Effects of hydrogen peroxide on corrosion of stainless steel, (II) Evaluation of oxide film properties by complex impedance measurement

Journal of Nuclear Science and Technology

Volumn 41, Issue 9, 2004, Pages 880-889

  Sugama, Junichi ^a   Uchida, Shunsuke ^a   Yamashiro, Naoya ^a   Morishima, Yusuke ^a   Hirose, Tatsuya ^a   Miyazawa, Takahiro ^a   Satoh, Tomonori ^a   Satoh, Yoshiyuki ^a   Iinuma, Koichi ^a   Wada, Yoichi ^b   Tachibana, Masahiko ^b  

^a TOHOKU UNIVERSITY   (Japan)

^b HITACHI LTD   (Japan)

Author keywords

BWR type reactors; Cole Cole plot; Complex impedance; Electrochemical corrosion potential; Hydrogen peroxide; Stress corrosion cracking

Indexed keywords

COLE-COLE PLOT; COMPLEX IMPEDANCE; ELECTROCHEMICAL CORROSION POTENTIAL; HYDROGEN WATER CHEMISTRY (HWC);

BOILING WATER REACTORS; CORROSION; ELECTRIC RESISTANCE; ELECTROMECHANICAL DEVICES; HYDROGEN PEROXIDE; STRESS ANALYSIS; STRESS CORROSION CRACKING;

STAINLESS STEEL;

EID: 9144223946     PISSN: 00223131     EISSN: None     Source Type: Journal    
DOI: 10.1080/18811248.2004.9715560     Document Type: Article

References (19)

1. Y. Wada, S. Uchida, M. Nakamura, et al., “Empirical understanding of the dependency of hydrogen water chemistry effectiveness on BWR designs,” J. Nucl. Sci. Technol., 36, 169 (1999).
2. S. Uchida, E. Ibe, K. Nakata, et al., “Application of hydrogen water chemistry to moderate corrosive circumstances around the reactor pressure vessel bottom of boiling water reactors,” Nucl. Technol., 110, 250 (1995).
3. R. J. Row, M. E. Indig, C. C. Lin, et al., “Suppression of ra-diolytic oxygen produced in a BWR by feedwater hydrogen addition,” Proc. Int. Conf. Water Chemistry of Nuclear Reactor Systems, Water Chemistry 3, British Nuclear Energy Society, 23 (1984).
4. R. L. Cowan, M. E. Indig, J. N. Kass, et al., “Experience with hydrogen water chemistry in boiling water reactors,” Proc. Int. Conf. Water Chemistry of Nuclear Reactor Systems, Water Chemistry 4, British Nuclear Energy Society, 29 (1986).
5. F. P. Ford, D. F. Taylor, P. L. Andresen, et al., “Corrosion assisted cracking of stainless and low alloy steels in LWR environments,” EPRI NP-5064M Project 2006-6 Final Report, February 1987, (1987).
6. Y. J. Kim, L. W. Niedrach, C. C. Lin, et al., “Development of ECP models for BWR application,” Proc. 7th Int. Symp. Environmental Degradation of Materials in Nuclear Power Systems—Water Reactors, Breckenridge, CO., National Association of Corrosion Engineers, 699 (1995).
7. S. Uchida, N. Shigenaka, M. Tachibana, et al., “Effects of hydrogen peroxide on intergranular stress corrosion cracking of stainless steel in high temperature water, (I); Effects of hydrogen peroxide on electrochemical corrosion potential of stainless steel,” J. Nucl. Sci. Technol., 35, 301 (1998).
8. T. Satoh, S. Uchida, J. Sugama, et al., “Effects of hydrogen peroxide on corrosion of stainless steel (I); Improvement of hydrogen peroxide remaining in a high temperature high pressure hydrogen peroxide loop,” J. Nucl. Sci. Technol., 41, 610 (2004).
9. C. C. Lin, F. R. Smith, N. Ichikawa, et al., “Decomposition of hydrogen peroxide in aqueous solutions at elevated temperatures,” Int. J. Chem. Kinetics, 23, 971 (1991).
10. D. Hiroishi, “Homogeneous and heterogeneous decomposition of hydrogen peroxide in high temperature water,” Proc. Int. Conf. Water Chemistry of Nuclear Reactor Systems, Water Chemistry 5, British Nuclear Energy Society, 311 (1989).
11. S. Uchida, M. Tachibana, A. Watanabe, et al., “Effects of hydrogen peroxide on intergranular stress corrosion cracking of stainless steel in high temperature water, (II); Optimization of crack propagation rate measurement system,” J. Nucl. Sci. Technol., 37, 257 (2000).
12. Y. Wada, A. Watanabe, M. Tachibana, et al., “Effects of hydrogen peroxide on intergranular stress corrosion cracking of stainless steel in high temperature water, (III); Crack growth rate in corrosive envirnment determined by hydrogen peroxide,” J. Nucl. Sci. Technol., 38, 183 (2001).
13. Y. Wada, A. Watanabe, M. Tachibana, et al., “Effects of hydrogen peroxide on intergranular stress corrosion cracking of stainless steel in high temperature water, (IV); Effects of oxide film on electrochemical corrosion potential,” J. Nucl. Sci. Technol., 37, 901 (2000).
14. N. Yamashiro, S. Uchida, Y. Satoh, et al., “Determination of hydrogen peroxide in pure water by chemiluminescence detection, (I); Flow cell type hydrogen peroxide detector,” J. Nucl. Sci. Technol., 41, 890 (2004).
15. S. Uchida, Y. Satoh, N. Yamashiro, et al., “Determination of hydrogen peroxide in pure water by chemiluminescence detection, (II); Theoretical analysis of luminol chemiluminescence processes,” J. Nucl. Sci. Technol., 41, 898 (2004).
16. K. Mabuchi, M. Sakai, N. Ohnaka, “A study on corrosion behavior of Type 304 stainless steel with electrochemical impedance spectroscopy in high temperature pure water,” Zairyo-to-Kankyo, 43, 2-10 (1994), [in Japanese].
17. E. Ibe, S. Uchida, “A water radiolysis model in a circulating flow system with a boiling region and its application to hydrogen alternative water chemistry of boiling water reactors,” Nucl. Sci. Eng., 90, 140 (1985).
18. S. Uchida, T. Satoh, K. Furukawa, et al., “Characterization of oxide films on stainless steel exposed to hydrogen peroxide and oxygen in high temperature water,” Proc. 11th Int. Symp. Environmental Degradation of Materials in Nuclear Power Systems—Water Reactors, Stevenson, Washington, Aug. 10-14, 2003, (2003), (in CD-ROM).
19. Y. Murayama, T. Satoh, S. Uchida, et al., “Effects of hydrogen peroxide on intergranular stress corrosion cracking of stainless steel in high temperature water, (V); Characterization of oxide film on stainless steel by multilateral surface analysis,” J. Nucl. Sci. Technol., 39, 1199 (2002).