Comparison of gear noise and dynamic transmission error measurements

Proceedings of the Tenth International Congress on Sound and Vibration

Volumn , Issue , 2003, Pages 4005-4012

  Henriksson, Mats ^a,b   Pärssinen, Mikael ^b  

^a ROYAL INSTITUTE OF TECHNOLOGY   (Sweden)

^b SCANIA CV AB   (Sweden)

Author keywords

[No Author keywords available]

Indexed keywords

ACOUSTIC NOISE; AUTOMOTIVE INDUSTRY; ERROR ANALYSIS; SHAFTS (MACHINE COMPONENTS); SPEED CONTROL; STIFFNESS; VIBRATIONS (MECHANICAL);

DYNAMIC TRANSMISSION ERRORS (DTE); GEAR NOISE; GEARBOX;

GEARS;

EID: 2342443616     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: None     Document Type: Conference Paper

References (8)

1. D. B. Welbourn, "Fundamental knowledge of gear noise - A survey", Proc. Noise & Vib. Of Eng. and Trans., I Mech E, 9-14, (1979)
2. D. R. Houser, R. Singh, Gear noise short course, Department of mechanical engineering, Ohio state university, Ohio, 2002
3. C. H. Chung, G. Steyer, T. Abe, M. Clapper, C. Shah, "Gear noise reduction through transmission error control and gear blank tuning", SAE technical paper series, 1999-01-1766
4. Y. Miayauchi, K. Fujii, T. Nishino, K. Hatamura, T. Kurisu, "Introduction of gear noise reduction ring by mechanism analysis including FEM dynamic tuning", SAE technical paper series, 2001-01-0865
5. M. Nilsson, "Mätning av dynamiskt överföringsfel i komplett växellåda", final thesis report, Umeå University, 2001
6. rotec RAS v4.11, ©2002 rotec GmbH
7. th AIAA/ASME/SAE/ASEE joint propulsion conference, Indianapolis, 1994
8. LDP, Load distribution program, Ohio state university, http://www.gearlab.org/Pages/Software/ldp_.html