2-Scale topography dry electrode for biopotential measurements

Proceedings of the Annual International Conference of the IEEE Engineering in Medicine and Biology Society, EMBS

Volumn , Issue , 2011, Pages 1892-1895

  Vanlerberghe, F ^a,b   De Volder, M ^c   De Beeck, M Op ^b,c   Penders, J ^d   Reynaerts, D ^b   Puers, R ^b,c   Van Hoof, C ^b,c  

^a IMEC   (Belgium)

^b UNIVERSITY OF LEUVEN   (Belgium)

^c IMEC   (Netherlands)

^d HOLST CENTRE   (Netherlands)

Author keywords

[No Author keywords available]

Indexed keywords

BIOPOTENTIAL MEASUREMENT; COATED ELECTRODES; COATING MATERIAL; COMPARISON STUDY; CONDUCTIVE COATINGS; DRY ELECTRODE; ELECTRODE IMPEDANCE; IMPEDANCE CHARACTERIZATION; IMPEDANCE MEASUREMENT; MICRONEEDLES; SKIN LAYER;

BIOELECTRIC POTENTIALS; COATED WIRE ELECTRODES; COATINGS; NEEDLES; SILVER HALIDES;

ELECTRODES;

ARTICLE; ELECTROCARDIOGRAPHY; ELECTRODE; ELECTROENCEPHALOGRAPHY; EQUIPMENT; EQUIPMENT DESIGN; EQUIPMENT FAILURE; IMPEDANCE; NEEDLE; REPRODUCIBILITY; SENSITIVITY AND SPECIFICITY; SURFACE PROPERTY;

ELECTRIC IMPEDANCE; ELECTROCARDIOGRAPHY; ELECTRODES; ELECTROENCEPHALOGRAPHY; EQUIPMENT DESIGN; EQUIPMENT FAILURE ANALYSIS; NEEDLES; REPRODUCIBILITY OF RESULTS; SENSITIVITY AND SPECIFICITY; SURFACE PROPERTIES;

EID: 84055184515     PISSN: 1557170X     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.1109/IEMBS.2011.6090536     Document Type: Conference Paper

References (14)

1. Chi, Y.M.; Tzyy-Ping Jung; Cauwenberghs, G.;, "Dry-Contact and Noncontact Biopotential Electrodes: Methodological Review," Biomed. Eng., IEEE Reviews in, vol.3, no., pp.106-119, 2010
2. Sullivan, T.J.; Deiss, S.R.; Cauwenberghs, G.;, "A Low-Noise, Non-Contact EEG/ECG Sensor," BIOCAS 2007. IEEE, vol., no., pp.154-157, 27-30 Nov. 2007
3. Yu. M. Chi and G. Cauwenberghs. "Micropower non-contact eeg electrode with active common-mode noise suppression and input capacitance cancellation." EMBC 2009. pp 4218-4221, 3-6 2009
4. Yu M. Chi, Patrick Ng, Christoph Maier, and Gert Cauwenberghs. "Wireless non-contact biopotential electrodes." In Wireless Health 2010. ACM, New York, NY, USA, 194-195
5. R. Matthews, N. J. McDonald, P. Hervieux, P. J. Turner, and M. A. Steindorf. "A wearable physiological sensor suite for unobtrusive monitoring of physiological and cognitive state." In EMBS 2007, pp 5276-5281, 22-26 2007
6. N.S. Dias, J.P. Carmo, A. Ferreira da Silva, P.M. Mendes, J.H. Correia," New dry electrodes based on iridium oxide (IrO) for noninvasive biopotential recordings and stimulation", Sensors and Actuators A, 164 (2010), 28-34
7. W.C. Ng et al., "Micro-spike EEG electrode and the vacuumcasting technology for mass production", J. Mater. Process. Technol., Vol. 209, pp. 4434-4438, 2009
8. P. Griss, H.K. Tolvanen-Laasko, P. Meriläinen and G. Stemme, "Characterization of micromachined spiked biopotential electrodes", IEEE Trans. Biomed. Eng., 49, no. 6, 597-604, 2002.
9. F Pérennès et al. "Sharp beveled tip hollow microneedle arrays fabricated by LIGA and 3D soft lithography with polyvinyl alcohol", J. Micromech. Microeng. 16, 473, 2006
10. Gabriela Voskerician, et al., "Biocompatibility and biofouling of MEMS drug delivery devices", Biomaterials 24 (2003) 1959-1967
11. L.A. Geddes, L.E. Baker, A.G. Moore, "Optimum Electrolytic Chloriding of Silver Electrodes", Med. & Biol. Eng, vol. 7, pp. 49-56, 1969
12. ANSI/AAMI EC12:2000/(R)2010
13. nd ICEEE and XI CIE, Mexico, Sept. 7-9, 2005
14. Jorcin J, Orazem M E, Pébère N and Tribollet B, "CPE analysis by local electrochemical impedance spectroscopy", Electrochim. Acta 51 1473-9 2006