 1991.
21. M. S. Sehmbey, M. R. Pais, R. and L. C. Chow, A Study of Diamond Laminated Surfaces in Evaporative Spray Cooling, Thin Solid Films, Vol. 212, pp. 25-29,1992.
22. J. Yang, L. C. Chow, and M. R. Pais, An Analytical Method to Determine the Liquid Film Thickness Produced by Gas Atomized Sprays, 29th ASME/AIChE National Heat Transfer Conf., Atlanta, GA, 1993.
23. X. Q. Chen, L. C. Chow, and M. S. Sehmbey, Thickness of Film Produced by a Pressure Atomizing Nozzle, 30th AIAA Thermophysics and Heat Transfer Conference, San Diego, CA, paper # AIAA-95-2103, 1995.
24. K. Nishikawa, H. Kusuda, K. Yamasaki, and K. Tanaka, Nucleate Boiling at Low Levels, Bulletin ofJSME, Vol. 10(38), pp. 328-338, 1967.
25. P. J. Marto, D. K. Mackenzie, and A. D. Rivers, Nucleate Boiling in Thin Liquid Films, AIChE Symposium Series, Vol. 73(164), pp. 228-235, 1977.
26. R. Mesler and G. Mailen, Nucleate Boiling in Thin Liquid Films, AIChE Journal, Vol. 23, No. 6, pp. 954-957, 1977.
27. M. G. Cooper and J. P. Lloyd, Transient Local Heat Flux in Nucleate Boiling, Proceedings of the 3rd International Heat Transfer Conference, Chicago, Vol. 3, pp. 193-203, 1966.
28. I. A. Kopchikov, G. I. Voronin, T. A. Kolach, D. A. Labuntsov, and P. D. Lebedev, Liquid Boiling in a Thin Film, Int. J. Heat Transfer, Vol. 12, pp. 791-796, 1969.
29. Y. Haramura and Y. Katto, A New Hydrodynamic Model of Critical Heat Flux Applicable Widely to Both Pool and Forced Convection Boiling on Submerged Bodies in Saturated Liquids, Int. J. Heat Mass Transfer, Vol. 26(2), pp. 389-399, 1983.
30. T. Kumada and H. Sakashita, Proposed Model for Kutateladze Correlation and New Correlation of CHF, Pool and External Flow Boiling, V. K. Dhir and A. E. Bergles, Eds., ASME Press, New York, pp. 177-183, 1992.
31. A. K. Rajvanshi, J. S. Saini, and R. Prakash, Investigation of Macrolayer Thickness in Pool Boiling at High Heat Flux, Int. J. Heat Mass Transfer, Vol. 35, pp. 343-350, 1992.
32. S. Toda, A Study of Mist Cooling. 1st Report: Investigation of Mist Cooling, Heat Transfer Jpn. Res., Vol. 1(3), pp. 39-50, 1972.
33. L. C. Chow, M. S. Sehmbey, and M. R. Pais, Critical Heat Flux in High Heat Flux Spray Cooling, Symposium on Thermal Science and Engineering in Honor of Chancellor Chang-Lin Tien, San Francisco, CA, 1995.