Experimental study of thermal effectiveness in pneumatic conveying heat exchanger

Applied Thermal Engineering

Volumn 28, Issue 14-15, 2008, Pages 1932-1941

  Rajan, K S ^a   Srivastava, S N ^a   Pitchumani, B ^b   Dhasandhan, K ^a  

^a SASTRA UNIVERSITY   (India)

^b INDIAN INSTITUTE OF TECHNOLOGY DELHI   (India)

Author keywords

Correlation; Pneumatic conveying heat exchanger; Thermal effectiveness

Indexed keywords

CHEMICAL MODIFICATION; CONVEYING; FLUID MECHANICS; GALVANIZING; GASES; GYPSUM; HEAT EXCHANGERS; IRON; PNEUMATIC CONVEYORS; PNEUMATIC EQUIPMENT; PNEUMATICS; SOLIDS; TWO PHASE FLOW;

AIR VELOCITIES; DIMENSIONLESS CORRELATION; ELSEVIER (CO); EXPERIMENTAL DATA; EXPERIMENTAL STUDIES; FEED RATES; GALVANIZED IRON; GAS MEDIUM; GAS-SOLID; HOT AIR; INNER DIAMETER (ID); PNEUMATIC CONVEYING; SOLID MEDIUM; SOLID PHASES; TEST RIGS; VERTICAL PNEUMATIC CONVEYING;

AIR;

EID: 46749093852     PISSN: 13594311     EISSN: None     Source Type: Journal    
DOI: 10.1016/j.applthermaleng.2007.12.004     Document Type: Article

References (20)

1. P. Jain, P. Raghuraman, B. Pitchumani, Gas-Solid Heat Transfer during Pneumatic Conveying Between Cyclone Heat Exchangers, Fluid Particle Interactions V, New York, 1999.
2. Baeyens J., Van Gauwbergen D., and Vinckier I. Pneumatic drying: the use of large-scale experimental data in a design procedure. Powder Technology 83 (1995) 139-148
3. Radford R.D. A model of particulate drying in pneumatic conveying systems. Powder Technology 93 (1997) 109-126
4. Namkung W., and Cho M. Pneumatic drying of iron ore particles in a vertical tube. Drying Technology 22 (2004) 877-891
5. Bandrowski J., and Kaczmarzyk G. Gas-to-particle heat transfer in vertical pneumatic conveying of granular materials. Chemical Engineering Science 33 (1978) 1303-1310
6. Blasco R., and Alvarez P.I. Flash drying of fish meals with superheated steam: isothermal process. Drying Technology 17 4-5 (1999) 775-790
7. Fyhr C., and Rasmuson A. Steam drying of wood chips in pneumatic conveying dryers. Drying Technology 15 6-8 (1997) 1775-1785
8. Kaensup W., Kulwong S., and Wongwises S. Comparison of drying kinetics of paddy using a pneumatic conveying dryer with and without a cyclone. Drying Technology 24 8 (2006) 1039-1045
9. Kaensup W., Kulwong S., and Wongwises S. A small-scale pneumatic conveying dryer of rough rice. Drying Technology 24 8 (2006) 105-113
10. Narimatsu C.P., Ferreira M.C., and Freire J.T. Drying of coarse particles in a vertical pneumatic conveyor. Drying Technology 25 2 (2007) 291-302
11. Matsumoto S., and Pei D.C.T. A mathematical analysis of pneumatic drying of grains - I. Constant drying rate. International Journal of Heat and Mass Transfer 27 6 (1984) 843-849
12. Levy A., Mason D.J., Levi H.D., and Borde I. Drying of wet particles in a steady-state one-dimensional flow. Powder Technology 95 (1998) 15-23
13. Levy A., and Borde I. Steady state one dimensional flow model for pneumatic drying. Chemical Engineering Processes 38 (1999) 121-130
14. Pelegrina A.H., and Crapiste G.H. Modelling the pneumatic drying of food particles. Journal of Food Engineering 48 (2001) 301-310
15. Skuratovsky I., Levy A., and Borde I. Two-dimensional numerical simulations of the pneumatic drying in vertical pipes. Chemical Engineering and Processing 44 (2005) 187-192
16. Skuratovsky I., Levy A., and Borde I. Two-fluid, two-dimensional model for pneumatic drying. Drying Technology 1 (2003) 1645-1668
17. Kudra T., Mujumdar A.S., and Raghavan G.S.V. Gas-to-particle heat transfer in two-dimensional spouted beds. International Communications in Heat and Mass Transfer 16 (1989) 731-741
18. Freitas L.A.P., and Freire. Gas-to-particle heat transfer in the draft tube of a spouted bed. Drying Technology 19 6 (2001) 1065-1082
19. Rajan K.S., Pitchumani B., Srivastava S.N., and Mohanty B. Two-dimensional simulation of gas-solid heat transfer during pneumatic conveying. International Journal of Heat and Mass Transfer 50 5-6 (2007) 967-976
20. A. Jain, Studies on Gas-Solid Heat Transfer in Cyclone, Ph.D. Thesis, Indian Institute of Technology Roorkee, 2003.