A comparison of three-dimensional embedded strain transducers, compression tested within the same strain field while offset at an angle with the principal axes

Strain

Volumn 48, Issue 5, 2012, Pages 375-387

  O'Driscoll, C ^a   O'Donnell, E ^a   Stanley, W ^a   O'Donnell, P ^a   Little, E G ^a  

^a UNIVERSITY OF LIMERICK   (Ireland)

Author keywords

3D embedded strain gauge transducers; principal strains; strain tensor

Indexed keywords

MONTE CARLO SIMULATION; PRINCIPAL AXES; PRINCIPAL STRAIN; STRAIN FIELDS; STRAIN TENSOR;

ESTIMATION; MONTE CARLO METHODS; TENSORS; THREE DIMENSIONAL; TRANSDUCERS;

STRAIN;

EID: 84866739998     PISSN: 00392103     EISSN: 14751305     Source Type: Journal    
DOI: 10.1111/j.1475-1305.2012.00833.x     Document Type: Article

References (19)

1. McTague, D., and, Little, E. G., (1992) Assessment of strain gradients affecting the performance of 3D strain rosettes-relevant to the analysis of the cement mantle strains in total hip replacements. Strain 28, 143-151.
2. Rossetto, S., Bray, A., and, Levi, R., (1975) Three-dimensional strain rosettes; pattern selection and performance evaluation. Exp. Mech. 15, 375-381.
3. Trench, P., Little, E. G., Tocher, D., O'Donnell, P., and, Lawlor, V., (2009) The performance of three-dimensional strain rosettes evaluated when embedded into a sphere. Strain 45, 149-159.
4. Baker, W. E., and, Dove, R. C., (1963) Construction and evaluation of a three-dimensional strain rosette. Exp. Mech. 3, 201-206.
5. Brandt, A. M., (1973) Nine-gauges device for strain measurements inside concrete. Strain 9, 122-124.
6. Mulvihill, D. M., O'Driscoll, C., Stanley, W., and, Little, E. G., (2009) A comparison of various patterns of three-dimensional strain rosettes. Strain 47, e447-e456. doi: 10.1111/j.1475-1305.2009.00634.
7. Little, E. G., (1982) Effects of self heating when using a continuous bridge voltage for strain gauging epoxy models. Strain 18, 131-135.
8. Little, E. G., Tocher, D., Colgan, D., and, O'Donnell, P., (2005) An analysis of the factors influencing the data derived from a plug type three-dimensional strain rosette under compression and torsion. Strain 41, 193-202.
9. Box, G. E. P., Hunter, J. S., and, Hunter, W. G., (1978) Statistics for experimenters: an introduction to design, data analysis, and model building. Wiley series in probability and mathematical statistics. Applied Probability and Statistics. Wiley, New York, Chichester: xviii, 653.
10. Ryan, B., Little, E. G., Murphy, E., and, Griffin, J., (2007) Factorial design to establish key factors influencing results from strain gauges in tests on epoxy models. Strain 43, 340-344.
11. Cristofolini, L., and, Viceconti, M., (2000) Development and validation of a technique for strain measurement inside polymethyl methacrylate. J. Strain Anal. Eng. Des. 35, 21-33.
12. Ajovalasit, A., (2005) Embedded strain gauges: effect of the stress normal to the grid. Strain 41, 95-103.
13. Little, E. G., Tocher, D., and, O'Donnell, P., (1990) Strain gauge reinforcement of plastics. Strain 26, 91-98.
14. Pople, J., (1979) BSSM Strain Measurement Reference Book. British Society of Strain Measurement, Newcastle upon Tyne [Tyne and Wear Metropolitan County].
15. Derenne, M., and, Bazergui, A., (1971) Advances in the embedded strain gauge technique with an application to contact problems. Exp. Mech. 11, 105-112.
16. Barbato, G., and, Little, E. G., (1984) Performance analysis of the three-dimensional strain rosettes using computer simulation. Technical note. Istituto di Metrologia, Turin, Italy.
17. Rossetto, S., Bray, A., and, Levi, R.,. (1974) Uncertainties and errors in magnitude and direction of principal strains evaluated with three-dimensional strain rosettes. Proc. Fifth Int. Conf. Exp. Stress Analysis. Udine, Italy.
18. Colgan, D., McTague, D., ODonnell, P., and, Little, E. G., (1996) Three-dimensional embedded strain gauge analysis of the effect of collared versus collarless prostheses on cement mantle stresses in a femoral model of a total hip replacement. J. Strain Anal. Eng. Des. 31, 329-339.
19. Colgan, D., McTague, D., ODonnell, P., and, Little, E. G., (1996) The effect of the transverse component of the hip reaction on cement mantle stresses in a model of an implanted Exeter(TM) prosthesis. J. Strain Anal. Eng. Des. 31, 205-214.