Two component silicone modified epoxy foul release coatings: Effect of modulus, surface energy and surface restructuring on pseudobarnacle and macrofouling behavior

Applied Surface Science

Volumn 256, Issue 8, 2010, Pages 2440-2446

  Rath, S K ^a   Chavan, J G ^a   Sasane, Savita ^a   Jagannath, ^b   Patri, M ^a   Samui, A B ^a   Chakraborty, B C ^a  

^a NAVAL MATERIALS RESEARCH LABORATORY   (India)

^b BHABHA ATOMIC RESEARCH CENTRE   (India)

Author keywords

Foul release; Low surface energy; Macrofouling; Pseudobarnacle

Indexed keywords

ADHESION; ATOMIC FORCE MICROSCOPY; CONTACT ANGLE; DYNAMIC MECHANICAL ANALYSIS; EPOXY RESINS; FOULING; GONIOMETERS; INTERFACIAL ENERGY; SILICONES; SURFACE TOPOGRAPHY; WETTING; X RAY PHOTOELECTRON SPECTROSCOPY;

ADVANCING AND RECEDING CONTACT ANGLES; ANGLE RESOLVED X RAY PHOTOELECTRON SPECTROSCOPY; CONTACT ANGLE GONIOMETRY; FOUL-RELEASE COATINGS; LOW SURFACE ENERGY; MACROFOULING; PSEUDOBARNACLE; SURFACE RESTRUCTURING;

SILICONE COATINGS;

EID: 74249095938     PISSN: 01694332     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.apsusc.2009.10.084     Document Type: Article

References (25)

1. Townsin R.L. The ship hull fouling penalty. Biofouling 19 (2003) 9-15
2. Rascio V.J.D. Antifouling coatings: where do we go from here. Corr. Rev. 18 2 (2000) 133-154
3. Yebra D.M., Kill S., and Dam-Johansen K. Antifouling technology - past, present and future - steps towards efficient and environment friendly antifouling coatings. Prog. Org. Coat. 50 (2004) 75-104
4. Callow M.E., and Fletcher R.L. The influence of low surface energy materials on bioadhesion-a review. Int. Biodeterior. Biodegrad. 34 (1994) 333-348
5. Majumdar P., Elkins A., and Webster D.C. Thermoset siloxane urethane foul release coatings. ACS Symp. Ser. 957 (2007) 61-75
6. Genzer J., and Efimenko K. Recent developments in superhydrophobic surfaces and their relevance to marine fouling: a review. Biofouling 22 5 (2006) 339-360
7. Swain G.E. Redefining antifouling coatings. Prot. Coat. Eur. 4 (1999) 18-25
8. Schultz M.P., Finlay J.A., Callow M.E., and Callow M.J.A. A turbulent flow channel for the determination of adhesion strength of microfouling organisms. Biofouling 15 (2000) 243-251
9. Kohl J.G., and Singer I.L. Pull off behaviour of epoxy bonded to silicone duplex coatings. Prog. Org. Coat. 36 (1999) 15-20
10. Brady Jr. R.F. A fracture mechanical analysis of fouling release from nontoxic antifouling coatings. Prog. Org. Coat. 43 (2001) 188-192
11. Brady Jr. R.F. Properties which influence fouling release in polymers containing silicone and fluorine. Prog. Org. Coat. 35 (1999) 31-35
12. Adkins J.D., Mera A.E., Roe-Short M.A., Pawlikowski G.T., and Brady Jr. R.F. Novel non toxic coatings designed to resist marine fouling. Prog. Org. Coat. 29 2 (1996) 1-5
13. Ekin A., and Webster D.C. Combinatorial and high throughput screening of the effect of siloxane composition on the surface properties of crosslinked siloxane-polyurethane coatings. J. Comb. Chem. 9 (2007) 178-188
14. Ananda Kumar S., Balakrishnan T., Alagar M., and Denchev Z. Development and characterization of silicone/phosphorous modified epoxy materials and their application in anticorrosion and antifouling coatings. Prog. Org. Coat. 55 (2006) 207-217
15. Rath S.K., Chavan J.G., Sasane S., Srivastava A., Patri M., Samui A.B., Chakraborty B.C., and Sawant S. Coatings of silicone modified epoxy via urethane linkage: segmental correlation length, phase morphology, thermomechanical and surface behavior. Prog. Org. Coat. 65 (2009) 366-374
16. Wu S. Polymer Interface and Adhesion (1982), Marcel Dekker, New York
17. Pike J.K., Ho T., and Wynne J. Water induced surface rearrangements of poly (dimethylsiloxane-urea-urethane) segmented block copolymers. Chem. Mater. 8 4 (1996) 850-860
18. Bar G., Thonnan Y., Brandesh R., and Cantow H.J. Factors affecting the height and phase images in tapping mode atomic force microscopy: study of phase separated polymer blends of poly(ethane-co-styrene) and poly(2,6 dimethyl-1,4-phenylene oxide). Langmuir 13 (1997) 3807-3812
19. Kendall K. The adhesion and surface energy of elastic solids. J. Phys. D: Appl. Phys. 4 (1971) 1186-1195
20. Stein J., Truby K., Wood C.D., Takemori M., Vallance M., Swain G., Kavanagh C., Kovach B., Schultz M., Wiebe D., Holm E., Montemarano J., Wendt D., Smith C., and Meyer A. Structure-property relationships of silicone biofouling-release coatings: effect of silicone network architecture on pseudobarancale attachment strengths. Biofouling 19 (2003) 87-94
21. Johnson Jr. R.E., and Dettre R.H. In: Berg J.C. (Ed). Wettability (1993), Marcel Dekker, New York 1-73
22. Ratner B.D., Weathersby P.K., Hoffman A.S., Kelly M.A., and Scharpen L.H. Radiation grafted hydrogels for biomedical application as studied by ESCA technique. J. Appl. Polym. Sci. 22 (1978) 643-664
23. Lee S.H., and Ruckenstein E. Surface restructuring of polymers. J. Coll. Interface Sci. 120 (1987) 529-536
24. Tezuka Y., Ono T., and Imai K. Environmentally induced macromolecular rearrangement on the surface of polyurethane-polysiloxane graft copolymer. J. Coll. Interface Sci. 136 (1990) 408-411
25. Tezuka Y., and Imai K. Environmentally induced macromolecular rearrangement on the surface of polyurethane-polysiloxane block copolymer. J. Chem. Soc. Faraday Trans. 87 (1991) 147-152