Emission formation mechanisms in a two-stroke direct-injection engine

SAE Technical Papers

Volumn , Issue , 1998, Pages

  Casarella, M V ^a   Ghandhi, J B ^b  

^a DELPHI CORPORATION   (United States)

^b UNIVERSITY OF WISCONSIN MADISON   (United States)

Author keywords

[No Author keywords available]

Indexed keywords

AIR; COMBUSTION; ENGINES; FUELS; MIXTURES; NITROGEN; NITROGEN OXIDES;

CHEMICAL PRODUCTION; COMBUSTION AND EMISSION PERFORMANCE; COMBUSTION QUALITIES; DIRECT INJECTION ENGINES; FORMATION MECHANISM; HIGH PRESSURE SWIRL INJECTOR; IN-CYLINDER MIXTURES; INJECTION SYSTEMS;

DIRECT INJECTION;

EID: 85072449151     PISSN: 01487191     EISSN: 26883627     Source Type: Journal    
DOI: 10.4271/982697     Document Type: Conference Paper

References (32)

1. EPA Regulation, Federal Register, Vol. 61, No. 194, October 1996
2. Heywood, J. B., Internal Combustion Engine Fundamentals, McGraw-Hill, New York, 1988.
3. Automotive Engineering, December 1997, pp 81-85.
4. Syvertsen, M. L., "Two-Stroke Direct-Injection Emissions and Efficiency: A Statistical Approach," M.S. Thesis, Department of Mechanical Engineering, University of Wisconsin-Madison, 1996.
5. Syvertsen, M. L., et al., "Injection and Ignition Effects on Two-Stroke Direct-Injection Emissions and Efficiency," SAE Paper 961803, 1996.
6. Casarella, M. V., et al., "Spray Combustion and Emissions in a Direct-Injection Two Stroke Engine with Wall Stabilization of an Air-Assisted Spray," SAE Paper 970360, 1997.
7. Myers, J., et al., "On the Computation of Emissions from Exhaust Gas Composition Measurements," Journal of Engineering for Gas Turbines and Power, vol. 111, p. 410, 1989.
8. Spindt, R. S., "Air-Fuel Ratios from Exhaust Gas Analysis," SAE Paper 650507, 1965.
9. Gatowski, J. A., et al., "Heat Release Analysis of Engine Pressure Data," SAE Paper 841359, 1984.
10. Hoffman, J. A., et al., "A Technique for Obtaining Spatial and Temporal Mass Flux Measurements of a Pulsed Spray: a Description of the Hardware and Methodology," Rev. Sci. Instrum., 68 (11), November, 1997.
11. Hoffman, J. A., and Martin J. K., "Mass-Related Properties of Atomizers for Direct-Injection SI Engines," SAE Paper 980500, 1998.
12. Coates, S. W., and Lassanske, G. G., "Measurement and Analysis of Gaseous Exhaust Emissions from Recreational and Small Commercial Marine Craft," SAE Paper 901596, 1990.
13. Lancaster, D. R., "Diagnostic Investigation of Hydrocarbon Emissions from a Direct Injection Stratified Charge Engine with Early Injection," Paper C397/80, I. Mech. E. Conference on Stratified Charge Automotive Engines, 1980.
14. Frank, R. M., and Heywood, J. B., "Combustion Characterization in a Direct-Injection Stratified-Charge Engine and Implications on Hydrocarbon Emissions," SAE Paper 892058, 1989.
15. Giovanetti, A. J., et al., "Analysis of Hydrocarbon Emissions Mechanisms in a direct-Injection Spark-Ignition Engine," SAE Paper 830587, 1983.
16. Drake, M. C., et al., "Advanced Diagnostics for Minimizing Hydrocarbon Emissions From a Direct-Injection Gasoline Engine," Twenty-Sixth Symposium (International) on Combustion, The Combustion Institute, 1996.
17. Fansler, T. D., et al., "Individual-Cycle Measurements of Exhaust-Hydrocarbon Mass from a Direct-Injection Two-Stroke Engine," SAE Paper 980758, 1998.
18. Drake, M. C., et al., "Fuel Distributions in a Firing Direct-Injection Spark-Ignited Engine Using Laser-Induced Fluorescence Imaging," SAE Paper 950110, 1995.
19. Turns, S. R., An Introduction to Combustion, Concepts and Applications, McGraw-Hill, New York, 1996.
20. Frank, R. M., and Heywood, J. B., "The Importance of Injection System Characteristics on Hydrocarbon Emissions from a Direct-Injection Stratified-Charge Engine," SAE Paper 900609, 1990.
21. Frank, R. M., and Heywood, J. B., "The Effect of Piston Temperature on Hydrocarbon Emissions from a Spark-Ignited Direct-Injection Engine," SAE Paper 910558, 1991.
22. Ingham, M., et al., "In-cylinder Sampling of Hydrocarbons in a Texaco L-141 TCP Engine," SAE Paper 820361, 1982.
23. Kim, C., and Foster, D. E., "Aldehyde and Unburned Fuel Emissions Measurements from a Methanol-Fueled Texaco Stratified Charge Engine," SAE 852120, 1985.
24. Kollman, R. E., et al., "Exhaust Emission Characteristics of a Small 2-Stroke Cycle Spark Ignition Engine," SAE Paper 730159, 1973.
25. Yoon, K., et al., "An Experimental comparison Between Air-Assisted Injection System and High Pressure Injection System at 2-Stroke Engine," SAE Paper 950270, 1995.
26. Eng, j. A., et al., "experimental hydrocarbon Consumption Rate Correlations from a spark ignition Engine," SAE Paper 972888.
27. Drake, M. C., et al., "Crevice Flow and Combustion Visualization in a Direct-Injection Spark-ignition Engine Using Laser Imaging Techniques," SAE Paper 952454, 1995.
28. Linna, J.-R., and Hochgreb, S., "Analytical Scaling Model for Hydrocarbon Emissions From Fuel Absorption in Oil Layers in Spark Ignition Engines," Combust. Sci. and Tech., 109, pp. 205-226, 1995.
29. Martin, J. K., et al., "Burn modes and Prior-Cycle Effects on Cyclic Variations in Lean-Burn Spark-Ignition Engine Combustion, SAE Paper 880201, 1988.
30. Parrish, S. E., and Farrell, P. V., "Transient Spray Characteristics of a Direct-Injection Spark-Ignited Fuel Injector," SAE 970629, 1997.
31. Matekunas, F. A., "Modes and Measures of Cyclic Combustion Variability," SAE Paper 830337, 1983.
32. Fansler, T. D., et al., "Individual-Cycle Measurements of Exhaust-Hydrocarbon Mass for a Direct-Injection Two-Stroke Engine," SAE Paper 980758, 1998.