Microstructure of alumina compact body made by slip casting

Journal of the European Ceramic Society

Volumn 22, Issue 4, 2002, Pages 397-401

  Takao, Yasumasa ^a   Hotta, Tadashi ^b   Naito, Makio ^b   Shinohara, Nobuhiro ^c   Okumiya, Masataro ^c   Uematsu, Keizo ^d  

^a NATIONAL INSTITUTE OF ADVANCED INDUSTRIAL SCIENCE AND TECHNOLOGY AIST   (Japan)

^b Japan Fine Ceramics Centre   (Japan)

^c ASAHI GLASS CO LTD   (Japan)

^d NAGAOKA UNIVERSITY OF TECHNOLOGY   (Japan)

Author keywords

Al2O3; Anisotropy; Failure analysis; Optical microscopy; Slip casting; Water suction

Indexed keywords

ANISOTROPY; CASTING; DRYING; FLOW OF FLUIDS; MICROSTRUCTURE;

POWDER PARTICLES;

ALUMINA;

ALUMINUM OXIDE; CASTING; FAILURE ANALYSIS; MICROSTRUCTURE;

EID: 0036532883     PISSN: 09552219     EISSN: None     Source Type: Journal    
DOI: 10.1016/S0955-2219(01)00307-7     Document Type: Article

References (28)

1. Fundamental parameters of casting slips and methods of their measurement
2. Reliability of alumina ceramics. Part 2: Effect of processing
3. Gelcasting of alumina
4. Structural reliability: A processing-dependent phenomenon
5. Powder processing science and technology for increased reliability
6. Burnout of binder and sintering behavior of powder compacts of bimodally distributed alumina powders with stearic acid and polyethleneglycol
7. Rheological characterization of aqueous alumina slurry for tape casting
8. Optimization of suspension characteristics for shaping processes
9. The adsorption behavior of dispersant molecules and rheological properties of highly concentrated alumina slurries
10. Role of the clogging effect in the slip casting process
11. The rheological behavior of concentrated colloidal dispersions
12. Work of adhesion influence on the rheological properties of silica filled polymer composites
13. Effects of organotitanate additions on the dispersion of aluminum nitride in nonpolar solvents
14. The effect of silane agent on tensile and bending properties of silica filled epoxy after water absorption by boiling
15. Principles of the development of a silica dielectric for microelectronics packaging
16. Functional polymers
17. Textures in high-alumina engineering ceramics
18. Direct study of the behavior of flow-forming defect in sintering
19. Effect of pressing conditions on the characteristics of pores in hot isostatically pressed alumina
20. Immersion microscopy for detailed characterization of defects in ceramic powders and green bodies
21. Grain-oriented microstructure of alumina ceramics made through the injection molding process
22. Effects of seasons on density, strength of alumina
23. New characterization techniques to control the manufacturing process of fine ceramics: A case study of the origin of property variation with spray dryer size
24. Morphological change in process-related large pores of granular compacted and sintered alumina
25. Processing defects and their relevance to strength in alumina ceramics made by slip casting
26. Particle aggregated structure in silica particle filled epoxy resin composite system
27. 2 particle-filled epoxy resin composite systems
28. Particulate structural contribution to viscosity of aluminum nitride particle filled epoxy resin composite system