A novel method to estimate parameters of the wall-wetting fuel model in MPFI engines for cold start and warm up conditions

Proceedings of the 2004 Fall Technical Conference of the ASME Internal Combustion Engine Division

Volumn , Issue , 2004, Pages 203-214

  Shahbakhti, M ^a   Ghafuri, M ^a   Aslani, A R ^a   Sahraeian, A ^a   Jazayeri, S A ^b   Azadi, S ^b  

^a IRAN KHODRO Engine Res Des/Mfg C   (Iran)

^b K N TOOSI UNIVERSITY OF TECHNOLOGY   (Iran)

Author keywords

[No Author keywords available]

Indexed keywords

AUTOMOTIVE FUELS; COMPUTER SIMULATION; ENGINE CYLINDERS; EVAPORATION; FUEL INJECTION; MATHEMATICAL MODELS; OXYGEN; PARAMETER ESTIMATION; SENSORS; THERMAL EFFECTS;

AIR FUEL RATIO (AFR); FUEL DELIVERY; FUEL TRANSFER; MASS FLOW;

INTERNAL COMBUSTION ENGINES;

EID: 14044276325     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1115/icef2004-0809     Document Type: Conference Paper

References (41)

1. Bielaczyc P. and Merkisz J., " Euro III / Euro IV Emissions-A Study of Cold Start and Warm-up Phases with a SI Engine", SAE Paper No. 1999-01-1073, 1999.
2. Kyriakis N.A. and Andre M., "Cold Start of Passenger Cars", Int.J.of Vehicle Design,Vol. 20, Nos. 1-4 (Special Issue), 1998.
3. Burk P.L. & Hochmuth J.K., "Cold Start Hydrocarbon Emissions Control", SAE paper No. 950410,1995.
4. Laurikko J. "Emissions Performance of Current TWC Vehicles at Low Ambient Temperature over FTP and ECE Test Cycles", SAE Paper No. 940933, 1994.
5. Rasmussen, I., "Emission fra Biler (Emissions from Cars, In Danish)", Ph. D. Dissertation, The Laboratory for Energetic, The Technical University of Denmark, Lyngby,Denmark, 1971.
6. Aquino, C. F., "Transient A/F Control Characteristics of the 5 Liter Central Fuel Injection Engine", SAE Paper No.810494, 1981.
7. Hires S. D. and Overington M. T., "Transient Mixture Strength Excursions - An Investigation of their Causes and the Development of a Constant Mixture Strength Fuelling Strategy", SAE Paper No.810495, 1981.
8. Cho H. and Min K., "Prediction of the Air-Fuel Ratio in Transient Conditions Using a Model of Liquid Fuel Behavior in the Intake Port of a SI Engine", IMechE, Vol. 214, 2000.
9. Curtis E. W. and Aquino Ch. F., "A New Port and Cylinder Wall Wetting Model to Predict Transient Air/Fuel Excursions in a Port Fuel Injected Engine", SAE Paper No. 961186, 1996.
10. Liand J. and Collings N., "A Semi-Empirical Model of Fuel Transport in Intake Manifolds of SI Engines and its Application in Transient Conditions", SAE Paper No. 1999-01-1314, 1999.
11. Haluska P. and Guzzella L., "Control Oriented Modeling of Mixture Formation Phenomena in Multi Point Injection SI Gasoline Engines", SAE Paper No. 980628. 1998.
12. Neyachenko I. I., "Method of A/F Control During SI Engine Cold Start", SAE Paper No.981171, 1998.
13. Leone D. M. and Dodge L. G., "Model Based Control and Cylinder-Event-Based Logic for an Ultra-Low Emissions Vehicle", SAE Paper No. 970531, 1997.
14. Lenz U. and Schroeder D., "Transient Air-Fuel Ratio Control Using Artificial Intelligence", SAE Paper No.970618, 1997.
15. Berggren P. and Perkovic A., "Cylinder Individual Lambda Feedback Control in an SI Engine", Msc Thesis, Linkoping University, 1996.
16. Shaylor P. J. and Teo Y. C., "Fuel Transport Characteristics of Spark Ignition Engines for Transient Fuel Compensation", SAE Paper No. 950067, 1995.
17. Horie K. and Akazaki Sh., "Emission Reduction During Warm-up Period by Incorporating a Wall-Wetting Fuel Model on the Fuel Injection Strategy During Engine Starting", SAE Paper No. 952478, 1995.
18. Almkvist G. & Ericksson S., "A Study of Air to Fuel Transient Response and Compensation with Different Fuels", SAE Paper No. 941933, 1994.
19. Stefanopoulou A. G. & Cook J. A., "Joint Air-Fuel Ratio and Torque Regulation Using Secondary Cylinder Air Flow Actuators",ASME Journal of Dynamic Systems, Measurement and Control, Vol.121,638-647,1999.
20. Melgaard H. & Hendricks E., "Continuous Identification of a Four-Stroke SI Engine", Proceedings of the American Control Conference, 1876-1881, 1990.
21. Chen-Fang Chang & Fekete N. P., "Engine Air-Fuel Ratio Control Using an Event-Based Observer", SAE Paper No.930766, 1993.
22. Kainz J. L. & Smith J. C., "Individual Cylinder Fuel Control with a Switching Oxygen Sensor", SAE Paper No.1999-01-0546, 1999.
23. Almkvist G. and Eriksson S., "An Analysis of Air to Fuel Ratio Response in a MPFI Engine Under Transient Conditions", SAE Paper No.932753, 1993.
24. Moskwa J.J., "Automotive Engine Modeling for Real-Time Control", Department of Mechanical Engineering, M.I.T., PH.D. thesis,1988.
25. Jones V. K., Ault B. A. and Franklin B. A., "Identification and Air-Fuel Ratio Control of a Spark Ignition Engine", IEEE Transactions on Control Systems Technology, Vol.3,No.1,14-21, 1995.
26. Arsie I & Rizzo G., "Non Linear Observer for Fuel Film Dynamics into the Intake Manifold of a Spark Ignition Engine", IEEE/ASME International Conference on Advanced Intelligent Mechatronics, 251-256, 1999.
27. Moyne L. and Moine X., "Application of a Physical Model in Engine Control: Compensation of Wall Wetting by Fluid Mechanics", Int. J. of Vehicle Design, Vol. 22, Nos. 3/4, 1999.
28. Oroukre P. J. & Amsden A. A., "A Particle Numerical Model for Wall Film Dynamics in PFI Engines", SAE Paper No. 961961, 1996.
29. Schurov S. M. & Collings N., "An Experimental Investigation of Fuel Transport in a Port Fuel Injected Engine", SAE Paper No. 952485, 1995.
30. Tang X. & Asik J. R., "Optimal A/F Ratio Estimation Model (Synthetic UEGO) for SI Engine Cold Transient AFR Feedback Control", SAE Paper No. 980798, 1998.
31. Moskwa J.J., "Estimation of Dynamic Fuel Parameters in Automotive Engines",ASME Journal of Dynamic Systems, Measurement and Control, Vol 116, No.4,774-780,1994.
32. Hendricks E. & Sorenson S. C., "Mean Value Modelling of Spark Ignition Engines", SAE Paper No. 900616, 1990.
33. Nelles O., "Nonlinear System Identification", Springer, Berlin, 2001.
34. Ghen G. and Asmus T. W., "Fuel Mixture Temperature Variations in the Intake Port", SAE Paper No. 961194, 1996.
35. Alkidas A. C., "The Effects of Fuel Preparation on Hydrocarbon Emissions of a SI Engine Operating Under Steady-State Conditions", SAE Paper No. 941959, 1994.
36. Boam D. J. & Finlay I. C., "The Sources of Unburned Hydrocarbon Emissions From Spark Ignition Engine During Cold Start and Warm up", ImechE, Part D, Vol. 208, 1994.
37. Cengel Y., "Thermodynamics and Heat Transfer", Mc Graw-Hill, Inc., 1997.
38. " Annual Report for IRAN Weather Conditions", Country Aerology Organization Publication, 2000.
39. Alkidas C., "Intake-Valve Temperature histories During S.I. Engine Warm-Up", SAE Paper No. 2001-01-1704, 2001.
40. Heywood J. B., "Internal Combustion Engine Fundamentals", Mc Graw_Hill, Inc.,1988.
41. Meyer R., "Liquid Fuel Transport into the Cylinder in Port Injected SI Engines", PhD Thesis, Massachusetts, M.I.T University, 1998.