Preliminary study of polymer melt rheological behavior flowing through micro-channels

International Communications in Heat and Mass Transfer

Volumn 32, Issue 3-4, 2005, Pages 501-510

  Chen, Shia C ^a   Tsai, R I ^a   Chien, R D ^b   Lin, T K ^a  

^a CHUNG YUAN CHRISTIAN UNIVERSITY   (Taiwan)

^b NANYA INSTITUTE OF TECHNOLOGY   (Taiwan)

Author keywords

Melt rheology; Micro channel; Rabinowitsch correction; Shape factor; Shear thinning

Indexed keywords

CAPILLARY FLOW; CHANNEL FLOW; COMPUTER SIMULATION; MELTING; MICROSTRUCTURE; MOLDING; PRESSURE EFFECTS; RHEOLOGY; THERMAL EFFECTS; VISCOSITY MEASUREMENT; VOLUME MEASUREMENT;

MICRO-CHANNEL FLOW; MICRO-MELT RHEOLOGY; MICRO-STRUCTURED GEOMETRY; POLYMER MELTS;

POLYMERS;

POLYMER MELT; RHEOLOGY; SHEAR THINNING;

EID: 15844399342     PISSN: 07351933     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.icheatmasstransfer.2004.07.004     Document Type: Article

References (10)

1. D. Yao Rapid thermal response injection molding for microfabrication, Ph.D thesis, University of Massachusetts, Amherst, MA (2001)
2. C. Harris M.S. Despa K.W. Kelly J. Microelectromech. Syst. 9 2000 502
3. R.W. Friedl J. Inj. Molding Technol. 4 2000 78
4. L. Yu Y.J. Juang K.W. Koelling L.J. Lee SPE Tech. Papers 46 2000 468
5. D. Yao B. Kim J. Micromechanics Microengineering 12 2002 604
6. L. Yu C.G. Kuo L.J. Lee K.W. Keolling M.J. Madou Polym. Eng. Sci. 42 2002 871
7. Y.J. Juang L.J. Lee K.W. Koelling Polym. Eng. Sci. 42 2002 551
8. K.W. Koelling Molding and mold technology 2003 (September 1) Chung-Li, Taiwan
9. S.C. Chen Annual report of thin-wall injection molding of National Science Council 1998
10. J.M. Dealy Rheomers for molten plastics 1982 Van Nostrand Reinhold New York