Wall slip phenomenon assessment of yield stress pseudoplastic fluids in Couette geometry

Applied Rheology

Volumn 20, Issue 5, 2010, Pages 1-11

  Kelessidis, V C ^a   Hatzistamou, V ^a   Maglione, R ^b  

^a TECHNICAL UNIVERSITY OF CRETE   (Greece)

^b Cascina Europa ^*  (Italy)

Author keywords

Bentonite; Carbopol; Herschel Bulkley; Rheology; Rheometry; Wall slip

Indexed keywords

EID: 77957656707     PISSN: 14306395     EISSN: None     Source Type: Journal    
DOI: 10.3933/ApplRheol-20-52656     Document Type: Article

References (48)

1. Yoshimura A, Prud'homme RK:Wall slip corrections for Couette and parallel disk viscometers, J. Rheol. 32 (1988) 53-67.
2. Kalyon DM: Apparent slip and viscoplasticity of concentrated suspensions, J. Rheol. 49 (2005) 621-640.
3. Barnes HA, Nguyen QD: Rotating vane rheometry-a review, J. Non-Newtonian Fluid Mech. 98 (2001) 1-14.
4. Kelessidis VC, Maglione R: Yield stress of water-bentonite dispersions, Colloids and Surfaces A 318 (2008) 217-226
5. Bingham EC: Fluidity and plasticity, McGraw-Hill, New York (1922)
6. Mooney M: Explicit formulas for slip and fluidity, J. Rheol. 2 (1931) 210-222.
7. Reiner M: Slippage in a non-Newtonian liquid. J. Rheology 2 (1931) 337-350.
8. Karnis A, Mason SG: Particle motions in sheared suspensions: XXIII. Wall migration of fluid drops, J Colloid and Interface Science 24 (1967) 164-169.
9. Vinogradov GV, Froishteter GB, Trilisky KK, Smorodinsky EL: The flow of plastic disperse systems in the presence of the wall effect, Rheol. Acta 14 (1975) 765-775.
10. Leighton D, Acrivos A:The shear-induced migration of particles in concentrated suspensions, J. Fluid Mech. 181 (1987) 415-439.
11. Mannheimer RJ: Laminar and turbulent flow of cement slurries in large diameter pipe: A comparison with laboratory viscometers, J. Rheol. 35 (1991) 113-133.
12. Aral BK, Kalyon DM: Effects of temperature and surface roughness on time-dependent development of wall slip in steady torsional flow of concentrated suspensions, J. Rheol. 38 (1994) 957-972.
13. Barnes HA: A review of the slip (wall depletion) of polymer solutions, emulsions and particle suspensions in viscometers: Its cause, character, and cure, J. Non-Newtonian Fluid Mech. 56 (1995) 221-251.
14. Walls HJ, Caines SB, Sanchez AM, Khanb SA: Yield stress and wall slip phenomena in colloidal silica gels, J. Rheol. 47 (2003) 847-868
15. Chryss AG., Bhattacharya SN., Pullum L: Rheology of shear thickening suspensions and the effects of wall slip in torsional flow, Rheol. Acta 45 (2005) 124-131
16. De Kee D, Kim YD, Nguyen QD: Measuring rheological properties using a slotted plate device, Korea-Australia Rheol. J. 19 (2007) 75-80.
17. Sofou S, Muliawan E, Hatzikiriakos S, Mitsoulis E: Rheological characterization and constitutive modeling of bread dough, Rheol. Acta 47 (2008) 369-381.
18. Zahirovic S, Lubansky AS, Yeow YL, Boger DV: Obtaining the steady shear rheological properties and apparent wall slip velocity data of a water-in-oil emulsion from gap-dependent parallel plate viscometry data, Rheol. Acta 48 (2009) 221-229.
19. Kiljanski T: A method for correction of the wall-slip effect in a Couette rheometer, Rheol. Acta 28 (1989) 61-64.
20. Magnin A, Piau JM: Cone and plate rheometry of yield stress fluids. Study of an aqueous gel. J. Non-Newtonian Fluid Mech. 36 (1990) 85-108.
21. Buscall R, Ian McGowan J, Morton-Jones AJ:The rheology of concentrated dispersions of weakly attracting colloidal particles with and without wall slip, J. Rheol. 37 (1993) 621-641.
22. Mallik S, Ekere NN, Durairaj R, Marks AE: An investigation into the rheological properties of different lead-free solder pastes for surface mount applications, Soldering & Surface Mount Technology, 20 (2008) 3-10
23. Tsenoglou C: Viscoplasticity of agglomerated suspensions, Rheol. Acta 28 (1989) 311-314.
24. Tabuteau H, Coussot P, de Bruyn JR: Drag force on a sphere in steady motion through a yield-stress fluid, J. Rheol. 51 (2007) 125-137.
25. Saak AW, Jennings HM, Shah SP: The influence of wall slip on yield stress and viscoelastic measurements of cement paste, Cement Concrete Res. 31 (2001) 205-212.
26. Roberts GP, Barnes HA, Carew P: Modeling the flow behavior of very shear thinning liquids, Chem. Eng. Sci. 56 (2001) 5617-5623.
27. Plucinski J, Gupta RK, Chakrabarti S:Wall slip of mayonnaises in viscometers, Rheol. Acta 37 (1998) 256-269.
28. Jana SC, Kapoor B, Acrivos A: Apparent wall slip velocity coefficients in concentrated suspensions of noncolloidal particles, J. Rheol. 39 (1995) 1123-1132.
29. Kelessidis VC: Investigations on the thixotropy of bentonite suspensions, Energy Sources Part A 30 (2008) 1729-1746
30. Bonn D, Denn MM: Yield stress fluids slowly yield to analysis, Science 324 (2009) 1401-1402
31. Kelessidis VC, Tsamantaki C, Dalamarinis P: Effect of pH and electrolyte on the rheology of aqueous Wyoming bentonitedispersions, Appl. Clay Sci. 38 (2007) 86-96.
32. Grikshtas R, Rao MA: Determination of slip velocities in a concentric cylinder viscometer with Mooney and Kiljanski methods, J. Texture Stud. 24 (1993) 173-184.
33. Speers RA, Tung MA, Williamson DT: Rheological determination of peptizing agents in bentonite clays, Rheol. Acta 27 (1988) 561-564.
34. Kok MV: Characterization and Development of Drilling Fluid Type for an Oil Field, Energy Sources Part A 32 (2010) 395 -399
35. BenAzouz K, Dupuis D, Bekkour K: Rheological characterizations of dispersions of clay particles, Appl. Rheol. 20 (2010) 13041.
36. Autio K, Houska M: Measurement of flow curves for model liquids and real food systems with two commercial viscometers, J. Food Eng. 13 (1991) 57-66.
37. Kelessidis VC, Hatzistamou V: Preparation methodology and rheological properties of yield pseudoplastic transparent fluids, J. Dispersion Sci. Technol. (2010) accepted.
38. American Petroleum Institute Specifications 13A: Specification for drilling fluid materials, SPE (2006).
39. Joye, D.D: Shear rate and viscosity corrections for a Casson fluid in cylindrical (Couette) geometries, J. Colloid Interface Sci. 267 (2003) 204-210.
40. Hanks RW: Couette viscometry of Casson fluids, J. Rheol. 27 (1983) 1-6.
41. Kelessidis VC, Maglione R: Modeling rheological behavior of bentonite suspensions as Casson and Robertson-Stiff fluids using Newtonian and true shear rates in Couette viscometry, Powder Technol. 168 (2006) 137-147.
42. Kelessidis VC, Maglione R: Shear rate corrections for Herschel-Bulkley fluids in Couette geometry, Appl. Rheol. 18 (2008) 34482.
43. Kelessidis VC, Maglione R, Tsamantaki C, Aspirtakis Y: Optimal determination of rheological parameters for Herschel-Bulkley drilling fluids and impact on pressure drop, velocity profiles and penetration rates during drilling, J. Petroleum Sci. Eng. 53 (2006) 203-224.
44. Morrison SR, Harper JC: Wall Effect In Couette Flow Of Non-Newtonian Suspensions, Ind. Eng. Chem. Fund. 4 (1965) 176-181.
45. Tsamantaki C, Kelessidis VC, Dalamarinis P, Mpandelis GE: Static and dynamic yield stress of water-bentonite suspensions, Paper presented at the 2nd International Conference on: "Advances in Mineral Resources Management and Geotechnics", Hania, Greece (2006) 247-254
46. Haimoni A, Hannant DJ:Development in the shear vane test to measure the gel strength of oil well cement slurries, Adv. Chem. Res. 1 (1988) 221-229.
47. Banfill PFG, Kitching DR: Use of a controlled stress rheometer to study the yield stress of oilwell cement slurries, in Banfill PFG (Ed.), Rheology of Fresh Cement and Concrete, E & FN Spon, London (1991) 125-136.
48. Ulherr PHT, Guo J, Fang TN, Tiu C: Static measurements of yield stress using a cylindrical penetrometer, Korea-Austral. Rheol. J. 14 (2002) 17-23.