Analytical and numerical modelling of the direct metal deposition laser process

Journal of Physics D: Applied Physics

Volumn 41, Issue 2, 2008, Pages

  Peyre, P ^a   Aubry, P ^b   Fabbro, R ^a   Neveu, R ^a,d   Longuet, A ^c  

^a CNRS   (France)

^b GERAILP   (France)

^c CENTRE DES MATÉRIAUX   (France)

^d CNRS   (France)

Author keywords

[No Author keywords available]

Indexed keywords

DEPOSITION; ELECTRIC CONDUCTIVITY; FINITE ELEMENT METHOD; THERMAL LOAD; THERMOCOUPLES; TITANIUM ALLOYS;

CONTINUOUS LASER BEAMS; NUMERICAL MODELING; THERMAL CYCLES;

LASER BEAMS;

EID: 38049033859     PISSN: 00223727     EISSN: 13616463     Source Type: Journal    
DOI: 10.1088/0022-3727/41/2/025403     Document Type: Article

References (13)

1. Jouvard J M, Grevey D, Lemoine F and Vannes A B 1997 J. Laser Appl. 9 43-53
2. Huang Y L, Liu J, Ma N H and Li J G 2006 Three-dimensional analytical model on laser-powder interaction during laser cladding J. Laser Appl. 18 42-6
3. Qi H, Mazumder J and Ki H 2006 Numerical simulation of heat transfer and fluid flow in coaxial laser cladding process for direct metal deposition J. Appl. Phys. 100 4903
4. Toyserkani E, Khajepour A and Corbin S 2003 3D finite element modeling of laser cladding by powder injection: effects of powder feed rate and travel speed on the process J. Laser Appl. 15 153-60
5. Ladubovic M, Hu D and Kovacevic R 2003 A three dimensional model for direct metal powder deposition and rapid prototyping J. Mater. Sci. 38 35-49
6. Gosh S and Choi J 2006 Modeling and experimental validation of stresses and microstructure formation in multi-layer laser-aided DMD process J. Heat Transfer 128 662-79
7. Ye R et al 2006 Numerical modeling of the thermal behavior during the LENS process Mater. Sci. Eng. A 428 47-53
8. Han L, Phatak K M and Liu F W 2005 Modeling of laser deposition and repair process J. Laser Appl. 17 89-99
9. Alimardani M, Toyserkani E and Huisson J P 2007 3D numerical approach for geometrical prediction of multiplayer solid freeform fabrication process J. Laser Appl. 19 14-25
10. Peyre P, Aubry P, Braham C and Fabbro R 2006 Results on laser direct manufacturing of graded structures Proc. ICALEO'2006 Conf. (Scottsdale, USA)
11. Mokadem S 2004 Epitaxial laser treatement of single crystal nickel-base superalloys Thesis no 3127 Ecole Polytechnique Fédérale de Lausanne (Switzerland)
12. Kummailil J, Sammarco C, Skinner D, Brown C A and Rong K 2005 Effect of select LENS™ processing parameters on the deposition of Ti-6Al-4V J. Manuf. Process. 7 42-50
13. Qian L, Mei J, Liang L and Wu X 2005 Influence of position and laser power on thermal history and microstructure of direct laser fabricated Ti-6Al-4V samples Mater. Sci. Technol. 21 597-605