Investigations to remove domes from plastic shells by polishing

Fusion Science and Technology

Volumn 51, Issue 4, 2007, Pages 600-605

  Czechowicz, D G ^a   Chen, C J ^b   Dorman, J A ^c   Steinman, D A ^a  

^a GENERAL ATOMICS   (United States)

^b UNIVERSITY OF CALIFORNIA   (United States)

^c UNIVERSITY OF CALIFORNIA   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

ATOMIC FORCE MICROSCOPY; REMOVAL; SURFACE ROUGHNESS; SURFACE TREATMENT; TARGETS;

MECHANICAL POLISHING; MID POWER MODES; PLASTIC SHELLS; SURFACE DOMES;

PLASTIC PRODUCTS;

EID: 34250668709     PISSN: 15361055     EISSN: None     Source Type: Journal    
DOI: 10.13182/FST51-600     Document Type: Conference Paper

References (13)

1. K. C. CHEN, et al., "Fabrication of Graded Germanium-Doped CH Shells," Fusion Sci. Technol. 49, 751 (2006).
2. M. THEOBALD, et al., "Gas Etching to Obtain Germanium Doped CHx Microshells Compatible with the Laser Megajoule Target Specifications," Fusion Sci. Technol. 49, May 2006, p.757.
3. K. C. CHEN et al., "Reduction of Isolated Defects on Ge Doped CH Capsules to Below Ignition Specifications," Fusion Sci. Technol., this issue.
4. S. W. HAAN, et al., "Update on Specifications for NIF Ignition Targets, and Their Rollup into an Error Budget," Fusion Sci. Technol., this issue.
5. A. NIKROO and D. M. WOODHOUSE, "Bounce Coating Induced Domes on Glow Discharge Polymer Coated Shells," Fusion Sci. Technol. 35, 202 (1999).
6. S.A. LETTS, D.W. MEYERS, and L. A. WITT, "Ultrasmooth Plasma Polymerized Coatings for Laser Fusion Targets," J. Vac. Sci. Technol. 19, 739 (1981).
7. R. L. CRAWLEY, "Surface Improvement and Thickness Adjustment by Plasma Etching," KMS Fusion, Inc. 1988 Annual Technical Report on Inertial Fusion Research, p. 58, (1988).
8. A. A. YASSEEN, et al., "Chemical-Mechanical Polishing for Polysilicon Surface Micromachining," J. Electrochem. Soc. 144, 237 (1997).
9. G. NANZ and L. CAMILLETTI, "Modeling of Chemical-Mechanical Polishing: A Review," IEEE Transactions on Semiconductor Manufacturing 8, 382 (1995).
10. G.-R. YANG, et al., "Chemical-Mechanical Polishing of Parylene N and Benzocyclobutene Films," J. Electrochem. Soc. 144, 3249 (1997).
11. C. BORST, et al., "Chemical-Mechanical Planarization of Low-k Polymers for Advanced IC Structures," Transactions of the ASME 124, 362 (2002).
12. M. L. HOPPE and E. R. CASTILLO, "Polishing of Beryllium Capsules to Meet NIF Specifications," J. Phys. IV France 133, 895 (2005).
13. K. C. CHEN, private communication (2006).