Estimating the strength of single-ended dislocation sources in micron-sized single crystals

Philosophical Magazine

Volumn 87, Issue 30, 2007, Pages 4777-4794

  Rao, S I ^b   Dimiduk, D M ^a   Tang, M ^c   Parthasarathy, T A ^b   Uchic, M D ^a   Woodward, C ^d  

^a AIR FORCE RESEARCH LABORATORY   (United States)

^b UES INC   (United States)

^c LAWRENCE LIVERMORE NATIONAL LABORATORY   (United States)

^d Northwestern University   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

ANISOTROPY; DISLOCATIONS (CRYSTALS); POISSON RATIO; STRESS ANALYSIS; THREE DIMENSIONAL;

DISLOCATION LINE DIRECTION; DISLOCATION LINE TENSION; PLASTIC RESPONSE;

SINGLE CRYSTALS;

EID: 34548593351     PISSN: 14786435     EISSN: 14786443     Source Type: Journal    
DOI: 10.1080/14786430701591513     Document Type: Article

References (30)

1. S.I. Rao, T.A. Parthasarathy, M. Tang, et al., paper presented at the 3rd International MMM Conference, Freiburg, 18-22 September (2006).
2. H. Tang, K.W. Schwarz and H.D. Espinosa, Acta mater. 55 1607 (2007).
3. D. Weygand, M. Poignant, P. Gumbsch, et al., Mater. Sci Engng A (in press).
4. M.D. Uchic, D.M. Dimiduk, J.N. Florando, et al., Mater. Res. Soc. Symp. Proc. 753 27 (2003).
5. M.D. Uchic and D.M. Dimiduk, Mater. Sci. Engng A 400-401 268 (2005).
6. D.M. Dimiduk, M.D. Uchic and T.A. Parthasarathy, Acta Mater. 53 4065 (2005).
7. D.M. Dimiduk, C. Woodward, R. LeSar, et al., Science 312 1188 (2006).
8. M.D. Uchic, D.M. Dimiduk, J.N. Florando, et al., Science 305 986 (2004).
9. J.R. Greer, W.C. Oliver and W.D. Nix, Acta Mater. 53 1821, errata (2005).
10. C.A. Volkert and E. Lilliodden, Phil, Mag. 86 5567 (2006).
11. D.M. Dimiduk, M.D. Uchic, S.I. Rao, et al., Modell. Simul. Mater. Sci. Engng 15 135 (2007).
12. B.V. Blankenhagen, P. Gumbsch and E. Arzt, Phil. Mag. Lett. 83 1 (2003).
13. T.A. Parthasarathy, S.I. Rao, D.M. Dimiduk, et al., Scripta. Mater. 56 313 (2007).
14. B. Pichaud, F. Minari and J. Kellerhals, Phil. Mag. A 38 593 (1978).
15. W. Cai, V. Bulatov, T. Pierce, et al., Solid Mech. Appl, 115 1 (2004).
16. A. Arsenlis, W. Cai, M. Tang, et al., Modell. Simul. Mater. Sci. Engng, accepted (2007).
17. A.J. Ardell, Metall. Trans. A 16 2131 (1985).
18. D. Bacon, D. Barnett and R. Scattergood, Prog. Mater. Sci, 23 51 (1980).
19. B. Devincre, in Computer Simulation in Materials Science, edited by H.O. Kirchner, V. Pontikis and L.P. Kubin (Kluwer Academic, Dordrecht, The Netherlands, 1996).
20. K. Schwarz, J. Appl. Phys. 85 108 (1999).
21. X.H. Liu and K. Schwarz, Modell. Simul, Mater. Sci. Engng 13 1233 (2005).
22. M. Tang, W. Cai, G. Xu, et al., Modell. Simul. Mater. Sci. Engng 14 1139 (2006).
23. J.P. Hirth and J. Lothe, Theory of Dislocations, 2nd ed. (John Wiley and Sons, New York, 1982).
24. P.M. Hazzledine, in Fundamentals of Deformation and Fracture, edited by B.A. Bilby, et al. (Cambridge University Press, Cambridge, 1985).
25. M. Tang, G. Xu, W. Cai, et al., in Thin Film Stresses and Mechanical Properties, edited by S.G. Corocoran, Y.-C. Joo, R.N. Moody and Z. Zuo (Materials Research Society, Warrendale, PA, 2003).
26. P.M. Hazzledine and S.J. Shaibani, in Proceedings of the 6th International Conference on Strength of Metals and Alloys (ICSMA), Vol. 1, edited R.C. Gifkins (Pergamon, Oxford, 1982).
27. P.M.. Hazzledine, H.P. Karnthaler and E. Wintner, Phil, Mag. 32 81 (1975).
28. E. Nembach, Prog. Mater. Sci. 45 275 (2000).
29. R. Madec, B. Devincre and L.P. Kubin, Phys. Rev. Lett. 89 255508-1 (2002).
30. H. Neuhauser, in Dislocations in Solids, edited by F.R.N. Nabarro, Vol. 6 (North-Holland, Amsterdam, 1983).