Modeling and identification of feed drive kinematics and cycle time calculation

American Society of Mechanical Engineers, Manufacturing Engineering Division, MED

Volumn 14, Issue , 2003, Pages 483-490

  Wang, Wencai ^a   Yip Hoi, Derek M ^a  

^a UNIVERSITY OF MICHIGAN   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

ACCELERATION; ALGORITHMS; COMPUTER SIMULATION; COOLANTS; DECELERATION; DRILLING; MACHINING; PARAMETER ESTIMATION; POSITION CONTROL; SYNCHRONIZATION;

CYCLE TIME CALCULATIONS; FEED DRIVE KINEMATICS;

KINEMATICS;

EID: 1842590528     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1115/IMECE2003-41651     Document Type: Conference Paper

References (12)

1. Koren Y., "Computer Control of Manufacturing Systems", McGraw-Hill, New York, 1983.
2. Ou-Yang C., Lin T.S., "Developing an integrated framework for feature-based early manufacturing cost estimation", International Journal of Advanced Manufacturing Technology, 13 (1997) 618-629.
3. Maropoulos P.G. et al., "Integration of tool selection with design, part 2: aggregate machining time estimation". Journal of Materials Processing Technology, 107 (2000) 135-142.
4. Woods D.J. and Crossly T.R.," An empirical formula to determine the production times of turned components", Annals of the CIRP, 31(1983) 353-358.
5. Lee J.W., "Study on the determination of actual cutting time in NC turning", International Journal of Production Research, 26 (9) (1988) 1547-1559.
6. Pallot B., Duchamp R., "Motion time calculation for numerically controlled machine-tools", International Journal of Production Research, 29 (12) (1991)2433-2441.
7. Erkorkmaz K., Altintas Y., "High speed CNC system design. Part I: jerk limited trajectory generation and quintic spline interpolation", International Journal of Machine Tools & Manufacture, 41 (9)(2001) 1323-1345.
8. Tomita Y., Makino K., Sugimine M., Taniguchi N., "High-response X-Y stage system driven by in-parallel linear motors", Annals of CIRP 45 (1) (1996) 359-362
9. Simon D., Isik C., Optimal trigonometric robot joint trajectories, Robotica 9 (4) (1991) 379-386.
10. Pritschow G., Course notes: control techniques of machine tools and industrial robots), Institute of Control Technology for Machine Tools and Manufacturing Units, Stuttgart University, Germany, 1997.
11. Koren, Y., et al. Reconfigurable manufacturing systems. CIRP Annals, 2 (11) (1999) 6-12.
12. Yip-Hoi D.M., Research report on CoPl Case Study: Evaluation and Validation of Methodologies, NSF Engineering Research Center for Reconfigurable Machining Systems, the Universiy of Michigan, January 2002.