Edge loading and running-in wear in dynamically loaded journal bearings

Tribology International

Volumn 92, Issue , 2015, Pages 395-403

  Sander, David E ^a   Allmaier, H ^a   Priebsch, H H ^a   Reich, F M ^a   Witt, M ^b   Skiadas, A ^b   Knaus, O ^c  

^a VIRTUAL VEHICLE RESEARCH CENTER   (Austria)

^b KS Gleitlager GmbH   (Germany)

^c AVL LIST GMBH   (Austria)

Author keywords

Measurement; Mixed lubrication; Non Newtonian lubricant; Simulation

Indexed keywords

DIESEL ENGINES; DYNAMIC LOADS; END EFFECTORS; GEOMETRY; JOURNAL BEARINGS; LUBRICATION; MEASUREMENTS; METALS; NON NEWTONIAN FLOW; SOLID LUBRICANTS;

ASPERITY CONTACT PRESSURE; AUTOMOTIVE LUBRICANTS; CIRCUMFERENTIAL DIRECTION; DYNAMICALLY LOADED JOURNAL BEARING; HYDRODYNAMIC JOURNAL BEARINGS; MIXED LUBRICATION; NON NEWTONIAN LUBRICANTS; SIMULATION;

SURFACE ROUGHNESS;

EID: 84938917590     PISSN: 0301679X     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.triboint.2015.07.022     Document Type: Article

References (28)

1. P.J. Blau On the nature of running-in Tribol Int 38 11 2006 1007 1012
2. G. Rowe, H. Kaliszer, G. Trmal, and A. Cotter Running-in of plain bearings Wear 34 1 1975 1 14
3. M. Mokhtar, R. Howarth, and P. Davies Wear characteristics of plain hydrodynamic journal bearings during repeated starting and stopping ASLE Trans 20 3 1977 191 194
4. G. Masouros, A. Dimarogonas, and K. Lefas A model for wear and surface roughness transients during the running-in of bearings Wear 45 3 1977 375 382
5. S. Roy Chowdhury, H. Kaliszer, and G. Rowe An analysis of changes in surface topography during running-in of plain bearings Wear 57 2 1979 331 343
6. E. Durak, H. Adatepe, and A. Biyiklioglu Experimental study of the effect of additive on the tribological properties journal bearing under running-in and start-up or shut-down stages Ind Lubr Tribol 60 3 2008 138 146
7. J. Bouyer, and M. Fillon An experimental analysis of misalignment effects on hydrodynamic plain journal bearing performances J Tribol 124 2 2002 313 319
8. S. Boedo, and J. Booker Classical bearing misalignment and edge loading: a numerical study of limiting cases J Tribol 126 3 2004 535 541
9. J. Sun, and G. Changlin Hydrodynamic lubrication analysis of journal bearing considering misalignment caused by shaft deformation Tribol Int 37 10 2004 841 848
10. J. Sun, C. Gui, and Z. Li An experimental study of journal bearing lubrication effected by journal misalignment as a result of shaft deformation under load J Tribol 127 4 2005 813 819
11. C. Priestner, H. Allmaier, H. Priebsch, and C. Forstner Refined simulation of friction power loss in crank shaft slider bearings considering wear in the mixed lubrication regime Tribol Int 46 1 2012 200 207
12. H. Allmaier, C. Priestner, C. Six, H. Priebsch, C. Forstner, and F. Novotny-Farkas Predicting friction reliably and accurately in journal bearings - a systematic validation of simulation results with experimental measurements Tribol Int 44 10 2011 1151 1160
13. D. Sander, H. Allmaier, H. Priebsch, F. Reich, M. Witt, T. Füllenbach, and et al. Impact of high pressure and shear thinning on journal bearing friction Tribol Int 81 2015 29 37
14. G. Offner Friction power loss simulation of internal combustion engines considering mixed lubricated radial slider, axial slider and piston to liner contacts Tribol Trans 56 3 2013 503 515
15. H. Allmaier, C. Priestner, F. Reich, H. Priebsch, C. Forstner, and F. Novotny-Farkas Predicting friction reliably and accurately in journal bearings - the importance of extensive oil-models Tribol Int 48 2012 93 101
16. H. Allmaier, C. Priestner, F. Reich, H. Priebsch, and F. Novotny-Farkas Predicting friction reliably and accurately in journal bearings - extending the simulation model to TEHD Tribol Int 58 2013 20 28
17. H. Vogel The law of the relation between the viscosity of liquids and the temperature Phys Z 22 1921 645 646
18. C. Barus Isothermals, isopiestics and isometrics relative to viscosity Am J Sci 266 1893 87 96
19. M.M. Cross Rheology of non-Newtonian fluids: a new flow equation for pseudoplastic systems J Colloid Sci 20 5 1965 417 437
20. G. Offner Modelling of condensed flexible bodies considering non-linear inertia effects resulting from gross motions Proc Inst Mech Eng Part K: J Multi-body Dyn 225 3 2011 204 219
21. N. Patir, and H. Cheng An average flow model for determining effects of three-dimensional roughness on partial hydrodynamic lubrication ASME, Trans, J Lubr Technol 100 1978 12 17
22. N. Patir, and H. Cheng Application of average flow model to lubrication between rough sliding surfaces ASME, Trans, J Lubr Technol 101 1979 220 230
23. J. Greenwood, and J. Williamson Contact of nominally flat surfaces Proc R Soc Lond Ser A, Math Phys Sci 295 1966 300 319
24. J. Greenwood, and J. Tripp The contact of two nominally flat rough surfaces Proc Inst Mech Eng 185 1 1970 625 633
25. J. Archard Contact and rubbing of flat surfaces J Appl Phys 24 8 1953 981 988
26. L. Yang Wear coefficient equation for aluminium-based matrix composites against steel disc Wear 255 1 2003 579 592
27. Herbst H. Theoretical modeling of the cylinder lubrication in internal combustion engines and its influence on piston slap induced noise, friction and wear [Ph.D. thesis]. Technische Universität Graz, 2007.
28. Krasser J. Thermoelastohydrodynamische Analyse dynamisch belasteter Radialgleitlager [Ph.D. thesis]. Technische Universität Graz, 1996.