Influence of wall slip on the hydrodynamic behavior of a two-dimensional slider bearing

Acta Mechanica Sinica/Lixue Xuebao

Volumn 23, Issue 6, 2007, Pages 655-661

  Ma, G J ^a   Wu, C W ^a   Zhou, P ^a  

^a DALIAN UNIVERSITY OF TECHNOLOGY   (China)

Author keywords

Multi linearity method; Quadratic programming; Slider bearing; Wall slip

Indexed keywords

NONLINEAR CONTROL SYSTEMS; NUMERICAL ANALYSIS; SHEAR STRESS; WALL FLOW;

HYDRODYNAMIC LOAD; NONLINEAR SLIP CONTROL EQUATION; SLIP GAP FLOW; WALL SLIP;

FLUID DYNAMICS;

EID: 36448980285     PISSN: 05677718     EISSN: None     Source Type: Journal    
DOI: 10.1007/s10409-007-0099-9     Document Type: Article

References (24)

1. Craig V.S.J. and Neto C. (2001). Williams D.R.M.: shear-dependent boundary slip in an aqueous Newtonian liquid. Phys. Rev. Lett. 87(5): 054504
2. Zhu Y. and Granick S. (2001). Rate-dependent slip of Newtonian liquid at smooth surfaces. Phys. Rev. Lett. 87(9): 096105
3. Zhu Y. and Granick S. (2002). Limits of the Hydrodynamic no-slip boundary condition. Phys. Rev. Lett. 88(10): 106102
4. Hervet H. and Léger L. (2003). Flow with slip at the wall: from simple to complex fluids. C. R. Physique 4(2): 241-249
5. Thompson P.A. and Troian S.M. (1997). A general boundary condition for liquid flow at solid surfaces. Nature 389: 360-362
6. Priezjev N.V. and Troian S.M. (2004). Molecular origin and dynamic behavior of slip in sheared polymer films. Phys. Rev. Lett. 92(1): 018302
7. Nagayama G. and Cheng P. (2004). Effects of interface wettability on microscale flow by molecular dynamic simulation. Int. J. Heat Mass Transf. 47: 501-513
8. Neto C., Evans D.R. and Craig V.S.J. (2005). Boundary slip in Newtonian liquids: a review of experimental studies. Rep. Prog. Phys. 68: 2859-2897
9. Navier C.L.M.H. (1823). Mémoire sur les lois du mouvement des fluides. Mém l'Acad R. Sci. l'Inst France 6: 389-440
10. Smith F.W. (1959). Lubricant behavior in concentrated contact systems-the castor oil-stell system. Wear 2: 250-263
11. Bair S. and Winer W.O. (1979). Shear strength measurements of lubricants at high pressure. ASME J. Lubr. Tech. 101: 251-256
12. Wu C.W. and Ma G.J. (2005). On the boundary slip of fluid flow. Sci. China Ser. G 48(2): 178-187
13. Spikes H.A. and Granick S. (2003). Equation for slip of simple liquids at smooth solid surfaces. Langmuir 19: 5065-5071
14. Salant R.F. and Fortier A.E. (2004). Numerical analysis of a slider bearing with a heterogeneous slip/no-slip surface. Tribol. Trans. 47: 328-334
15. Maxwell J.C. (1879). On stresses in rarefied gases arising from inequalities of temperature. Philos. Trans. R. Soc. 170: 231-256
16. Peng Y.Q., Lu X.C. and Luo J.B. (2004). Nanoscale effect on ultrathin gas film lubrication in hard disk drive. ASME J. Tribol. 126: 347-352
17. Wu C.W. and Sun H.X. (2006). Quadratic programming algorithm for wall slip and free boundary pressure condition. Int. J. Numer. Methods Fluids 50: 131-145
18. Spikes H.A. (2003). The half-wetted bearing. Part 1: extended Reynolds equation. Proc. Inst. Mech. Eng. Part J J. Eng. Tribol. 217: 1-14
19. Jacobson B.O. and Hamrock B.J. (1984). Non-Newtonian fluid model incorporated into elastohydrodynamic lubrication of rectangular contacts. ASME J. Tribol. 106: 275-282
20. Stahl J. and Jacobson B.O. (2003). A lubricant model considering wall-slip in EHL line contacts. ASME J. Tribol. 125: 523-532
21. Wilson W.R.D. and Huang X.B. (1989). Viscoplastic behavior of a silicone oil in a metalforming inlet zone. ASME J. Tribol. 111: 585-590
22. Östensen J.O., Wikström V. and Höglund E. (1993). Interaction effects between temperature, pressure and type of base oil on lubricant shear strength coefficient. Tribologia Finnish J. Tribol. 11(4): 123-132
23. Wikström V. and Höglund E. (1994). Investigation of parameter affecting the limiting shear stress-pressure coefficient: a new model incorporating temperature. ASME J. Tribol. 116: 612-620
24. Zhang H.W. and Zhang X.W. (2002). A combined parametric quadratic programming and precise integration method based dynamic analysis of elastic-plastic hardening/softening problems. Acta Mech. Sin. 18(6): 638-648