Simulation of contaminates around the solid immersion lens in a near-field optical recording system

IEEE Transactions on Magnetics

Volumn 43, Issue 3, 2007, Pages 1086-1092

  Terrell, Elon ^a   Higgs III, C Fred ^a  

^a CARNEGIE MELLON UNIVERSITY   (United States)

Author keywords

Near field recording; Participate contamination; Solid immersion lens

Indexed keywords

COMPUTER SIMULATION; HYDRODYNAMICS; IMPURITIES; INTERFACES (COMPUTER); MATHEMATICAL MODELS; OPTICAL DATA STORAGE; OPTICAL RECORDING;

NEAR-FIELD RECORDING; PARTICIPATE CONTAMINATION; SOLID IMMERSION LENS;

MAGNETIC LENSES;

EID: 33847717866     PISSN: 00189464     EISSN: None     Source Type: Journal    
DOI: 10.1109/TMAG.2006.888697     Document Type: Article

References (16)

1. F. Zijp, M. B. Van Der Mark, J. 1. Lee, C. A. Verschuren, B. H. W. Hendriks, M. L. M. Balistreri, H. P. Urbach, M. A. H. Van Der Aa, and A. V. PadiyF. Zijp, M. B. Van Der Mark, J. I. Lee, C. A. Verschuren, B. H. W. Hendriks, M. L. M. Balistreri, H. P. Urbach, M. A. H. Van Der Aa, and A. V. Padiy, "Near field read-out of a 50 GB first-surface disk with NA = 1.9 and a proposal for a cover-layer incident, dual-layer near field system," in Proc. Optical Data Storage 2004, Monterey, CA, Apr. 18-21, 2004, pp. 209-223.
2. T. Ishimoto, K. Saito, M. Shinoda, T. Kondo, A. Nakaoki, and M. Yamamoto, "Gap servo system for a biaxial device using an optical gap signal in a near field readout system," Jpn. J. Appl. Phys. Part 1: Regular Papers and Short Notes and Review Papers, vol. 42, pp. 2719-2724, 2003.
3. S. J. Yoon, J. Lee, Y. P. Park, and D. H. Choi, "Design of optical flying head for magnetooptical recording," IEEE Trans. Magn., vol. 41, no. 10, pp. 2851-2853, Oct. 2005.
4. F. Zijp, M. van der Mark, C. Verschuren, J. Lee, J. van den Eerenbeemd, P. Urbach, and M. van der AA, "High-density near-field optical recording with a solid immersion lens, conventional actuator, and a robust air gap servo," IEEE Trans. Magn., vol. 41, no. 2, pp. 1042-1046, Feb. 2005.
5. S. C. Lin, T. C. Kuo, and C. C. Chieng, "Particle trajectories around a flying slider," Trans. ASME, J. Tribol., vol. 120, pp. 69-74, 1998.
6. X. Shen and D. B. Bogy, "Particle flow and contamination in slider air bearings for hard disk drives," J. Tribol., vol. 125, pp. 358-363, 2003.
7. Q. H. Zeng, R. Pit, R. Payne, P. Baumgart, and F. Y. Huang, "Modeling and simulation of hard-particle interaction in head/disk interfaces," IEEE Trans. Magn., vol. 41, no. 2, pp. 604-609, Feb. 2005.
8. J. A. Roberson and C. T. Crowe, Engineering Fluid Mechanics. New York: Wiley, 1997.
9. Fluent 6.2 User's Guide. Lebanon, NJ: Fluent, Inc., 2005.
10. S. V. Patankar and D. B. Spalding, "A calculation procedure for heat, mass, and momentum transfer in three dimensional parabolic flows," Int. J. Heat Mass Transfer, vol. 15, p. 1787, 1972.
11. J. D. Anderson, Computational Fluid Dynamics: The Basics with Applications. New York: McGraw-Hill, 1995.
12. S. Zhang and D. B. Bogy, "Effects of lift on the motion of particles in the recessed regions of a slider," Phys. Fluids, vol. 9, p. 1265, 1997.
13. E. J. Terrell, V. K. Jasti, and C. F. Higgs III, "Modeling the motion of slurry nanoparticles during chemical mechanical polishing," in Proc. Int. Mechanical Engineering Congr. Expo., Orlando, FL, 2005.
14. E. J. Terrell, J. I. Garcia, and C. F. Higgs III, "Two-phase hydrodynamic modeling of particulate fluids in sliding contacts," in Proc. World Tribology Conf., 2005.
15. E. J. Terrell and C. F. Higgs III, "A modeling approach for predicting the abrasive particle motion during chemical mechanical polishing," J. Tribol., 2007, accepted for publication.
16. T. Ishimoto, T. Ito, M. Shinoda, K. Saito, T. Kondo, T. Matsui, S. Kim, A. Nakaoki, and M. Yamamoto, "Head analysis in air flow on near-field optical disk system with 2-axis actuator," Jpn. J. Appl. Phys., Part 1: Regular Papers and Short Notes and Review Papers, vol. 44, pp. 3410-3411, 2005.