Regeneration modes and peak temperatures in a diesel particulate filter

Chemical Engineering Journal

Volumn 232, Issue , 2013, Pages 541-554

  Yu, Mengting ^a   Luss, Dan ^a   Balakotaiah, Vemuri ^a  

^a UNIVERSITY OF HOUSTON   (United States)

Author keywords

DPF regeneration; DTI; Peak temperature; Regeneration mode; Stationary feed

Indexed keywords

DIESEL PARTICULATE FILTERS; DPF REGENERATIONS; DTI; PEAK TEMPERATURES; REGENERATION MODE; REGENERATION TEMPERATURE; TECHNOLOGICAL CHALLENGES; TEMPERATURE DIFFERENCES;

COMBUSTION; FUEL FILTERS; SILICATE MINERALS; TENSORS;

AIR FILTERS;

EID: 84883511712     PISSN: 13858947     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.cej.2013.08.006     Document Type: Article

References (22)

1. N. Higuchi, S. Mochida, M. Kojima, Optimized Regeneration Conditions of Ceramic Honeycomb Diesel Particulate Filters, SAE, 1983, 830078.
2. J.M. Seo, W.S. Park, M.J. Lee, The Best Choice of Gasoline/Diesel Particulate Filter to Meet Future Particulate Matter Regulation, SAE, 2012, 2012-01-1255.
3. Yu M., Luss D., Balakotaiah V. Analysis of flow distribution and heat transfer in a diesel particulate filter. Chem. Eng. J. 2013, 226:68-78.
4. Yu M., Luss D., Balakotaiah V. Analysis of ignition in a diesel particulate filter. Catal. Today 2013, 2. http://dx.doi.org/10.1016/j.cattod.2013.05.003.
5. Koltsakis G., Haralampous O., Depcik C., Ragone J.C. Catalyzed diesel particulate filter modeling. Rev. Chem. Eng. 2013, 29:1-61.
6. Bissett E.J. Mathematical model of the thermal regeneration of a wall-flow monolith diesel particulate filter. Chem. Eng. Sci. 1984, 39:1233-1244.
7. Haralampous O.A., Koltsakis G.C. Oxygen diffusion modeling in diesel particulate filter regeneration. AIChE J. 2004, 50(9):2008-2019.
8. Gundlapally S.R., Balakotaiah V. Heat and mass transfer correlations and bifurcation analysis of catalytic monoliths with developing flows. Chem. Eng. Sci. 2011, 66:1879-1892.
9. T. Boger, D. Rose, I. Tilgner, A.K. Heibel, Regeneration Strategies for An Enhanced Thermal Management of Oxide Diesel Particulate Filters, SAE, 2008-01-0328.
10. Koltsakis G.C., Stamatelos A.M. Modeling thermal regeneration of wall-flow diesel particulate traps. AIChE J. 1996, 42:1662-1672.
11. Bissett E.J., Shadman F. Thermal regeneration of diesel-particulate monolithic filters. AIChE J. 1985, 31:753-758.
12. Deemter J.J.V. Heat and mass transport in a fixed catalyst bed during regeneration. Ind. Eng. Chem. 1953, 1227-1233.
13. Y. Miyairi, S. Miwa, F. Abe, Z. Xu, Y. Nakasuji, Numerical study on forced regeneration of wall-flow diesel particulate filters, SAE, 2001, 2001-01-0912.
14. Chen K., Martirosyan K.S., Luss D. Wrong-way behavior of soot combustion in a planar diesel particulate filter. Ind. Eng. Chem. Res. 2009, 48:8451-8456.
15. Chen K., Luss D. Temperature rise during stationary and dynamic regeneration of a diesel particulate filter. Rev. Chem. Eng. 2010, 26:133-147.
16. R. Zhan, Y. Huang, M. Khair, Methodologies to control DPF uncontrolled regenerations, SAE, 2006, 2006-01-1090.
17. G.C. Koltsakis, O.A. Haralampous, Z.C. Samaras, L. Kraemer, F. Heimlich, K. Behnk, Control Strategies for Peak Temperature Limitation in DPF Regeneration Supported by Validated Modeling, SAE, 2007, 2007-01-1127.
18. Chen K., Martirosyan K.S., Luss D. Hot zones formation during regeneration of diesel particulate filters. AIChE J. 2011, 57:497-506.
19. Chen K., Luss D. Temperature excursions in diesel particulate filters: response to shift to idle. Ind. Eng. Chem. Res. 2011, 50:832-842.
20. Yu M., Luss D. Inlet cone effect on diesel particulate filter regeneration upon a rapid shift to idle. Ind. Eng. Chem. Res. 2012, 51:11355-11366.
21. T. Mizutani, Y. Watanabe, K. Yuuki,; S. Hashimoto, T. Hamanaka, J. Kawashima, Soot Regeneration Model for SiC-DPF System Design, SAE, 2004, 2004-01-0159.
22. T. Boger, I.-C. Tilgner, M. Shen, Y. Jiang, Oxide based particulate filters for light-duty diesel applications: impact of the filter length on the regeneration and pressure drop behavior, SAE, 2008, 2008-01-0485.