Indentation-induced deformation behavior in martensitic steel observed through in-situ nanoindentation in a transmission electron microscopy

Materials Science Forum

Volumn 503-504, Issue , 2006, Pages 239-244

  Ohmura, T ^a   Minor, A ^b   Tsuzaki, K ^a   Morris Jr , J W ^c  

^a NATIONAL INSTITUTE FOR MATERIALS SCIENCE   (Japan)

^b LAWRENCE BERKELEY NATIONAL LABORATORY   (United States)

^c Lawrence Berkeley National Laboratory   (United States)

Author keywords

Dislocation; Fe C martensite; Grain boundary; In situ nanoindentation; Transmission electron microscopy

Indexed keywords

DEFORMATION; DISLOCATIONS (CRYSTALS); GRAIN BOUNDARIES; NANOINDENTATION; STRESS ANALYSIS; TRANSMISSION ELECTRON MICROSCOPY;

CRITICAL STRESS; IN-SITU NANOINDENTATION; LOW-ANGLE LATH BOUNDARY; MARTENSITIC STEEL;

MARTENSITE;

EID: 35248862010     PISSN: 02555476     EISSN: 16629752     Source Type: Book Series    
DOI: 10.4028/0-87849-985-7.239     Document Type: Conference Paper

References (24)

1. E.O. Hall: The deformation and ageing of mild steel. Proc. R. Soc.B64, 747 (1951).
2. NJ. Petch: The cleavage strength of polycrystals. J. Iron Steel Inst. 174, 25 (1953).
3. J.C.M. Li: Petch relation and grain boundary sources. Trans. AIME 227, 239 (1963).
4. M.F. Ashby: The deformation of plastically non-homogeneous materials. Phil. Mag.21, 399 (1970).
5. J.W. Morris, Jr.: in Proc. Int. Symposium on Ultrafine Grained Steels, edited by S. Takaki and T. Maki (Iron and Steel Inst., Tokyo, Japan, 2001), p.34.
6. J.J. Hauser, and B. Chalmers: The plastic deformation of bicrystals of f.c.c. metals. Acta Matell.9, 802 (1961).
7. W.E. Carrington, and D. McLean: Slip nuclei in silicon-iron. Acta Matell.13, 493 (1965).
8. Z. Shen, R.H. Wagoner, and W.A.T. Clark: Dislocation pile-up and grain boundary interactions in 304 stainless steel. Acta Metall.36, 3231 (1988).
9. K.J. Kurzydlowski, R.A. Varin and W. Zielinski: In situ investigation of the early stages of plastic deformation in an austenitic stainless steel. Acta Metall 32, 71 (1984).
10. T.C. Lee, I.M. Robertson, and H.K. Birnbaum: An insitu transmission electron-microscope deformation study of the slip transfer mechanisms in metals. Met. Trans. 21A, 2437 (1990).
11. T. Maki, K. Tsuzaki, and I. Tamura: The morphology of microstructure composed of lath martensites in steels. Trans. ISIJ, 20 207 (1980)
12. H.J. Kim, Y.H. Kim, and J.W. Morris, Jr.: Thermal mechanisms of grain and packet refinement in a lath martensitic steel. ISIJ Int., 38, 1277 (1998).
13. T. Ohmura, K. Tsuzaki, and S. Matsuoka: Nanohardness measurement of high-purity Fe-C martensite. Scripta Mater. 45, 889 (2001).
14. T. Ohmura, K. Tsuzaki, and S. Matsuoka: Evaluation of the matrix strength of Fe-0.4 wt% C tempered martensite using nanoindentation techniques. Phil. Mag. A 82, 1903 (2002).
15. T. Ohmura, T. Hara, and K. Tsuzaki: Relationship between nanohardness and microstructures in high-purity Fe-C as-quenched and quench-tempered martensite. J. Mater. Res. 18, 1465 (2003).
16. T. Ohmura, T. Hara, and K. Tsuzaki: Evaluation of temper softening behavior of Fe-C binary martensitic steels by nanoindentaiton. Scripta Mater. 49, 1157 (2003).
17. J.W. Morris, Jr., C.S. Lee, and Z. Guo: The nature and consequences of coherent transformations in steel, ISIJ Int., 43, 410 (2003).
18. Z. Guo, and J.W. Morris, Jr.: The effective grain size of martensitic steel, (submitted).
19. A.M. Minor, E.A. Stach, and J.W. Morris, Jr.: Quantitative in situ nanoindentation in an electron microscope. Appl. Phys. Lett., 79, 1625 (2001).
20. E.A. Stach, T. Freeman, A.M. Minor, D.K. Owen, J. Cumings, M.A. Wall, T. Chraska, R. Hull, J.W. Morris, Jr., A. Zettl, and U. Dahmen: Development of a nanoindenter for in situ transmission electron microscopy. Microscopy and Microanalysis, 7, 507 (2001).
21. A.R. Marder and G. Krauss: The morphology of martensite in iron-carbon alloys. Transactions of the ASM, 60, 651 (1967).
22. J.M. Marder and A.R. Marder: The morphology of iron-nickel massive martensite. Transactions of the ASM, 62, 1 (1969).
23. S. Morito, H. Tanaka, R. Konishi, T. Furuhara and T. Maki: The morphology and crystallography of lath martensite in Fe-C alloys. Acta Mater., 51, 1789 (2003).
24. Z. Guo: PhD Thesis, Dept. Materials Science, Univ. of California, Berkeley (2001).