Development of low-profile piezoelectric energy harvester for high load application

2013 1st IEEE Conference on Technologies for Sustainability, SusTech 2013

Volumn , Issue , 2013, Pages 120-125

  Purviance, Thorin ^a   Wickler, Spencer ^a   Clayson, Keith ^a   Barnes, Travis ^a   Mo, Changki ^a  

^a WASHINGTON STATE UNIVERSITY   (United States)

Author keywords

compressive stress; cymbal structured; Energy harvesting; low profile; piezoelectric; ring and stack transducers

Indexed keywords

CYMBAL-STRUCTURED; ENERGY HARVESTING DEVICE; LOW-PROFILE; PIEZOELECTRIC; PIEZOELECTRIC ENERGY HARVESTERS; PIEZOELECTRIC LAYERS; PIEZOELECTRIC RINGS; PIEZOELECTRIC STACK;

COMPRESSIVE STRESS; DESIGN; ENERGY HARVESTING; METALS; PIEZOELECTRICITY; SUSTAINABLE DEVELOPMENT;

PIEZOELECTRIC TRANSDUCERS;

EID: 84887570887     PISSN: None     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1109/SusTech.2013.6617308     Document Type: Conference Paper

References (17)

1. D. Arnold, W. Kinsel, W. Clark, and C. Mo, "Exploration of New Cymbal Design in Energy Harvesting, " Proc. of SPIE, Smart Structures and Materials, Mar. 6-10, San Diego, CA, 2011.
2. C. Mo, D. Arnold, W. Kinsel, and W. Clark, "Unimorph PZT Cymbal Design in Energy Harvesting, " ASME Conf. on Smart Materials Adaptive Structures and Intelligent Systems, Sept. 18-21, Scottsdale, AZ., 2011.
3. C. Mo, D. Arnold, W. Kinsel, and W. Clark, "Modeling and Experimental Validation of Unimorph PZT Cymbal Design in Energy Harvesting, " Journal of Intelligent Material Systems and Structures, Vol. 24(7), pp. 828-836, 2013.
4. C. Mo, S. Jordan, and W. Clark, "Bimorph Piezoelectric Cymbal Design in Energy Harvesting, " ASME Conf. on Smart Materials, Adaptive Structures and Intelligent Systems, Stone Mountain, GA, 19-21 September, 2012.
5. H. Kim, A. Bartra, S. Priya, K. Uchino, and D. Markley, "Energy Harvesting Using a Piezoelectric Cymbal Transducer in Dynamic Environment, " Japanese Journal of Applied Physics, Vol. 43(9A), pp. 6178-6183, 2004.
6. H. Kim, S. Priya, K. Uchino, and R. Newham, "Piezoelectric Energy Harvesting under High Pre-Stressed Cyclic Vibrations, " Journal of Electroceramics, Vol. 15, pp. 27-34, 2005.
7. H. Kim, S. Priya, and K. Uchino, "Modeling of Piezoelectric Energy Harvesting Using Cymbal Transducers, " Japanese Journal of Applied Physics, Vol. 45(7), pp. 5836-5840, 2006.
8. J. Yuan, X. Shan, T. Xie, and W. Chen, "Modeling and Improvement of a Cymbal Transducer in Energy Harvesting, " Journal of Intelligent Material Systems and Structures, Vol. 21(8), pp. 765-771, 2010.
9. S. Platt, S. Farritor, K. Garvin, and H. Haider, "The Use of Piezoelectric Ceramics for Electric Power Generation Within Orthopedic Implants, " IEEE/ASME Trans on Mechatronics, Vol. 10(4), pp. 455-461, 2005.
10. S. Platt, S. Farritor, and H. Haider, "On Low-Frequency Electric Power Generation With PZT Ceramics, " IEEE/ASME Trans on Mechatronics, Vol. 10(2), pp. 240-252, 2005.
11. H. Chen, C. Jia, C. Zhang, Z. Wang, and C. Liu, "Power Harvesting With PZT Ceramics, " IEEE International Symposium on Circuits and Systems, 27-30 May, New Orleans, LA., pp. 557-560, 2007.
12. D. D'Lima, S. Patil, N. Steklov, J. Slamin, and C. Colwell, "Tibial Forces Measured In Vivo after Total Knee Arthroplasty, " The Journal of Arthroplasty, Vol. 21(2), pp. 255-262, 2006.
13. B. Kirking, J. Krevolin, C. Townsend, C. Colwell, and D. D'Lima, "A multiaxial force-sensing implantable tibial prosthesis, " Journal of Biomechanics, Vol. 39, pp. 1744-1751, 2006.
14. S. Sivarasu and M. Lazar, "Finite Element Analysis of a Novel High Flexion Knee (Ti-UHMWPE) used in Total Knee Arthroplasty, " The Internet Journal of Bioengineering, Vol. 4(1), 2009.
15. A. Ugural, Stresses in Plates and Shells, 2nd edition, Boston, McGraw-Hill, Inc, 1999.
16. W. Young, Roark's Formulas for Stress &Strain, McGraw-Hill, Inc, New York, 6th Ed., 1989.
17. IEEE Standard 176, IEEE Standards on Piezoelectricity, The Institute of Electrical and Electronics Engineers, 1978