Uncertainty in testing the metrological performances of coordinate measuring machines

CIRP Annals - Manufacturing Technology

Volumn 55, Issue 1, 2006, Pages 535-538

  Savio, E ^a  

^a UNIVERSITY OF PADOVA   (Italy)

Author keywords

Coordinate measuring machine; Test; Uncertainty

Indexed keywords

ERROR ANALYSIS; ESTIMATION; IDENTIFICATION (CONTROL SYSTEMS); QUALITY ASSURANCE; UNCERTAIN SYSTEMS;

CONTACT SCANNING PROBE; ERROR SOURCES; TEST UNCERTAINTY;

COORDINATE MEASURING MACHINES;

EID: 33750079895     PISSN: 00078506     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0007-8506(07)60476-4     Document Type: Article

References (14)

1. Evans, C.J., Hocken, R.J., Estler, T.W., 1996, Self-Calibration: Reversal, Redundancy, Error Separation, and 'Absolute Testing', Keynote paper, Annals of CIRP, Vol. 45/2:617-433.
2. Kunzmann, H., Wäldele, F., 1988, Performance of CMMs, Keynote paper, Annals of CIRP, Vol. 37/2: 633-640.
3. Wilhelm, R.G., Hocken, R., Schwenke, H., 2001, Task specific uncertainty in coordinate metrology, Keynote paper, Annals of CIRP, Vol. 50/2:553-563.
4. Abbe, M., Takamasu, K., Ozono, S., 2003, Reliability on calibration of CMM, Measurement, 33:359-368.
5. ISO 10360-2:2001, GPS - Acceptance test and reverification test for CMMs - Part 2: CMMs used for measuring size.
6. ISO 10360-3:2000, GPS - Acceptance test and reverification test for CMMs - Part 3: CMMs with the axis of a rotary table as the fourth axis.
7. ISO 10360-4:2000, GPS - Acceptance test and reverification test for CMMs - Part 4: CMMs used in scanning measuring mode.
8. Estler, T.W., 1999, Measurement as Inference: Fundamental Ideas, Keynote paper, Annals of CIRP, Vol. 48/2:611-631.
9. ISO 14253-1:1998, GPS - Inspection by measurement of workpieces and measuring equipment - Part 1: Decision rules for proving conformance or non-conformance with specification.
10. Kruth, J.-P., Vanherck, P., Van den Bergh, C., Schacth, B., 2002, Interaction between workpiece and CMM during quality control in non-standard thermal conditions, Precision Engineering, 26:93-98.
11. ISO/DTS 23165, 2004, GPS - Guide to the evaluation of CMM test uncertainty, Comm. Draft.
12. Goch G., 2003, Gear metrology, Keynote paper, Annals of CIRP, Vol. 52/2:659-695.
13. Weckenmann, A., Estler, T., Peggs, G., McMurtry, D., 2004, Probing Systems in Dimensional Metrology, Keynote paper, Annals of CIRP, Vol. 53/2:657-684.
14. De Chiffre, L., Hansen, N.H., Morace R.E., 2005, Comparison of Coordinate Measuring Machines using an Optomechanical Hole Plate, Annals of CIRP, Vol. 54/1:479-482.