Measuring transient wall heat flux under diesel engine conditions

International Journal of Engine Research

Volumn 5, Issue 5, 2004, Pages 443-452

  Meingast, U ^a   Reichelt, L ^a   Renz, U ^a  

^a RWTH AACHEN UNIVERSITY   (Germany)

Author keywords

Common rail system; Diesel engine; Transient wall heat flux

Indexed keywords

ANEMOMETERS; COMPUTATIONAL FLUID DYNAMICS; DOPPLER EFFECT; EVALUATION; HEAT FLUX; HIGH PRESSURE EFFECTS; HIGH TEMPERATURE EFFECTS; THERMOCOUPLES;

COMMON RAIL (CR) SYSTEMS; TRANSIENT ENERGY EQUATION; TRANSIENT WALL HEAT FLUX;

DIESEL ENGINES;

EID: 9944252009     PISSN: 14680874     EISSN: None     Source Type: Journal    
DOI: 10.1243/1468087042320960     Document Type: Article

References (21)

1. Enomoto, Y., Nagano, H., Hagihara, Y. and Koyama, T. Thermal load in D.I. diesel engines under EGR operation-measurements of steady state temperature of combustion chamber wall surfaces and intake gas temperature. Jap. Soc, Automat. Engrs Rev., 1997, 18, 225-231.
2. Kübler, W. Kolbentemperaturmessung mit Telemetrie am Beispiel eines Temperaturvergleichs zwischen MAN-Dieselmotoren. Motortechnische Z., 1995, 56(2), 72-77.
3. Senda, J., Kanda, T., Al-Roub, M., Farrell, F., Fukami, T. and Fujimoto, H. Modelling spray impingement considering fuel film formation on the wall. SAE Technical Paper 970047, 1997.
4. Wolf, R. S. and Cheng, W. K. Heat transfer characteristics of impinging diesel sprays. SAE Technical Paper 890439, 1989.
5. Senda, J., Fujimoto, H. and Yamamoto, K. Heat flux between impinged diesel spray and flat wall. SAE Technical Paper 912460, 1991.
6. Liu, Z. and Reitz, R. D. Modelling fuel spray impingement and heat transfer between wall in direct injection diesel engines. Numer. Heat Transfer, Part A, 1995, 28, 515-529.
7. Senda, J., Kobayashi, M., Iwashita, S. and Fujimoto, H. Modelling of diesel spray impingement on a flat wall. SAE Technical Paper 941894, 1994.
8. Eckhause, J. E. and Reitz, R. D. Modelling heat transfer to impinging fuel sprays in direct-injection engines. Atomization and Sprays, 1995, 5, 213-242.
9. Senda, J., Yamada, K., Fujimoto, H. and Miki, H. The heat-transfer characteristics of a small droplet impinging upon a hot surface. Int. Jap. Soc. Mech. Engrs, Ser. II, 1988, 2321(1), 105-111.
10. Meingast, U. and Renz, U. Fuel film thickness measurements under diesel engine conditions. In Proceedings of Conference on Liquid Atomization and Spray Systems (ILASS2001), Zürich, Switzerland, September 2001.
11. Diesel Engine Management, 2nd edition, 1999 (R. Bosch GmbH), Stuttgart, Germany.
12. Reichelt, L., Meingast, U. and Renz, U. Calculating transient wall heat flux from measurements of surface temperature. Int. J. Heat and Mass Transfer, 2002, 45(3), 579-584.
13. Meingast, U., Reichelt, L., Staudt, M., Renz, U. and Sommerhoff, F.-A. Analysis of spray/wall interaction under diesel engine conditions. SAE Technical Paper 2000-01-0272, 2000.
14. Temple-Pediani, R. W. Fuel droplet vaporization under pressure on a hot surface. Proc. Instn Mech. Engrs, 1970, 148, 677-696.
15. Meingast, U. Spray/Wand-Wechselwirkung bei der dieselmotorischen Direkteinspritzung. PhD Thesis, RWTH, Aachen, Germany, 2003.
16. FLUENT Users Guide V 4.48, 1998 (FLUENT Inc., Lebanon, New Hampshire).
17. Hohmann, S. Strahlausbreitung und Tropfenverdunstung bei der dieselmotorischen Direkt-einspritzung. PhD Thesis, RWTH, Aachen, Germany, 1998.
18. Hohmann, S. and Renz, U. Numerical simulations of fuel sprays at high ambient pressure: the influence of real gas effects and gas solubility on droplet vaporisation. Int. J. Heat and Mass Transfer, 2003, 46(16), 3017-3028.
19. Stanton, D. W. and Rutland, C. J. Multi-dimensional modelling of heat and mass transfer of fuel films resulting from impinging sprays. SAE Technical Paper 980132, 1998.
20. Wruck, N. Transientes Sieden von Tropfen beim Wandaufprall. PhD Thesis, RWTH, Aachen, Germany, 1999.
21. Aamir, M. A. and Watkins, A. P. Modelling of spray impingement heat transfer. In Proceedings of Conference on Liquid Atomization and Spray Systems (ILASS-Europe), Darmstadt, Germany, 11-13 September 2000. Paper I.3a.