On the parametrisation of turbocharger power and heat transfer models

IFAC Proceedings Volumes (IFAC-PapersOnline)

Volumn 43, Issue 7, 2010, Pages 210-215

  Mrosek, Matthias ^a   Isermann, Rolf ^a  

^a DARMSTADT UNIVERSITY OF TECHNOLOGY   (Germany)

Author keywords

Heat transfer; Quasi stationary measurement; Turbocharger modelling

Indexed keywords

DIESEL ENGINES; SUPERCHARGERS; TURBOMACHINERY;

AERODYNAMIC POWER; ANALYTICAL ANALYSIS; EULER'S EQUATION; HEAT TRANSFER MODEL; MEASURED TEMPERATURES; PHYSICAL PARAMETERS; POLYNOMIAL APPROACH; QUASI-STATIONARY;

HEAT TRANSFER;

EID: 80051883393     PISSN: 14746670     EISSN: None     Source Type: Conference Proceeding    
DOI: 10.3182/20100712-3-DE-2013.00075     Document Type: Conference Paper

References (11)

1. Fehl, G. (1992). Entwicklung einer Meßstrategie zur kontinuierlichen Erfassung von Kennlinien auf Motorenprüfständen. Dissertation, Technische Hochschule Darmstadt.
2. Justi, E.W. (1938). Spezifische Wärme - Enthalpie, Entropie und Dissoziation technischer Gase. Springer, Berlin.
3. Lutz, O. and Wolf, F. (1938). IS-Tafel für Luft und Verbrennungsgase. Springer, Berlin.
4. Mrosek, M. and Isermann, R. (2009). System properties and control of turbocharged Diesel engines with high-and low-pressure EGR. In 2009 IFAC Workshop on Engine and Powertrain Control, Simulation and Modeling. Rueil-Malmaison, France.
5. Mrosek, M., Zahn, S., and Isermann, R. (2010). Parameter estimation for physical based air path models of turbocharged Diesel engines - An experience based guidance. SAE International Journal of Engines, 2(2), 570-583.
6. Pischinger, R., Klell, M., and Sams, T. (2002). Thermodynamik der Verbrennungskraftmaschine (Der Fahrzeugantrieb). Springer, Wien, New York, 2. edition.
7. Rautenberg, M., Mobarak, A., and Malobabic, M. (1983). Influence of heat transfer between turbine and compressor on the performance of small turbochargers. In International Gas Turbine Congress, JSME Paper 83-TOKYO-IGTC-73. Tokyo.
8. Schwarte, A., Hack, L., Isermann, R., Nitzke, H.G., Jeschke, J., and Piewek, J. (2004). Automated calibration of engine control units with continuous engine data recording. In Steuerung und Regelung von Fahrzeugen und Motoren - AUTOREG 2004, 651-663. Wiesloch.
9. Stodola, A. (1945). Steam and Gas Turbines. McGraw-Hill, New York. Reprinted by Peter Smith.
10. Zahn, S. (2010). Elektronisches Management motorischer Fahrzeugantriebe: Elektronik-Architektur, Modellbildung, Regelung und Diagnose von Verbrennungsmotoren, Getrieben und Elektroantrieben, chapter Mittelwert- und Arbeitstaktsynchrone Simulation von Dieselmotoren. Vieweg+Teubner.
11. Zahn, S. and Isermann, R. (2008). Crank angle synchronous modelling and real-time simulation of diesel engines for ECU function development and testing. In 9th Int. Symp. On Advanced Vehicle Control. Kobe.