Low cost fabrication of microfluidic microchannels for Lab-On-a-Chip applications

2010 International Conference on Electronic Devices, Systems and Applications, ICEDSA 2010 - Proceedings

Volumn , Issue , 2010, Pages 242-244

  Bahadorimehr, A R ^a   Jumril, Yunas ^a   Majlis, B Yeop ^a  

^a INSTITUTE OF MICROENGINEERING AND NANOELECTRONICS IMEN   (Malaysia)

Author keywords

Glass; Lab On Chip; Micochannels; Microfluidics; PDMS; Wet etching

Indexed keywords

ANALYSIS SYSTEM; COST EFFECTIVE; DEPOSITION METHODS; GLASS SLIDES; LAB-ON-A-CHIP APPLICATIONS; LAB-ON-CHIP; LOW COST FABRICATION; MICOCHANNELS; MICRO FLUIDIC SYSTEM; MICRO TOTAL ANALYSIS SYSTEMS; MOLDING TECHNIQUES; PDMS; SMOOTH CHANNEL; VERTICAL WALL;

COST BENEFIT ANALYSIS; FABRICATION; GLASS; MICROCHANNELS; MICROFLUIDICS; THERMOELECTRIC EQUIPMENT;

WET ETCHING;

EID: 77955295007     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1109/ICEDSA.2010.5503067     Document Type: Conference Paper

References (7)

1. A. Mathur, S.S. Roy, M. Tweedie, S. Mukhopadhyay, S.K. Mitra and J.A. McLaughlin, "Characterisation of PMMA microfluidic channels and devices fabricated by hot embossing and sealed by direct bonding," Curr.Appl.Phys., vol. 9, pp. 1199-1202, 2009.
2. S. Natarajan, D.A. Chang-Yen and B.K. Gale, "Large-area, high-aspect-ratio SU-8 molds for the fabrication of PDMS microfluidic devices," J Micromech Microengineering, vol. 18, 2008.
3. S.M. Westwood, S. Jaffer, O.A. Lui and B.L. Gray, "Thick SU-8 and PDMS three-dimensional enclosed channels for free-standing polymer microfluidic systems," in 2007 Canadian Conference on Electrical and Computer Engineering, CCECD, pp. 12-15, 2007.
4. T. Fujii, "PDMS-based microfluidic devices for biomedical applications," Microelectron Eng, vol. 61-62, pp. 907-914, 16 September 2001 through 19 September 2001. 2002.
5. S. Xu, Y. Duan, Y. Ding and B. Lu, "New method for rapid fabricating masters of PDMS-based microfluidic devices," Jixie Gongcheng Xuebao, vol. 43, pp. 105-109, 2007.
6. C.-. Li, C.N. Cheung, J. Yang, C.H. Tzang and M. Yang, "PDMS-based microfluidic device with multi-height structures fabricated by single-step photolithography using printed circuit board as masters," Analyst, vol. 128, pp. 1137-1142, 2003.
7. A. Caboni, M. Barbaro, A. Homsy, P.D. Van Wal, V. Linder and N. De Rooij, "Integration of a microfluidic flow cell on a CMOS biosensor for DNA detection," in PRIME - 4th Ph.D. Research in Microelectronics and Electronics Conference 2008, pp. 121-124, 2008.