Analysis of morphology and performance of PP microstructures manufactured by micro injection molding

Microsystem Technologies

Volumn 14, Issue 2, 2008, Pages 209-214

  Zhang, K F ^a   Lu, Zhen ^a  

^a HARBIN INSTITUTE OF TECHNOLOGY   (China)

Author keywords

Micro injection molding; Morphology; PP Microstructures

Indexed keywords

CRYSTAL DEFECTS; INJECTION MOLDING; LIGHT POLARIZATION; MICROSTRUCTURE; SURFACE TOPOGRAPHY;

COLUMN CRYSTAL LAYER; INTERNAL DEFECT; MICRO INJECTION MOLDING (MIM);

POLYPROPYLENES;

EID: 35148841404     PISSN: 09467076     EISSN: None     Source Type: Journal    
DOI: 10.1007/s00542-007-0412-3     Document Type: Article

References (12)

1. Liou AC, Chen RH (2005) Injection molding of polymer micro- and sub-micron structures with high-aspect ratios. Int J Adv Manuf Technol 28:1097-1103
2. Kasanicka B, Muller M, Auhorn M et al (2006) Correlations between production process, states and mechanical properties of microstructures made of zirconia. Microsyst Technol 12:1133-1141
3. Gurhan K, Peter A, Michael BJ (1995) Microstructure and physical property control of injection moulded polypropylene. Plastics, Rubber Composites Pprocess Appl 23:71-85
4. Viana JC (2004) Development of the skin layer in injection moulding: phenomenological model. Polymer 45:993-10058
5. Ruprecht R, Gietzelt T, Miller K et al (2002) Injection molding of microstructured components from plastics, metals and ceramics. Microsyst Technol 8:351-358
6. Pantanik R, Coccorullo I, Speranza V et al (2005) Modeling of morphology evolution in the injection molding process of thermoplastic polymers. Progress Polymer Sci 30:1185-1222
7. Ruprecht R, Hanemann T, Piotter V. et al (1998) Polymer materials for microsystem technologies. Microsyst Technol 5:44-48
8. Ralf T, Jorg K, Stefan S, et al (1996) Morphology and phase behaviour of blends of syndiotactic and isotactic polypropylene: 1. X-ray scattering, light microscopy, atomic force microscopy, and scanning electron microscopy. Polymer 37:2627-2634
9. Shimizu T, Murakoshi Y, Sano T et al (1998) Fabrication of micro-parts by high aspect ratio structuring and metal injection molding using the supercritical debinding methol. Microsyst Technol 5:90-92
10. Piotter V, Bauer W, Benzler T. et al (2002) Injection molding of components for Microsystems. Microsyst Technol 7:99-102
11. Michaeli W, Spennemann A, Gartner R (2002) New plastification concepts for micro injection moulding. Microsyst Technol 8:55-57
12. Liu ZY, Loh MH, Tor SB et al (2002) Micro-powder injection molding. J Mater Process Technol 127:165-168