Sequential injection overmolding of an elastomeric ethylene-octene copolymer on a polypropylene homopolymer core

Polymer Engineering and Science

Volumn 44, Issue 11, 2004, Pages 2110-2116

  Arzondo, L M ^a   Pino, N ^a   Carella, J M ^a   Pastor, J M ^b,c   Merino, J C ^b,c   Poveda J ^c   Alonso, C ^c  

^a UNIVERSIDAD NACIONAL DE MAR DEL PLATA   (Argentina)

^b UNIVERSIDAD DE VALLADOLID   (Spain)

^c FOUNDATION FOR RESEARCH AND DEVELOPMENT IN TRANSPORT AND ENERGY   (Spain)

Author keywords

[No Author keywords available]

Indexed keywords

COOLING; COPOLYMERS; ELASTOMERS; ETHYLENE; HOMOPOLYMERIZATION; LOW DENSITY POLYETHYLENES; MECHANICAL PROPERTIES; MOLECULAR STRUCTURE; PACKING; POLYMERS; POLYPROPYLENES; TEMPERATURE DISTRIBUTION; THERMAL EXPANSION;

ETHYLENE-OCETENE COPOLYMER (EOC); SEQUENTIAL INJECTION OVERMOLDING; SHEAR RATES;

INJECTION MOLDING;

EID: 9644265117     PISSN: 00323888     EISSN: None     Source Type: Journal    
DOI: 10.1002/pen.20216     Document Type: Article

References (12)

1. D. Y. Huang and R. S. Chen, Polym. Eng. Sci., 39, 2155 (1999).
2. A. R. Carella, C. Alonso, J. C. Merino, and J. M. Pastor, Polym. Eng. Sci. 42, 2172 (2002).
3. D. Weng et al., J. Injection Molding Technol., 4, 22 (2000).
4. A. J. Hsieh and J. W. Soong. Reinf. Plast. Compos., 20, 239 (2001).
5. V. Mangipudi, M. Tlrrell, and A. V. Pocius, J. Adhes. Sci. Technol., 8, 1251 (1994).
6. A. V. Pocius, Adhesion and Adhesives Technology: An Introduction, Hanser, New York (1996).
7. D. Rana, C. H. Lee, K. Cho, B. H. Lee, and S. Choe, J. Appl. Polym. Sci. 69, 2441 (1998).
8. C. J. Carriere and H. C. Silvis, J. Appl. Polym. Sci., 66, 1175 (1997).
9. R. L. Jones and R. W. Richards, Polymer at Surfaces and Interfaces, Chapter 4, Cambridge University Press, London (1999).
10. E. Helfand and Y. Tagami, J. Chemical Physics, 56, 3592 (1972).
11. R. Schnell, M. Stamm, and C. Creton, Macromolecules, 31, 2284 (1998).
12. F. S. Bates, A. Kumar. and M. F. Schultz, J. Polym. Sci.: Part B: Polym. Phys., 33, 1423 (1995).