Nanostructured multilayers and their influence on tack of cross-linked elastomers

Langmuir

Volumn 16, Issue 18, 2000, Pages 7346-7350

  David, M O ^a   Gerriet, T ^a   Nardin, M ^a   Schultz, J ^a  

^a INSTITUT DE CHIMIE DES SURFACES ET INTERFACES   (France)

Author keywords

[No Author keywords available]

Indexed keywords

ADHESION; CROSSLINKING; ELASTOMERS; ENERGY GAP; INTERDIFFUSION (SOLIDS); INTERFACIAL ENERGY; MECHANICAL PROPERTIES; NANOSTRUCTURED MATERIALS; RHEOLOGY; SURFACE PROPERTIES; WETTING;

ALKANETHIOL MOLECULES; INTERFACIAL DISSIPATION; MOLTEN POLYMERS;

MULTILAYERS;

EID: 0034275824     PISSN: 07437463     EISSN: None     Source Type: Journal    
DOI: 10.1021/la9915670     Document Type: Article

References (28)

1. Wetzel, F. H. ASTM Bull. 1957, 221, 64.
2. Hamed, G. R. Rubber Chem. Technol. 1981, 54, 403.
3. Hamed, G. R. Rubber Chem. Technol. 1981, 54, 576.
4. Russell, T. P.; Kim H. C. Science 1999, 285, 1219.
5. de Crevoisier, G.; Fabre, P.; Corpart, J. M.; Leibler, L. Science 1999, 285, 1246.
6. Gent, A. N.; Schultz, J. J. Adhes. 1972, 3, 281.
7. de Gennes, P. G. C. R. Acad. Sci. 1988, 307, 1949.
8. de Gennes, P. G. C. R. Acad. Sci. 1991, 311 II, 1415.
9. de Gennes, P. G. C. R. Acad. Sci. 1996, 320 IIb, 193.
10. Zosel, A. Int. J. Adhesion Adhes. 1998, 18, 265.
11. Cretan, C.; Leibler, L. J. Polym. Sci., Part B: Polym. Phys. 1996, 34, 545.
12. Gay, C.; Leibler, L. Phys. Rev. Lett. 1999, 82, 936.
13. Neumann, A. W.; Good, R. J. In Surface and Colloid Science; Good, R. J., Stronberg, R. Eds.; Plenum: NY, 1979.
14. Flory, P. J.; Rehner, J. J. Chem. Phys. 1943, 11, 521.
15. Flory, P. J. J. Chem. Phys. 1950, 18, 108.
16. Johnson, K. L.; Kendall, K.; Roberts, A. D. Proc. R. Soc. London, Ser. A 1971, 324, 301.
17. Ondarçuhu, T. J. Phys, II 1997, 7, 1893.
18. Zhang, L.; Cosandey, F.; Persaud, R.; Madey, T. E. Surf. Sci. 1999, 439, 73.
19. Petri, D. F. S.; Wenz, G.; Shunk, P.; Schimmel, T. Langmuir 1999, 15, 4520.
20. The glass plates used for tack and contact angle measurements were degreased only with acetone and alcohol: this is not sufficient. Subsequent treatment with a low concentration of sodium hydroxide in water leads to a surface completely covered with water (David, M. O.; Nipithakul, T.; Nardin, M.; Schultz, J.; Suchiva, K. J. Appl. Polym. Sci., in press).
21. Cognard, J. J. Chim. Phys. 1987, 84, 2.
22. The values are slightly higher but comparable to hysteresis obtained with glass. This variation does not necessarily reflect a variation of roughness because hysteresis is also sensitive to the chemical composition of the surface and especially its reorganizaton (orientation of groups interacting favorably with water) when it is in contact with the liquid.
23. Eick, J. D.; Good, R. J.; Neumann, A. W. J. Colloid Interface Sci. 1975, 53, 235.
24. 27
25. Gent, A. N.; Lai, S. M. Rubber Chem. Technol. 1995, 68, 13.
26. Kinloch, A. J. Adhesion and Adhesives Science and Technology; Chapman and Hall: New York, 1987; Chapter 3.
27. Bain, C. D.; Troughton, E. B.; Tao, Y. T.; Evall, J.; Whitesides, G. M.; Nuzzo, R. G. J. Am. Chem. Soc. 1989, 111, 321.
28. Wohlfart, P.; Weiss, J.; Käshammer, J.; Winter, C.; Scheumann, V.; Fischer, R. A.; Mittler-Neher, S. Thin Solid Films 1999, 340, 274.