Measurement of the thermal elongation of high speed spindles in real time using a cat's eye reflector based optical sensor

Sensors and Actuators, A: Physical

Volumn 221, Issue , 2015, Pages 154-160

  Yan, Zih Siang ^a   Lin, Wen Han ^b   Liu, Chien Hung ^a  

^a NATIONAL CHUNG HSING UNIVERSITY   (Taiwan)

^b NATIONAL FORMOSA UNIVERSITY   (Taiwan)

Author keywords

Cat's eye; High speed spindles; Laser diode; Photodiode detector; Thermal elongation

Indexed keywords

MACHINE TOOLS; OPTICAL SENSORS; PHOTODIODES; REFLECTION; SEMICONDUCTOR LASERS;

CAT'S EYES; HIGH-SPEED SPINDLE; LOW FREQUENCY RANGE; PHOTODIODE DETECTOR; QUADRANT PHOTODIODE DETECTORS; REAL TIME MEASUREMENTS; STANDARD DEVIATION; THERMAL ELONGATION;

ELONGATION;

EID: 84919933377     PISSN: 09244247     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.sna.2014.11.003     Document Type: Article

References (12)

1. R. Ramesh, M.A. Mannan, and A.N. Poo Error compensation in machine tools - a review: Part I: geometric, cutting-force induced and fixture-dependent errors Int. J. Mach. Tools Manuf. 40 2000 1235 1256
2. D.A. Krulewich Temperature integration model and measurement point selection for thermally induced machine tool errors Mechatronics 8 1998 395 412
3. J. Bryan International status of thermal error research (1990) CIRP Ann. - Manuf. Technol. 39 1990 645 656
4. T. Moriwaki, A. Horiuchi, and K. Okuda Effect of cutting heat on machining accuracy in ultra-precision diamond turning CIRP Ann. - Manuf. Technol. 39 1990 81 84
5. G. Spur, E. Hoffmann, Z. Paluncic, K. Benzinger, and H. Nymoen Thermal behaviour optimization of machine tools CIRP Ann. - Manuf. Technol. 37 1988 401 405
6. J.S. Chen, J.X. Yuan, J. Ni, and S.M. Wu Real-time compensation for time-variant volumetric errors on a matching center J. Eng. Ind. 115 1993 472 479
7. N. Srinivasa, J.C. Ziegert, and C.D. Mize Spindle thermal drift measurement using the laser ball bar Precis. Eng. 18 1996 118 128
8. S. Li, Y. Zhang, and G. Zhang A study of pre-compensation for thermal errors of NC machine tools Int. J. Mach. Tools Manuf. 37 1997 1715 1719
9. T.J. Ko, T.-W. Gim, and J.-Y. Ha Particular behavior of spindle thermal deformation by thermal bending Int. J. Mach. Tools Manuf. 43 2003 17 23
10. R. Zhu, S. Dai, Y. Zhu, X. Wu, and Y. Guo Thermal error analysis and error prediction modeling on a machine tool IEEM 2008. IEEE International Conference on Industrial Engineering and Engineering Management 2008 2056 2060
11. C.H. Liu, W.Y. Jywe, S.C. Tzeng, and Y.S. Lin Development of a novel optical measurement system for the error verification of a rotating spindle Opt. Eng. 44 2005 097003 97006
12. C.H. Liu, W.Y. Jywe, and H.W. Lee Development of a simple test device for spindle error measurement using a position sensitive detector Meas. Sci. Technol. 15 2004 1733