Measurement of residual stresses in injection molded polymeric part by applying layer-removal and incremental hole-drilling methods

Fibers and Polymers

Volumn 8, Issue 4, 2007, Pages 443-446

  Kim, Chae Hwan ^a   Kim, Sungho ^a   Oh, Hwajin ^a   Youn, Jae Ryoun ^a  

^a Seoul National University   (South Korea)

Author keywords

Incremental hole drilling method; Injection molding; Layer removal method; Polymeric materials; Residual stress

Indexed keywords

EID: 35348815532     PISSN: 12299197     EISSN: None     Source Type: Journal    
DOI: 10.1007/BF02875836     Document Type: Article

References (19)

1. G. Pötsch and W. Michaeli, "Injection Molding: An Introduction", Hanser Publishers, New York, 1995.
2. P. Postawa and D. Kwiatkowski, J. Achiev. Mater. & Manufact. Eng., 18, 171 (2006).
3. S. Alexandrov, W. Lee, and K. Chung, Fibers and Polymers, 5, 209 (2004).
4. R. G. Treuting and W. T. Read, J. Appl. Phys., 22, 130 (1951).
5. W. F. Zoetelief, L. F. A. Douven, and A. J. Ingen Housz, Polym. Eng. Sci., 36, 1886 (1996).
6. K. M. B. Jansen, J. J. W Orij, C. Z. Meijer, and D. J. Van Dijkathar, Polym. Eng. Sci., 39, 2030 (1999).
7. A. Turnbull, A. S. Maxwell, and S. Pillai, J. Mater. Sci., 34, 451 (1999).
8. E. Bendek, I. Lira, M. Francois, and C. Vial, Int. J. Mech. Sci., 48, 1429 (2006).
9. S. K. Kim, S. W. Lee, and J. R. Youn, Korea-Aust. Rheol. J., 14, 107 (2002).
10. J. Mathar, Trans. ASME, Iron & Steel, 56, 249 (1934).
11. ASTM, "Annual Book of ASTM E837-01", 2001.
12. Measurement Group, "Measurement of Residual Stresses by the Hole-Drilling Strain Gage Method", Tech Note TN-503-5, pp.1-20, Raleigh, NC, 1993.
13. G. S. Schajer, J. Eng. Mater.-T ASME, 103, 157 (1981).
14. M. T. Flaman and B. H. Manning, Exp. Mech., 25, 205 (1985).
15. G. S. Schajer, J. Eng Mater.-T. ASME, 110, 338 (1988).
16. T. H. Wang and W. B. Young, Eur. Polym. J, 41, 2511 (2005).
17. K. K. Kabanemi, H. Vaillancourt, H. Wang, and G. Salloum, Polym. Eng. Sci., 38, 21 (1998).
18. A. S. Maxwell and A. Turnbull, Polym. Test., 22, 231 (2003).
19. O. Sicot, X. L. Gong, A. Cherouat, and J. Lu, J. Compos. Mater., 37, 831 (2003).