Non-Newtonian and running-in wear effects in journal bearings operating under mixed lubrication

Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology

Volumn 230, Issue 2, 2016, Pages 135-142

  Allmaier, H ^a   Sander, D E ^a   Priebsch, H H ^a   Witt, M ^b   Fullenbach T ^b   Skiadas, A ^b  

^a VIRTUAL VEHICLE RESEARCH CENTER   (Austria)

^b KS Gleitlager GmbH   (Germany)

Author keywords

Friction; journal bearing; measurement; mixed lubrication; running in; simulation

Indexed keywords

DYNAMIC LOADS; FRICTION; JOURNAL BEARINGS; MEASUREMENTS; NON NEWTONIAN FLOW;

DYNAMICALLY LOADED JOURNAL BEARING; LUBRICATION CONDITION; METAL-METAL CONTACTS; MIXED LUBRICATION; PIEZOVISCOUS EFFECTS; RUNNING-IN; SIMULATION; SIMULATION APPROACH;

LUBRICATION;

EID: 84954349913     PISSN: 13506501     EISSN: 2041305X     Source Type: Journal    
DOI: 10.1177/1350650115594191     Document Type: Article

References (22)

1. Sommerfeld A,. Zur hydrodynamischen Theorie der Schmiermittelreibung. Z Math Phys 1904; 50 (97): 155-155.
2. Wang Y, Zhang C, Wang Q, Lin C,. A mixed-TEHD analysis and experiment of journal bearings under severe operating conditions. Tribol Int 2002; 35 (6): 395-407.
3. Allmaier H, Priestner C, Reich F, Priebsch H, Novotny-Farkas F,. Predicting friction reliably and accurately in journal bearings-extending the simulation model to TEHD. Tribol Int 2013; 58: 20-28.
4. Blau PJ,. On the nature of running-in. Tribol Int 2006; 38 (11): 1007-1012.
5. Abbot E, Firestone F,. Specifying surface quality. Mech Eng 1933; 55: 569-569.
6. McKee S,. The effect of running-in on journal bearing performance. Mech Eng 1927; 49 (12): 1335-1340.
7. Durak E, Adatepe H, Biyiklioglu A,. Experimental study of the effect of additive on the tribological properties journal bearing under running-in and start-up or shut-down stages. Indust Lub Tribol 2008; 60 (3): 138-146.
8. Sander D, Allmaier H, Priebsch H, et al. Impact of high pressure and shear thinning on journal bearing friction. Tribol Int 2005; 81: 29-37.
9. Allmaier H, Priestner C, Six C, Priebsch H, Forstner C, Novotny-Farkas F,. Predicting friction reliably and accurately in journal bearings-a systematic validation of simulation results with experimental measurements. Tribol Int 2011; 44 (10): 1151-1160.
10. Allmaier H, Priestner C, Sander D, Reich F, Friction in automotive engines. In: Pihtili H, (ed). Tribology in engineering 2013 Intech.
11. Allmaier H, Priestner C, Reich F, Priebsch H, Forstner C, Novotny-Farkas F,. Predicting friction reliably and accurately in journal bearings-the importance of extensive oil-models. Tribol Int 2012; 48: 93-101.
12. Morina A, Neville A,. Understanding the composition and low friction tribofilm formation/removal in boundary lubrication. Tribol Int 2007; 40 (10-12): 1696-1704.
13. Greenwood J, Tripp J,. The contact of two nominally flat rough surfaces. Proc IMechE 1970; 185 (1): 625-633.
14. Priestner C, Allmaier H, Priebsch H, Forstner C,. Refined simulation of friction power loss in crank shaft slider bearings considering wear in the mixed lubrication regime. Tribol Int 2012; 46 (1): 200-207. DOI: 10.1016/j.triboint.2011.03.012.
15. Offner G,. Friction power loss simulation of internal combustion engines considering mixed lubricated radial slider, axial slider and piston to liner contacts. Tribol Trans 2013; 56 (3): 503-515.
16. Stambaugh R, Kopko R and Bennett P. The relationship of journal bearing wear to multigrade engine oil viscometric properties, SAE Technical Paper 770627. DOI: 10.4271/770627.
17. Vogel H,. The law of the relation between the viscosity of liquids and the temperature. Phys Z 1921; 22: 645-646.
18. Barus C,. Isothermals, isopiestics and isometrics relative to viscosity. Am J Sci 1893; 266: 87-96.
19. Cross MM,. Rheology of non-Newtonian fluids: a new flow equation for pseudoplastic systems. J Colloid Sci 1965; 20 (5): 417-437.
20. Reynolds O,. On the theory of lubrication and its application to Mr. Beauchamp Tower's experiments, including an experimental determination of the viscosity of olive oil. Proc R Soc Lond 1886; 40 (242-245): 191-203.
21. Offner G,. Modelling of condensed flexible bodies considering non-linear inertia effects resulting from gross motions. Proc IMechE, Part K 2011; 225 (3): 204-219.
22. Nikolic N, Torovic T, Antonic Z,. A procedure for constructing a theoretical wear diagram of IC engine crankshaft main bearings. Mechanism Machine Theory 2012; 58: 120-136. DOI: 10.1016/j.mechmachtheory.2012.07.009.