Microcomputer implementation of optimal algorithms for closed-loop control of hybrid stepper motor drives

IEEE Transactions on Industrial Electronics

Volumn 47, Issue 6, 2000, Pages 1319-1325

  Crnosija, Petar ^a,b   Kuzmanovic, Branislav ^a   Ajdukovic, Stipe ^a  

^a UNIVERSITY OF ZAGREB   (Croatia)

^b UNIVERSITY OF ZAGREB   (Croatia)

Author keywords

[No Author keywords available]

Indexed keywords

ALGORITHMS; CHOPPER AMPLIFIERS; CLOSED LOOP CONTROL SYSTEMS; ELECTRIC CURRENT CONTROL; ELECTRIC DRIVES; MICROCONTROLLERS; OPTIMAL CONTROL SYSTEMS; PHASE CONTROL; RELUCTANCE MOTORS; TORQUE CONTROL;

HYBRID STEPPER MOTOR DRIVES;

STEPPING MOTORS;

EID: 0034497674     PISSN: 02780046     EISSN: None     Source Type: Journal    
DOI: 10.1109/41.887960     Document Type: Article

References (17)

1. P. P. Acarnley and P. Gibbons, "Closed-loop control of stepping motors: Prediction and realization of optimum switching angle," Proc. Inst. Elect. Eng., pt. B, vol. 129, no. 4, pp. 211-216, 1982.
2. P. P. Acarnley, R. J. Hill, and C. W. Hooper, "Detection of rotor position in stepping and switched motors by monitoring of current waveform," IEEE Trans. Ind. Electron., vol. IE-32, pp. 215-222, June 1985.
3. R. Brown, "Near time-optimal control of step motors," in Proc. 15t Anna. Symp. IMCSD, B. C. Kuo, Ed., 1986, pp. 191-200.
4. P. Crnosija, Z. Brkia, T. Crnosija, and O. Percinic, "Position and speed digital measurement of step motors,"in Proc. 16th Annu. Symp. IMCSD, B. C. Kuo, Ed., 1987, pp. 313-320
5. P. Crnos'ija, M. Benakovic, F. Skof, T. Crnosija, I. Prelozicek, and O. Percinic, "Optimal closed-loop control of a hybrid step motor with chopper drive," Robot. Comput.-Integr. Manuf., vol. 8, no. 3, pp. 187-192, 1991
6. P. Crnosija, A. Nad, and B. Kuzmanovic, "Control of hybrid steppe motor drive by using a signal of reconstructed magnetic flux," in Proc EPE Chapter Symp. EDDA, Lausanne, Switzerland, 1994, pp. 197-202
7. EV80C196 KB Microcontroller Evaluation Board Users Manual, Inte Corp., Chandler, AZ, 1989
8. V. D. Hair, "Direct detection of back emf in permanent-magnet step mo- tors," in Proc. 12th Annu. Symp. IMCSD, B. C. Kuo, Ed., 1983, pp. 211-219
9. T. Higuchi, "Closed-loop control of PM step motors by sensing back emf," in Proc. llth Annu. Symp. IMCSD, 1982, pp. 289-294
10. A. Hughes, "Parameters governing the dynamic performance of permanent-magnet stepping motors," in Proc. 6th Annu. Symp. IMCSD, B. C. Kuo, Ed., 1977, pp. 397
11. Linear Motors and Positioning Systems, Kinetics, Santa Clara, CA, 1985
12. B. C. Kuo, Incremental Motion Control Step Motors and Control Systems. Champaign, IL: SRL Publishing, 1979
13. B.C. Kuo and K. Butts, "Closed-loop control of a 3.6° floppy disk drive PM motor by back emf sensing," in Proc. llth Annu. Symp. IMCSD, 1982, pp. 295-308
14. B. Kuzmanovic, P. Crnosija, and H. Krndelj, "Optimal closed-loop control of a hybrid step motor with chopper and current controller," in Proc. EPE Chapter Symp. EDDA, 1996, pp. 129-134
15. Manual SLS-MSO, Phytron, Grobenzell, Germany, 1989
16. Schrittmotoren RSS und RSH, Phytron, Grobenzell, Germany, 1989
17. D. G. Taylor and B. C. Kuo, "Optimization of average torque in hybrid permanent magnet step motors using closed-loop control," in Proc. 14th Annu. Symp. IMCSD, B. C. Kuo, Ed., 1985, pp. 319-333.