Quantitative Elastohydrodynamic Film-Forming for an Oil/Refrigerant System

Journal of Tribology

Volumn 139, Issue 6, 2017, Pages

  Bair, Scott ^a   Habchi, Wassim ^b,c   Baker, Mark ^d   Pallister, David M ^d  

^a GEORGIA INSTITUTE OF TECHNOLOGY   (United States)

^b LEBANESE AMERICAN UNIVERSITY   (Lebanon)

^c GEORGIA INSTITUTE OF TECHNOLOGY   (United States)

^d LUBRIZOL CORPORATION   (United States)

Author keywords

compressibility; elastohydrodynamic; film thickness; oil refrigerant lubrication; pressure viscosity

Indexed keywords

COMPRESSIBILITY; ELASTOHYDRODYNAMICS; FILM THICKNESS; REFRIGERANTS; TEMPERATURE DISTRIBUTION; VISCOSITY;

CONCENTRATED CONTACTS; DILUTION EFFECT; INCREASED TEMPERATURE; INLET PRESSURES; INLET TEMPERATURE; MEASUREMENTS OF; PRESSURE-VISCOSITY; TEMPERATURE DEPENDENCE;

ELASTOHYDRODYNAMIC LUBRICATION;

EID: 85021429745     PISSN: 07424787     EISSN: 15288897     Source Type: Journal    
DOI: 10.1115/1.4036171     Document Type: Article

References (30)

1. Liu, Y., Wang, Q. J., Wang, W., Hu, Y., Zhu, D., Krupka, I., and Hartl, M., 2006, "EHL Simulation Using the Free-Volume Viscosity Model," Tribol. Lett., 23(1), pp. 27-37
2. Liu, Y., Wang, Q. J., Bair, S., and Vergne, P., 2007, "A Quantitative Solution for the Full Shear-Thinning EHL Point Contact Problem Including Traction," Tribol. Lett., 28(2), pp. 171-181
3. Liu, Y., Wang, Q. J., Krupka, I., Hartl, M., and Bair, S., 2008, "The Shear-Thinning Elastohydrodynamic Film Thickness of a Two-Component Mixture," ASME J. Tribol., 130(2), p. 021502
4. Krupka, I., Bair, S., Kumar, P., Khonsari, M. M., and Hartl, M., 2009, "An Experimental Validation of the Recently Discovered Scale Effect in Generalized Newtonian EHL," Tribol. Lett., 33(2), pp. 127-135
5. Krupka, I., Kumar, P., Bair, S., Khonsari, M. M., and Hartl, M., 2010, "The Effect of Load (Pressure) for Quantitative EHL Film Thickness," Tribol. Lett., 37(3), pp. 613-622
6. Habchi, W., Bair, S., Qureshi, F., and Covitch, M., 2013, "A Film Thickness Correction Formula for Double-Newtonian Shear-Thinning in Rolling EHL Circular Contacts," Tribol. Lett., 50(1), pp. 59-66
7. Habchi, W., Vergne, P., Bair, S., Andersson, O., Eyheramendy, D., and Morales-Espejel, G. E., 2010, "Influence of Pressure and Temperature Dependence of Thermal Properties of a Lubricant on the Behaviour of Circular TEHD Contacts," Tribol. Int., 43(10), pp. 1842-1850
8. Habchi, W., Bair, S., and Vergne, P., 2013, "On Friction Regimes in Quantitative Elastohydrodynamics," Tribol. Int., 58, pp. 107-117
9. Bjorling, M., Habchi, W., Bair, S., Larsson, R., and Marklund, P., 2013, "Towards the True Prediction of EHL Friction," Tribol. Int., 66, pp. 19-26
10. Bjorling, M., Habchi, W., Bair, S., Larsson, R., and Marklund, P., 2014, "Friction Reduction in Elastohydrodynamic Contacts by Thin-Layer Thermal Insulation," Tribol. Lett., 53(2), pp. 477-486
11. Bair, S., Habchi, W., Sperka, P., and Hartl, M., 2016, "Quantitative Elastohydrodynamic Film Forming for a Gear Oil With Complex Shear-Thinning," Proc. Inst. Mech. Eng., Part J, 230(3), pp. 289-299
12. Tuomas, R., and Isaksson, O., 2009, "Measurement of Lubrication Conditions in a Rolling Element Bearing in a Refrigerant Environment," Ind. Lubr. Tribol., 61(2), pp. 91-99
13. Jonsson, U. J., and Hansson, N., 1998, "Lubrication Limits of Rolling Element Bearings in Refrigeration Compressors," International Compressor Engineering Conference (ICEC), West Lafayette, IN, July 14-17, Paper No. 1228
14. Bair, S., 2000, "Pressure-Viscosity Behavior of Lubricants to 1.4 GPa and Its Relation to EHD Traction," Tribol. Trans., 43(1), pp. 91-99
15. Geller, V. Z., Paulaitis, M. E., Bivens, D. B., and Yokozeki, A., 1996, "Viscosities of HFC-32 and HFC-32/Lubricant Mixtures," Int. J. Thermophys., 17(1), pp. 75-83
16. Comunas, M. J., Baylaucq, A., Boned, C., and Fernandez, J., 2004, "Dynamic Viscosity for HFC-134a Polyether Mixtures Up to 373.15 K and 140 MPa at Low Polyether Concentration. Measurements and Modeling," Ind. Eng. Chem. Res., 43(3), pp. 804-814
17. Jonsson, U. J., and Lilje, K. C., 1998, "Elastohydrodynamic Lubrication Properties of Polyol Ester Lubricants-R134a Mixtures," International Compressor Engineering Conference (ICEC), West Lafayette, IN, July 14-17, Paper No. 1227
18. Bair, S., 2015, "A Critical Evaluation of Film Thickness-Derived Pressure-Viscosity Coefficients," Lubr. Sci., 27(6), pp. 337-346
19. Vergne, P., Fillot, N., Bouscharain, N., Devaux, N., and Morales-Espejel, G. E., 2015, "An Experimental and Modeling Assessment of the HCFC-R123 Refrigerant Capabilities for Lubricating Rolling EHD Circular Contacts," Proc. Inst. Mech. Eng., Part J, 229(8), pp. 950-961
20. Bair, S., 2016, "A New High-Pressure Viscometer for Oil/Refrigerant Solutions and Preliminary Results," Tribol. Trans. (accepted)
21. Bair, S., Baker, M., and Pallister, D. M., 2016, "Revisiting the Compressibility of Oil/Refrigerant Lubricants," ASME J. Tribol., 139(2), p. 024501
22. Laesecke, A., and Bair, S., 2011, "High-Pressure Viscosity Measurements of 1, 1, 1, 2-Tetrafluoroethane," Int. J. Thermophys., 32(5), pp. 925-941
23. Bair, S., Mary, C., Bouscharain, N., and Vergne, P., 2013, "An Improved Yasutomi Correlation for Viscosity at High Pressure," Proc. Inst. Mech. Eng., Part J, 227(9), pp. 1056-1070
24. McEwen, E., 1952, "The Effect of Variation of Viscosity With Pressure on the Load-Carrying Capacity of the Oil Film Between Gear-Teeth," J. Inst. Pet., 38(344-345), pp. 646-672
25. Andrade, E. D. C., 1930, "The Viscosity of Liquids," Nature, 125(3148), pp. 309-310
26. Grunberg, L., and Nissan, A. H., 1949, "Mixture Law for Viscosity," Nature, 164(4175), pp. 799-800
27. Habchi, W., Eyheramendy, D., Vergne, P., and Morales-Espejel, G. E., 2012, "Stabilized Fully-Coupled Finite Elements for Elastohydrodynamic Lubrication Problems," Adv. Eng. Software, 46(1), pp. 4-18
28. Gunsel, S., and Pozebanchuk, M., 1999, "Elastohydrodynamic Lubrication With Polyolester Lubricants and HFC Refrigerants," Air Conditioning and Refrigeration Technology Institute, Arlington, VA, Vol. 1, Final Report No. DOE/CE/23810-102
29. Venner, C. H., and Bos, J., 1994, "Effects of Lubricant Compressibility on the Film Thickness in EHL Line and Circular Contacts," Wear, 173(1-2), pp. 151-165
30. Habchi, W., and Bair, S., 2012, "Quantitative Compressibility Effects in Thermal Elastohydrodynamic Circular Contacts," ASME J. Tribol., 135(1), p. 011502.