Design of a cantilever-based system for DNA detection

2011 7th Conference on Ph.D. Research in Microelectronics and Electronics, PRIME 2011 - Conference Proceedings

Volumn , Issue , 2011, Pages 61-64

  Adami, Andrea ^a   Borghetti, Fausto ^a   Massari, Nicola ^a   Decarli, Massimiliano ^a   Collini, Cristian ^a   Lorenzelli, Leandro ^a   Stoppa, David ^a  

^a FONDAZIONE BRUNO KESSLER   (Italy)

Author keywords

ASIC design; DNA biosensors; MEMS cantilevers

Indexed keywords

ASIC DESIGN; CMOS TECHNOLOGY; DETECTION SENSITIVITY; DETECTOR DESIGN; DETECTOR RESPONSE; DNA BIOSENSORS; DNA DETECTION; DNA HYBRIDISATION; ELECTRICAL MEASUREMENT; HIGH RESOLUTION; LABEL-FREE DETECTION; LOW NOISE; MICRO-FABRICATION TECHNOLOGY; MICROCANTILEVER ARRAYS; PIEZO-RESISTIVE; READOUT ASIC;

BIOSENSORS; CMOS INTEGRATED CIRCUITS; DESIGN; DNA; ENGINEERING RESEARCH; INTEGRATED CIRCUITS; MICROELECTRONICS; NANOCANTILEVERS;

DETECTORS;

EID: 80052218276     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1109/PRIME.2011.5966217     Document Type: Conference Paper

References (10)

1. P. S. Waggoner et al.-Micro- and nanomechanical sensors for environmental, chemical, and biological detection-Lab on a Chip 7 (2007), 1238-1255.
2. J. C. Stackowiak, et al.-Chemomechanics of surface stress induced by DNA hybridisation-Langmuir 22 (2006), 263-268.
3. J. Fritz et al. - Translating Biomolecular Recognition into Nanomechanics, Science, vol. 288 (2000), 316-318. (Pubitemid 30226188)
4. R. Mukhopadhyay et al.-Nanomechanical sensing of DNA sequences using piezoresistive cantilevers-Langmuir 21 (2005), 8400-8408.
5. A. Johansson et al., "SU-8 cantiler sensor system with integrated readout", Sensors and Actuators A, pp. 111-115, 123-124 2006.
6. D. Mark et al.-Microfluidic lab-on-a-chip platforms: requirements, characteristics and applications-Chemical Society Review 39 (2010), 1153-1182.
7. M. Grassi, "A 160dB rquivalent dynamic range auto-scaling interface for resistive gas sensor arrays", IEEE J. of Solid-State Circuits, pp.519-528, Vol.42, n.3, March 2007.
8. D. Rairigh et al., "Baseline resistance cancellation circuit for high resolution thiolate-monolayer-protected gold nanoparticle vapor sensor arrays", ISCAS 2008, pp. 2002-2005, Seattle, May 2008.
9. A.Flammini et al., "A low-cost interface to high-value resistive sensors varying over a wide range", IEEE Trans. On Instrumentation and Measurement, pp. 1052-1056, Vol.53, n.4, August 2004.
10. M. Malfatti et al., "A CMOS interface for gas sensor array with 0.5%-linearity over 500kΩ to 1GW range and ±2.50C temperature control accuracy", ISSCC 2006, San Francisco February 2006.