Totem-pole boost bridgeless PFC rectifier with simple zero-current detection and full-range ZVS operating at the boundary of DCM/CCM

IEEE Transactions on Power Electronics

Volumn 26, Issue 2, 2011, Pages 427-435

  Su, Bin ^a   Zhang, Junming ^a   Lu, Zhengyu ^a  

^a ZHEJIANG UNIVERSITY   (China)

Author keywords

Boundary; bridgeless; high efficiency; low common mode (CM) noise; low conduction losses; power factor correction (PFC); reverse recovery; soft transition; totem pole; zero current detection; zero voltage switching (ZVS) range extension

Indexed keywords

BOUNDARY; BRIDGELESS; HIGH EFFICIENCY; LOW COMMON-MODE (CM) NOISE; LOW CONDUCTION LOSSES; POWER FACTOR CORRECTION (PFC); REVERSE RECOVERY; SOFT TRANSITION; TOTEM POLE; ZERO-CURRENT DETECTION; ZERO-VOLTAGE-SWITCHING (ZVS) RANGE EXTENSION;

ELECTRIC CURRENT MEASUREMENT; ELECTRIC POWER FACTOR; MOSFET DEVICES; POLES; TRANSDUCERS; ZERO VOLTAGE SWITCHING;

ELECTRIC RECTIFIERS;

EID: 79951539664     PISSN: 08858993     EISSN: None     Source Type: Journal    
DOI: 10.1109/TPEL.2010.2059046     Document Type: Article

References (24)

1. R. Martinez and P. N. Enjeti, "A high-performance single-phase rectifier with input power factor correction," IEEE Trans. Power Electron., vol (Pubitemid 126774087)
2. L. Huber, J. Yungtaek, and M. M. Jovanovic, "Performance evaluation of bridgeless PFC boost rectifiers," IEEE Trans. Power Electron., vol. 23, no. 3, pp. 1381-1390, May 2008. (Pubitemid 351756711)
3. X.Xiaoni,L.Teng, J. Zeng,W. Hongyang, andY. Jianping, "Asymmetrical H-PFC for low line applications," in Proc. IEEE Power Electron. Spec. Conf., 2007, pp. 1077-1081.
4. D. Tollik and A. Pietkiewicz, "Comparative analysis of 1-phase active power factor correction topologies," in Proc. IEEE Telecommun. Energy Conf., 1992, pp. 517-523.
5. Y. Gang, H. Haiyang, D. Yan, and H. Xiangning, "A ZVT PWM three level boost converter for power factor preregulator," in Proc. IEEE Power Electron. Spec. Conf., 2006, pp. 1-5.
6. J. C. Salmon, "Circuit topologies for PWM boost rectifiers operated from 1-phase and 3-phase AC supplies and using either single or split DC rail voltage outputs," in Proc. IEEE Appl. Power Electron. Conf. Expo., 1995, pp. 473-479.
7. W. Y. Choi, J.M. Kwon, and B. H. Kwon, "Bridgeless dual-boost rectifier with reduced diode reverse-recovery problems for power-factor correction," IET Power Electron., vol. 1, no. 2, pp. 194-202, Jun. 2008.
8. E. H. Ismail, "Bridgeless SEPIC rectifier with unity power factor and reduced conduction losses," IEEE Trans. Ind. Electron., vol. 56, no. 4, pp. 1147-1157, Apr. 2009.
9. J. Yungtaek and M. M. Jovanovic, "A bridgeless PFC boost rectifier with optimized magnetic utilization," IEEE Trans. Power Electron., vol. 24, no. 1, pp. 85-93, Jan. 2009.
10. A. F. de Souza and I. Barbi, "High power factor rectifier with reduced conduction and commutation losses," in Proc. IEEE Telecommun. Energy Conf., Copenhagen, Denmark, 1999, p. 5.
11. J. S. Lai and D. Chen, "Design consideration for power factor correction boost converter operating at the boundary of continuous conduction mode and discontinuous conductionmode," in Proc. IEEE Appl. Power Electron. Conf. Expo., 1993, pp. 267-273.
12. L. Huber, B. T. Irving, andM.M. Jovanovic, "Open-loop control methods for interleaved DCM/CCM boundary boost PFC converters," IEEE Trans. Power Electron., vol. 23, no. 4, pp. 1649-1657, Jul. 2008.
13. L. Huber, B. T. Irving, and M. M. Jovanovic, "Effect of valley switching and switching-frequency limitation on line-current distortions of DCM/CCM boundary boost PFC converters," IEEE Trans. Power Electron., vol. 24, no. 2, pp. 339-347, Feb. 2009.
14. J. Zhang, J. Shao, P. Xu, F. C. Lee, and M. M. Jovanovic, "Evaluation of input current in the critical mode boost PFC converter for distributed power systems," in Proc. IEEE Appl. Power Electron. Conf. Expo., 2001, pp. 130-136. (Pubitemid 32327376)
15. B. T. Irving, J. Yungtaek, and M. M. Jovanovic, "A comparative study of soft-switched CCM boost rectifiers and interleaved variable-frequency DCM boost rectifier," in Proc. IEEE Appl. Power Electron. Conf. Expo., 2000, pp. 171-177.
16. L. Huber, B. T. Irving, andM.M. Jovanovic, "Reviewand stability analysis of PLL-based interleaving control of DCM/CCM boundary boost PFC converters," IEEE Trans. Power Electron., vol. 24, no. 8, pp. 1992-1999, Aug. 2009.
17. L. Huber, B.T. Irving, andM.M. Jovanovic, "Closed-loop control methods for interleaved DCM/CCM boundary boost PFC converters," in Proc. IEEE Appl. Power Electron. Conf. Exp., 2009, pp. 991-997.
18. C. Adragna, L. Huber, B. T. Irving, and M. M. Jovanovic, "Analysis and performance evaluation of interleaved DCM/CCM boundary boost PFC converters around zero-crossing of line voltage," in Proc. IEEE Appl. Power Electron. Conf. Expo., 2009, pp. 1151-1157.
19. T. Ishii and Y. Mizutani, "Power factor correction using interleaving technique for critical mode switching converters," in Proc. IEEE Power Electron. Spec. Conf., 1998, pp. 905-910.
20. M. S. Elmore, "Input current ripple cancellation in synchronized, parallel connected critically continuous boost converters," in Proc. IEEE Appl. Power Electron. Conf. Expo., 1996, pp. 152-158.
21. Y. Haoyi, Y. Zhihui, D. Jingya, Y. Chao, X. Xiaoni, and Y. Jianping, "Common mode noise modeling and analysis of dual boost PFC circuit," in Proc. IEEE Telecommun. Energy Conf., 2004, pp. 575-582.
22. M. Shoyama, T. Tsumura, and T. Ninomiya, "Mechanism of commonmode noise reduction in balanced boost switching converter," in Proc. IEEE Power Electron. Spec. Conf., 2004, pp. 1115-1120.
23. K. Pengju,W. Shuo, and F.C. Lee, "Commonmode EMI noise suppression for bridgeless PFC converters," IEEE Trans. Power Electron., vol. 23, no. 1, pp. 291-297, Jan. 2008.
24. J. W. Kim, S. M. Choi, and K. T. Kim, "Variable on-time control of the critical conduction mode boost power factor correction converter to improve zero-crossing distortion," in Proc. IEEE Power Electron. Drives Syst., 2005, pp. 1542-1546.