Analysis of residual stresses in micro powder injection moulded micro bending specimens made of zirconia

Materials Science Forum

Volumn 490-491, Issue , 2005, Pages 503-508

  Kasanicka B ^a   Wroblewski, Th ^b   Schulze, V ^a   Lohe, D ^a  

^a UNIVERSITY OF KARLSRUHE   (Germany)

^b DESY   (Germany)

Author keywords

Characteristic bending strength; MAXIM; Micro bending specimens; Micro injection moulding; Microstructure; Residual stresses; Surface topography

Indexed keywords

CERAMIC MATERIALS; MICROSTRUCTURE; SCANNING ELECTRON MICROSCOPY; SINTERING; SURFACE TOPOGRAPHY; TOPOGRAPHY; X RAYS; ZIRCONIA;

CERAMIC MICROCOMPONENTS; MICRO POWDER INJECTION; MICRO POWDER INJECTION MOULDING; MOULDED MICRO BENDING; X-RAY IMAGING;

RESIDUAL STRESSES;

EID: 35148828098     PISSN: 02555476     EISSN: 16629752     Source Type: Book Series    
DOI: 10.4028/0-87849-969-5.503     Document Type: Conference Paper

References (7)

1. www.sfb499.de
2. L. Merz, S. Rath, V. Piotter, R. Ruprecht, J. Ritzhaupt-Kleissl, J. Haußelt: Feedstock Development for Micro Powder Injection Moulding; Microsystem Technologies 8 (2002); p. 129-132.
3. T. Wroblewski, O. Clauß, H.-A. Crostack, A. Ertel, F. Fandrich, Ch. Genzel, K. Hradil, W. Ternes, E. Woldt: A new diffractometer for materials science and imaging at HASYLAB beamline G3, Nuclear Instruments&Methods in Physics Research A 428 (1999), p. 570-582.
4. th European Conference on Residual Stresses-ECRS 6, Coimbra Portugal, Materials Science Forum Vols. 404-407 (2002), p: 121-126.
5. M. Auhorn, T. Beck, V. Schulze, D. Lohe: Quasi-static and cyclic testing of specimens with high aspect ratios produced by micro-casting and micro-powder-injection-moulding, Microsystem Technologies, Vol. 8, 2/3, Berlin (2002), p. 109-112.
6. 2 micro specimens, Z. Metallkunde (2004), in review.
7. M. Auhorn, T. Beck, V. Schulze, D. Lohe: Determination of mechanical properties of slip cast, micro powder injection moulded and microcast high aspect ratio microspecimens, Microsystem Technologies (2004), in review.